正确使用量块，在测长仪上进行比对测量。
Operate length gauge, Use gauge block correct, operate comparing measurement.
研究了应用移相干涉术测量新的一等量块的方法。
The method of measuring new first grade gauge block by phase shift interferometry has been studied.
质量块的转动惯量对于剪切失效具有不可忽略的影响。
It is also shown that the influence of the rotary inertia of the mass block on the shear failure is not negligible.
分析了相对测量法量块测量过程中误差的来源和大小。
The paper gives an analysis on the source and size of measurement error of gauge block by relative measuring method.
提出了联合使用量块和一套导向镗孔装置的解决方案。
It is carried out by using some lumps and a set of especial guiding boring-hole device. This method is easy and convenient.
提出利用多点支撑法，减小量块长度变化量的测试方案。
An advance multi-point bracing means is proposed to minish length variation of gauge blocks.
测量直线度时，将工件竖放在放置于平板上的测量块上。
To measure the straightness, erect the workpiece on the measuring block placed on the surface plate.
该稳频激光系统已被用于国产的量块干涉仪和绝对重力仪中。
It has been applied to the homemade gauge block interferometers and absolute gravimeters.
本仪器是一般是用标准器（如量块）以比较法测量工件的尺寸。
The optimeter is widely used to precisely measure external size of workpiece by comparison with a gauge block or standard part.
本文证明了带硅质量块的铝纳米梁结构可以形成一种加速度计。
The nano-beams with silicon block can be seen as accelerometer is proved.
在划分资源储量块段时，根据《煤、泥炭地质勘查规范》“8。”
结果表明，车体结构上的质量块及其形心位置对基频的影响是非线性的。
The result shows that the influence of basic frequency affected by the mass block of vehicle body structure and its location of centroid is nonlinear.
采用高速大质量块撞击火炮身管是一种技术可行的火炮射击模拟试验方法。
Driving a huge mass with a high speed to impact the tube of gun weapon is a feasible technology used to simulate the firing process.
我通常使用镜头清洁布或者量块清洁布，尽管我倾向为每个提高一份清洁布。
I generally use a lens cleaning cloth or one of the cloths supplied for cleaning Gauge block sets, although I tend to keep the cloths bespoke for each use.
通过对量块表面的测量，验证了使用非接触方法测量金属强反射表面的可行性。
Through measuring surfaces of gauge blocks, this system is viable to measure high-reflective metallic surface.
但现在由于我在永久进行增量块级备份，就能开始极其频繁地对数据拍取快照。
But now because I'm doing incremental block level forever, I can start taking snapshots of my data much more frequently.
在人体系统变质量力学模型研究基础上，开展了人体系统变质量块体动力学研究。
On the basis of study on varing-mass mechanical model of human body system, the varing-mass block-body dynamics of human body system are developed to study.
分析表明：单位质量灵敏度和质量块的形状关系甚小，而和共振频率的关系较大。
The analysis indicates that the sensitivity on a unit mass is nearly independent of the shape of the mass block, whereas it is more dependent on the resonance frequency of that block.
测试中采用不同的质量块，会影响鸡蛋的固有频率，但刚度值基本不会发生变化。
Along with the increase of egg's weight, the natural frequency will increase. The weight will affect the frequency of eggs, but the stiffness will not change.
量块组尺寸计算公式不含三角函数，计算简便、结果精确，特别适合车间现场使用。
As no trigonometric function in the formula results in easy and accurate calculation result, it is especially suitable for workshop applications.
在用绝对光波干涉法测量量块长度时，必须解决光在量块表面反射时的位相跃变问题。
With using absolute optical interferometer for measuring length of block gauge, it is necessary to solve the problem of phase jump for reflecting of light on its surface.
该装置以组合量块为标准，采用可换向的单测头和成本较低的电感测微仪进行定位测量。
The new measurement system of thermal deformation adopts combined gauges as standard length, single switchable measuring head and inductance micrometers to carry on relative measurement.
结果表明，采用尺寸优化和拓扑优化的方法进行优化设计可提高质量块安装点的动刚度。
The size optimization and topology optimization were introduced to improve the dynamic stiffness of the mounting points.
介绍了量块新标准与旧标准的差异和新标准变化的原因、目的及其对量块加工带来的影响。
This paper introduces the difference between the new standard of gauge blocks and the old one, the cause and aim of changes and the influence on the manufacture are also described.
最后对设计的弹簧质量块系统分别进行了模态分析和谐波响应分析，分析结果和理论一致。
At last, the designed spring mass system were carried out modal analysis and harmonic analysis, and the analysis results consistent with the theory.
研究了差动式电感传感器的输出特性，在此基础上提出了采用标准组合量块的传感器标定方法。
The output characteristic of differential inductance sensor is analyzed, and the calibration of sensor using standard combinatorial gauge is put forward.
研究了差动式电感传感器的输出特性，在此基础上提出了采用标准组合量块的传感器标定方法。
The output characteristic of differential inductance sensor is analyzed, and the calibration of sensor using standard combinatorial gauge is put forward.
应用推荐