给出了由望远镜转动中心与圆顶球心不重合引起的偏差的计算公式，并对其进行了分析。
In this paper we also provide a formula for computing the offset caused by non-coincidence between the telescope slewing center and the dome spherical center, and make further analysis on the offset.
在获得齿轮内啮合传动的齿侧间隙计算公式以后，结合齿对刚度的计算公式，推导出齿轮内啮合传动的加载重合度及载荷修正系数。
After getting the formula about the normal backlash and the stiffness of the tooth pairs of the gear, the contact ratio and the load correction factor could be obtained.
提出了一种新的重合度系数公式。
同时提出了实际双齿啮合(或承载)的必要和充分条件，以及实际重合度的计算公式。
The essential and sufficient conditions for actual double pair tooth mesh, as well as the formula of actual contact ratio, are also proposed.
同时提出了实际双齿啮合(或承载)的必要和充分条件，以及实际重合度的计算公式。
The essential and sufficient conditions for actual double pair tooth mesh, as well as the formula of actual contact ratio, are also propose...
同时提出了实际双齿啮合(或承载)的必要和充分条件，以及实际重合度的计算公式。
The essential and sufficient conditions for actual double pair tooth mesh, as well as the formula of actual contact ratio, are also propose...
应用推荐