提出了一种新的任意阶运算跨导放大器——电容(OTA - C)多功能滤波器的设计方法。
This paper presents a new general design method for arbitrary order operational transconductance amplifiers and capacitors (OTA-C) multifunction filters.
对于任意阶电平数的逆变器而言，这种算法能够方便地判断出参考空间矢量所落入的扇区，非常容易地进行矢量的合成运算。
For the inverters of the levels of any order, this algorithm can easily judge which vector the reference space vector falls in, and conduct the composition operations of the vectors.
提出了一种新的FIR滤波器快速算法，显著降低了实时信号处理中的长阶数FIR滤波器的运算量。
A novel fast algorithm for FIR filter is presented, the large computational volume of FIR filter with many taps is lowered down.
由二阶谐波平衡法得到的非线性代数方程组很容易用符号运算软件求出。
The nonlinear algebraic equations for the second order approximate solution were solved by using symbolic computation software.
这一方法比电力系统中现用的QR分解法优越，其运算量与矩阵运算阶次均大大低于QR分解法。
The computational complexity and dimension of matrices in computation are much lower than QR Decomposition Method, which is used now in power systems for the determination of dynamic stability.
一次二阶矩法是目前求解结构可靠性分析的主要计算方法之一，该方法要求功能函数对随机变量的偏导运算。
Reliability analysis using First Order Second Moment (FOSM) is important for structural probability design, in which process demands the derivative operation.
该算法避免了离线计算所采用的特征值分解等复杂运算，并且只利用信号的二阶统计量信息，计算工作量低。
The algorithm avoids the singular decomposition that commonly used in off-line calculation, and only the second order statistics of the signals is used, so the algorithm has low computing cost.
预处理滤波器改善了输入与参考之间的相干性，而降低自适应滤波器的阶数则降低了算法运算量。
The pre-treated filter improves the coherence between the input and the desired response, and the decrease in order reduces operations of the algorithm.
应用三阶差商公式预估新的搜索中心，使运算速度得以进一步提高。
The predicting of the new searching center by the application of a 3-order difference formula speeds up the calculation further.
每找出一个错误位置，对伴随式进行一次迭代运算并使伴随矩阵降一阶。
After every error location has been found out, we calculate the syndrome values by an iteration method and reduce the orders of syndrome matrix by one.
运用一阶单时间常数低通函数模拟运算放大器的开环增益，对RC桥式振荡电路进行线性分析，得出最大振荡频率为运算放大器增益带宽积的16.67%。
The maximum frequency of RC-bridge oscillator is 16.67% of gain bandwidth product of amplifier analyzed based on a first-order single time constant lowpass function model.
本文提出了以运算放大器为基础的一种新型电流模式MOSFET-C全集成精确连续时间平衡结构六阶低通滤波器电路。
This paper presents a new fully integrated MOSFET-C current mode sixth-order low-pass filter with precise continuous time balanced structure.
该算法以相邻像素的二阶差分为基础，自动选择与目标像素点相对应的源像素组进行插值运算。
According to the second-order difference of the consecutive pixels, the source pixel group is automatically selected to compute the corresponding target pixel gray value.
该方法采用微分电路和三采样值运算法，以电流的二阶导数深度抑制非周期分量并提高对采样值的甄别。
The approach utilizes 2-level derivation of secondary current and a 3-sample fitting calculation for decaying DC component depress as well as the sample data identifying.
在保证子波精度的前提下尽可能地降低模型阶数，提高运算效率，最终实现高效率高精度的子波模型定阶。
In the premise of ensuring the accuracy of seismic wavelet, reduced the model order as much as possible so as to obtain high-efficiency and high-precision seismic wavelet model order determination.
该方法一方面利用三阶累积量提高了抗噪性能，同时又使用非零奇异值矢量减少了存储量与运算量。
The third-order cumulant is used to improve the robustness to noise, and the singular value vector is used to reduce the memory and complicatedness. The…
该方法一方面利用三阶累积量提高了抗噪性能，同时又使用非零奇异值矢量减少了存储量与运算量。
The third-order cumulant is used to improve the robustness to noise, and the singular value vector is used to reduce the memory and complicatedness. The simulated experimental …
该方法一方面利用三阶累积量提高了抗噪性能，同时又使用非零奇异值矢量减少了存储量与运算量。
The third-order cumulant is used to improve the robustness to noise, and the singular value vector is used to reduce the memory and complicatedness. The simulated experimental …
应用推荐