本技术的核心问题就是采用热管串联组件。
Its kernel is to adopt parallel connection module with heat pipes.
采用热管作为集热器的水源热泵式太阳能供暖系统。
The heat pipe is used as the collector for solar energy heating system with water source heat pump.
如果采用热管换热技术，对余热进行回收，可达到节能的目的。
If adopted, heat pipes can recover lost heat so as to save energy.
分析结果表明：采用热管技术对解决冻土路基问题是一种很好的方案。
The result of analysis indicates that it is a superior solution for solving the problem of the sinking frozen earth railway roadbed by applying the heat pipe technology.
基于热管的工作原理，提出了采用热管呼吸阀解决呼吸阀的冻结问题。
On the basis of the heat pipe's working principle, a design which applies heat pipe is introduced to prevent freezing problem.
本实用新型的优点是采用热管散热器散热，散热效果好、体积小、安装方便。
Because of adopting the heat pipe radiator to radiate heat, the utility model has the advantages of good heat radiation effect, small size and convenient installation.
在整改过程中采用热管式空气预热器进行可靠性分析，表明热管式空气预热器具有优越性。
Analysis of the heat tubular air preheater's reliability indicates that the heat tubular air preheater has the superiority.
采用优质硫磺作原料，在省煤器低温段采用热管元件等可有效地解决硫磺制酸露点腐蚀问题。
Dew point corrosion can be effectively avoided by using qualified sulphur as raw material and installing heat pipe element in the low temperature section of economizer.
在设计热管式余热锅炉时，我们常常采用能量平衡的方法。
The energy equilibrium method is often used to design hot pipe surplus energy boiler.
对充气热管空气预热器的结构进行分析和应用介绍，采用平界面模型，确定充气热管冷却段的有效长度。
By using a flat interface model it is possible to determine the effective length of a gas-filled heat pipe cooling section.
其中热管吸液芯分别采用普通不锈钢丝和反向槽道毛细结构，分析其工作性能。
The performance of the wick is analyzed with two wicks which is normal wire-mesh screen and reversed groovy capillary structure.
这种加热炉的技术关键在于筒体按常压结构设计，采用了超导热管和波纹管强化传热材料，大幅度提高了热效率。
The heater body is designed with a atmospheric pressure structure, which adopts superheat pipes and corrugated pipes to improve greatly its heat efficiency.
用普通便携式X射线机，采用特殊的透照技术，对换热管与管板角焊缝进行射线检测。
Radiographic examination was performed with portable X-ray fault detector appling the special radiographic technique for fillet weld of heat exchange tube-tubeplate.
底座采用角铁架设焊接而成，在地板的下面设有地热管、通过隔热层将地热管密封。
A base is formed by erecting and welding Angle irons, and terrestrial heat tubes are arranged under floors and are sealed through heat insulating layers.
介绍了小口径换热管堵塞采用柔性钻头疏通的处理方法。
The author introduces a method of dredging stems in small_bore tubes by flexible aiguille.
采用含磷、锡、硅、锑和铝等元素的70黄铜制造散热管。
The pipes could be fabricated by the brass H70 containing P, Sn, Si, Sb and Al.
利用该模型，采用复合形优化法，用QBASIC语言编程，在安装热管的面积一定状况下对碳钢-水热管换热器的结构进行优化。
QBASIC was used to make procedure, structure of heat pipe was optimized with complex method on condition that the area of fixing heat pipe was invariable.
采用工业试验的方法对两台分别燃油及燃煤的电站锅炉的热管式空气预热器灰污系数的确定进行了分析和研究。
Determination of fouling factors of heat pipe air preheaters for two utility boilers burning oil and coal respectively are implemented through industrial experiments.
采用以上技术方案后，该热管即可以用来喝热的饮料了。
By adopting the above technical proposal, the suction pipe can be used for drinking hot beverage.
本文采用实验方法对一台新型热管散热器进行了变工况性能测试研究。
In this paper, the off-design performance of a new type of heat pipe radiator was studied based on experimental method.
俪福led室内照明产品采用最先进的数码控制、散热管理以及照明灯具设计，产品质量和性能均达到国际水平。
Trichromatic LED commercial lighting products using the most advanced digital controls, thermal management and lighting design, product quality and performance are up the international standards.
针对烟气脱硫系统加热器(ggh)型式问题，提出采用新型高效热管ggh，可以提高系统的经济性。
In view of the type question of heater for flue gas desulfurization system (GGH), the text indicates the use of new type highly-efficient heating tube may increase the economy of system.
采用热阻网络法，得出热管散热模组的数学模型。
Theoretical model of heat pipe thermal module was built using thermal resistance network method.
采用带浸没加热管的惰性粒子振动流化床对(石灰)膏状物料干燥进行了实验研究。
Drying lime paste materials in a vibrated fluidized bed with inert particles and immersed heating tubes were experimentally investigated.
文中分析了该新型热管接收器的特点，并分3段模拟计算了采用该接收器的抛物面槽式太阳能集热器的集热效率和接收器的散热损失。
The thermal analysis of the heat pipe receiver was presented in which the collector efficiency and thermal loss were calculated in 3 separate sections.
采用自行设计的套管式传热实验装置及流程，进行了内置液轮机换热管的换热性能实验研究。
The heat exchange performance of the miniature hydraulic turbine is investigated in the lab with self-designed experimental device and flow.
列管式换热器的换热管束与管板连接一般均采用焊接加胀接的密封固定工艺。
In general a sealing technology involving welding in combination with expand jointing is used for connecting a pipe column to a tube plate in a tubulature type heat ex- changer.
热水供热管网采用分阶段改变流量质调节可以减少循环水泵耗电量。
Changing the flow mass at different stages may decrease the power consumption of water pump in hot water heat supply network.
同时亦介绍采用分段设计方法控制热管管壁温度的必要性。
It also introduces the necessity of controlling wall temperature of heat pipe by means of stepwise design.
本文采用实验方法对一台新型热管散热器进行了变工况性能测试研究。
The off-design performance of a new type of heat pipe radiator was studied based on experimental method.
应用推荐