详细介绍了真空浸渍树脂法制备金相样品的制备过程。
The metallography samples fabricated by the vacuum impregnation of resin are introduced.
文章介绍了钕铁硼铸块或速凝薄带的金相样品的制备方法。
A brief introduction to the preparation of metallographic specimen of NdFeB ingot or strip casting are given in this article.
热固性树脂中经常采用的原料是电木粉，镶嵌的过程需要使用到金相样品镶嵌机。
The important raw materials usually used in such thermosetting resin are bakelite, and metallographic specimen inlaying machine will be used in the same process.
介绍了一种金属粉末样品的金相制样方法。
In this article a method of sample preparation of metal powder is introduced.
本文运用金相组织分析的手段，对具有可比性的反弯试验的三种热处理制度下的样品进行分析，展示了金相组织与反弯性能之间的联系。
The article analyses the samples under the three heat treatment systems of inflection test with comparability, and illustrates the relation between metallographic structure and inflection performance.
对回收的样品进行了断口分析和金相分析，从宏微观角度分析了无钴合金在不同应变率下的断裂机制。
By the fracture analysis and metallographic analysis, we obtained the spall fracture mechanism at different strain rate.
观察到了不同氢含量的样品中氢化物的金相形态及其分布特征；
Microstructure and distribution of hydride on different hydrogen contents was observed.
剖焊样品的金相检验表明，成品的最小热影响区与母体金属完全相同。
Metallurgical tests of cross-sectional weld samples indicate a minimal heat-affected zone that is identical to the parent metal.
经过金相学处理后，样品被放在光学显微镜下，对其显微结构进行详细研究以分析实际制备后的涂层的质量和缺陷。
After metallographic preparation, microstructure of prepared coatings is analysed under an optical microscope to investigate the quality of fabricated coating.
并用金相、X -线衍射分析、电子探针、扫描电镜等方法对试验后样品的腐蚀表面进行了观察研究。
Surfaces of corroded specimens have been examined by means of metallography, X-ray diffraction analysis, EPMA, SEM, etc.
并用金相、X -线衍射分析、电子探针、扫描电镜等方法对试验后样品的腐蚀表面进行了观察研究。
Surfaces of corroded specimens have been examined by means of metallography, X-ray diffraction analysis, EPMA, SEM, etc.
应用推荐