如果您回想一下，您以前应该尝试过更改使用虚拟以太网配置的适配器。
If you recall, you tried to change an adapter earlier that was configured with virtual Ethernet.
必须将每个VIO服务器上的第二个虚拟以太网适配器配置为非干线适配器。
The second virtual Ethernet adapter on each of the VIO Servers must be configured as a non-trunk adapter.
以太网适配器本身通过使用HMC创建和配置。
The Ethernet adapters themselves are created and configured using the HMC.
您了解了网络配置的一些最佳实践，更改了您的以太网设置来支持最大帧，并查看了接口硬件和驱动程序数据。
You learned some best practices for network configuration, changed your Ethernet Settings to support jumbo frame, and viewed interface hardware and driver data.
图4显示这个LPAR配置了虚拟以太网和虚拟scs i适配器。
Figure 4 shows that the LPAR is configured with virtual Ethernet and virtual SCSI adapters.
在HMC中配置VIO服务器的概要时，在每个服务器上创建两个虚拟以太网适配器。
When configuring the profiles of the VIO Servers on the HMC, create two virtual Ethernet adapters on each server.
然后将其用于配置逻辑分区、分区的启动和关闭功能、以太网和存储适配器的管理，以及一些基本的系统管理功能。
It is then used for configuring logical partitions, startup and shutdown functions for partitions, management of Ethernet and storage adapters, and basic system management functions.
按照与开箱即用配置相同的方式，执行netserver可伸缩性测试并收集数据，但是每个节点上只使用一个以太网适配器。
The netserver scalability tests were run and data were collected in the same way as in the out-of-the-box configuration except that only one Ethernet adapter per node was used.
按以下步骤在以太网适配器上配置IP地址。
To configure an IP address on the Ethernet adapters, do the following.
例如，当一个以太网适配器被动态添加到一个分区中时，以下代理就会被调用，从而对这个适配器和网络进行配置：pci_bus .agent、pci . agent和net . agent。
For example, when an Ethernet adapter is dynamically added to a partition, the following agents are invoked to configure the adapter and network: pci_bus.agent, pci.agent, and net.agent.
关于如何配置 10 千兆以太网的信息，参见附录A或参见 附录B了解有关部署InfiniBand网络的更多信息。
For information on how to configure the 10 gigabit Ethernet, refer to Appendix A, or refer to Appendix B to learn more about deploying an InfiniBand network.
邮件数据库分散在5个IBMFAStT 600阵列上，其配置也是RAID0。网络访问是通过一个1GB的以太网适配器进行的，它采用的是全双工模式。
The mail databases were spread across five IBM FAStT 600 arrays, also RAID 0. Network access was through a single 1 GB Ethernet adapter running in full duplex mode.
这种衍生的UTP电缆支持一种“自动配置协议”，允许两个以太网系统自行决定采用全双工抑或半双工操作。
The UTP Ethernet variants support an additional autoconfiguration protocol that allows two Ethernet systems to negotiate which speed to use, in full or half duplex mode.
在两个cec上，AIX客户机分区的虚拟以太网和虚拟scsi客户机适配器的槽编号(在分区配置文件中)必须匹配。
The slot Numbers of the virtual Ethernet and virtual SCSI client adapters for the AIX client partition (on the partition profile) must match on both CECs.
发布版本的网络驱动程序被使用，而且以太网Jumbo帧被配置好，以更好地支持这项散装流的情况。
Released versions of network drivers were used, and Ethernet jumbo frames were configured to better support this bulk streaming scenario.
VirtualI/O客户机（VIOC）bxaix85配置了一个具有适当VLANID 的虚拟以太网接口，从而通过VIOS 中的SEA与外界通信。
The Virtual I/O Client (VIOC), bxaix85, was configured with a virtual ethernet interface configured with the appropriate VLAN ID to communicate with the outside world using the SEA in the VIOS.
随着以太网协议统治地位的增强，在网络安装与配置方面也发生了一些变化。
With the enhancement of Ethernet protocol rule degree, some change has taken place at the aspects of network installment and configuration.
另外一种是配置该现场总线的硬件网关，让网关的以太网接入到该服务器中。
Another type is to configure the hardware gateway of this field bus, let Ethernet of the gateway access to this server.
本文详细讨论了CAN—以太网数据转换控制器及上位机配置软件的设计。
This paper discussed detailedly about the CAN Bus-Ethernet Controller of Data Exchange design and configure software design.
基于以太网的接口使得无线交换机公司能够保持它们的2G用户基础设施，而不必配置附加的第三方设备。
The Ethernet-based interface enables wireless switch companies to keep their 2G customer base without having to deploy additional third party equipment.
在办公室，移动宽带网络可以配置为自动故障转移和恢复以太网广域网端口，如果失去互联网连接连接思科WRP400。
At the office, the mobile broadband network can be configured on the Cisco WRP400 as an auto-failover and recovery connection if the Ethernet WAN port loses Internet connectivity.
在这种情况下，一个单一的思科1700系列模块化接入路由器配置了思科公司的ADSLWIC和思科4端口快速以太网交换机WIC可以部署以满足这些要求。
In this case, a single Cisco 1700 Series modular access router configured with a Cisco ADSL WIC and a Cisco 4-port Fast Ethernet Switch WIC can be deployed to meet these requirements.
他们使用以太网供电(PoE)标准IEEE 802.3af标准的使用和获取配置信息和操作，从一个平凡的FTP (TFTP)服务器软件的能力。
They use Power over Ethernet (PoE) using the standard IEEE 802.3af and obtain configuration information and operating software from a Trivial FTP (TFTP) server.
本文工作为EPA工业以太网的实时性改进研究提供了理论基础，为现场选用和配置EPA系统提供了依据和参考。
The work in this dissertation provides groundwork for the improvement of EPA real time performance and a useful guideline for choosing and configuring an EPA system in industrial field.
本文工作为EPA工业以太网的实时性改进研究提供了理论基础，为现场选用和配置EPA系统提供了依据和参考。
The work in this dissertation provides groundwork for the improvement of EPA real time performance and a useful guideline for choosing and configuring an EPA system in industrial field.
应用推荐