结果表明，流变应力随着温度的升高而降低，随应变率的升高而增大。
It was pointed out that the flow stress decreases with the increase of deforming temperature, while increased with the increasing of strain rate.
成形载荷随着温度的升高而降低，且呈现出周期性锯齿状载荷-行程曲线。
As the temperature rises, forming load decreases, and the curves of load-stroke shows serrated periodicity rule.
研究结果表明，GAP的色散分量随着温度的升高而降低，总表面能表现出与色散分量相一致的规律。
The results show that the dispersive component of the surface free energy of GAP decreases with increasing temperature and the total surface free energy takes on the consistent character.
通过理论计算推导出材料表面发射率随温度的变化趋势，结果表明，材料表面的发射率是随着温度的升高而降低。
Theoretical calculations of the emissivity of material surface were shown that the emissivity of material surface decreases with the temperature increases.
结论：山楂有机酸的含量随着温度升高而降低。
Conclusion: Organic acids in hawthorn reduce as the temperature rises.
流变应力随着变形速率的增加而增加，随着变形温度的升高而降低。
The flow stress decreases with the increase of deforming temperature and increases with the increase of strain rate.
混凝土的水蒸发速率、收缩变形、开裂面积都随着环境温度和风速的增加而增大，随着相对湿度的升高而降低；
The rate of water evaporation, shrinkage strain and the area of cracks increase with increasing exposure temperature and wind velocity, and with decreasing relative humidity.
峰值流变应力随着变形温度的升高而下降，且下降速率随着温度升高而降低；
The maximum flow stress decreased with the increase of the temperature, furthermore, the reduction speed decreased with the increase of the temperature.
峰值流变应力随着变形温度的升高而下降，且下降速率随着温度升高而降低；
The maximum flow stress decreased with the increase of the temperature, furthermore, the reduction speed decreased with the increase of the temperature.
应用推荐