其波形有方波、正弦波、三角波和锯齿波等。
The waveform square wave, sine wave, triangle wave and the sawtooth wave, etc.
方波；正弦波；锯齿波；斜波；3状态数据。
基于单片机的锯齿波发生程序，在数字示波器显示完美。
Sawtooth wave based on the occurrence of SCM procedures, in perfect digital oscilloscope display.
通过提取叠加在主波上的锯齿波波形，测试出其谐振频率；
The resonance frequency can be obtained by analyzing the tooth-waveform overlapped on the main response waveform.
铌酸锂相位调制器是锯齿波调制闭环光纤陀螺的关键器件。
Ti: LiNbO_3 Serrodyne Phase Modulator is the key device in closed-loop fiber-optic gyros.
对VCO内核而言，制作一个锯齿波最简单的方法就是“汇合”控制电压。
The simplest way for a VCO core to make a sawtooth wave is to "integrate" the control voltage.
铌酸锂相位调制器是实现锯齿波调制闭环光纤陀螺的关键器件。
Ti: LiNbO3 phase modulator is the key device in closed-loop sawtooth modulation fiber-optic gyroscope.
双频率锯齿波组合调制技术可应用于谐振式光纤陀螺数字处理系统。
The two-frequency serrodyne modulation technique can be used in the digital R-FOG system.
程序稍作修改还能生成并输出任意波形，如三角波、方波、锯齿波等。
If the programs are slightly changed, any waveform can be generated and output, such as triangle wave, square wave and zigzag wave, etc.
SCR触发器常以锯齿波为主，其线性度较好，但结构复杂，成本较高。
SCR contactor usually used zigzag wave, which linearity is better, but structure is complex and cost is expensive.
锯齿波的名字来源于示波器上其波形的形状，它看上去就像是手锯的齿一样。
The name stems from the waveform's appearance on a scope; it looks like the teeth of a hand saw.
锯齿波跳汰选矿，除了很微细的物料外，几乎可以处理各种粒度的矿物原料。
Sawtooth wave jig dressing, except for very subtle material outside, almost can handle various size of mineral materials.
锯齿波跳汰选矿，除了很微细的物料外，几乎可以处理各种粒度的矿物原料。
Oredressing by Sawtooth Wave Jig is capable of handling almost full sizes of mineral materials other than very fine material.
波整形电路从核心电路的锯齿波得到其他想要的波形——方波，脉冲波，三角波。
Wave shaping circuits derive the other desired waveforms — square, pulse, triangle, etc. — from the sawtooth output by the core circuit.
该试验台可为减振器试验提供简谐波、方波、锯齿波、随机路面谱等多种激振波形。
This test bench can provide a variety waveforms including: sine, square, saw-tooth, random road surface.
本论文首先分析了外差式连续波多普勒引信及锯齿波调频测距引信的原理和系统组成。
This paper discusses the principle and form of Heterodyne-CW Doppler fuze and Toothed-FM fuze firstly.
在相同电压及频率下，方波信号激励下的输出灵敏度最大，其次为正弦波，锯齿波最小。
With the same voltage and frequency, bar signal has the highest sensitivity and next the sine, the least sawtooth.
锯齿波从某一始点到某一终点沿着一条直线上升(或者下降)，在终点的时候它马上跃迁回其起始值。
A sawtooth wave rises (or falls) in a straight line from a starting point to an ending point, at which time it instantaneously jumps back to the starting value.
在实验结果中，还观察到简单波逐渐饱和的情况以及叠加于锯齿波上的大量高频调制部分。
In experimental results, one observes clearly the gradual saturation of simple waves and high frequency modulations on the sawtooth waveform.
主要内容是基于线性直方图法测量模—数转换器性能的片上模拟锯齿波发生器的实现方法。
This paper is mainly about an analog saw-tooth signal generator used for linear histogram test of ADCs.
主要设计思想是使用单片机控制DDS和D/A芯片，得到系统所需的正弦和锯齿波信号。
The main idea of design is using MCU to control DDS and D/A chips, so we can get sine wave and saw tooth signals.
与通常采用的公式相比，这里导出的公式中出现一项修正因子，它可以用锯齿波的观点来解释。
In the formulas deduced here there appears a revision factor as compared with the conventional formula, which can be explained with a point of view of zigzag waves.
该系统以可控硅三相桥式全控整流电路构成系统的主电路，采用同步信号为锯齿波的触发电路。
The thyristor triphase-bridge full controllable rectification circuit is taken as main circuit of the system and the trigger circuit with saw-tooth synchronism signal is adopted.
因而产生输出锯齿波，具有一个端点由固定电压源确定，和另一个端点根据定时和开关电容的电容比。
An output sawtooth thereby is produced having one endpoint determined by a fixed voltage source and the other endpoint in accord with the capacitance ratio of the timing and switched capacitors.
对于H68黄铜，随着晶粒尺寸的增大，出现锯齿屈服的临界应变量增大，锯齿波的最大应力振幅减小。
With the increase of the grain size of H68 brass, the critical plastic strain for the onset of serrations increases while the maximum stress amplitude of serrations decreases.
同时变频变幅的TFFP锯齿波扫描信号可以灵活地改变系统的扫描范围，进一步提高了系统的解调速度。
While the alterable frequency and scope sawtooth sweep signal for TFFP can neatly change the scanning range of the system, which is more improved the demodulation speed.
通过试验，得到了基本符合冲击试验规范的后峰锯齿波冲击脉冲波形，为实现任意冲击波形提供了理论依据。
After testing, the final peak saw-tooth shock pulse is basically suitable for shock testing rules. It provides the theoretical basis to realize shock pulse.
介绍了基于双频率锯齿波组合调制的谐振式光纤陀螺(R - FOG)的检测原理，分析了数字系统信号相关检测的理论。
The detection theory of resonator fiber optic gyro (R-FOG) based on the serrodyne modulation with two frequencies was introduced, and the correlative detection theory in digital system was analyzed.
本文针对实际中遇到的具体问题，介绍了一种频率幅度均可调节的数字式锯齿波发生器，给出了实现这种发生器的方法和具体电路。
A digital saw-toothed Wave generator adjustable frequency and amplitude is introduced in the paper, and gives the realizing method as well as actual circuit.
本文针对实际中遇到的具体问题，介绍了一种频率幅度均可调节的数字式锯齿波发生器，给出了实现这种发生器的方法和具体电路。
A digital saw-toothed Wave generator adjustable frequency and amplitude is introduced in the paper, and gives the realizing method as well as actual circuit.
应用推荐