本文用最小二乘配点法分析弹性壳体弯曲问题。
This paper analyses elastic shell-bending problems by means of the least-square collocation method.
因此，直接配点法对于再入轨迹优化问题的求解是可行的。
Therefore, the direct collocation method is a viable approach to the reentry vehicle trajectory optimization problem.
因此，直接配点法对于再入轨迹优化问题的求解是可行的。
Therefore, the direct collocation method is a viable approach to lunar probe soft landing trajectory optimization problem.
本文运用配点法，对用有限元建立的动力方程求结构的瞬态响应。
This paper applies the collocation methods to the equations of a structural dynamic system farmulated by finite element to determine the structural transient response.
综合应用差分法和配点法，研究了混合边界矩形薄板的弯曲问题。
Using difference method and collocation point method, this paper studies the bending problem for rectangular thin plates with mixed boundary.
等额配点法和最小二乘积分法是两种最常用的虚边界元法构造思路。
The primal research work about virtual boundary element method is on the problems of single domain.
用逐次逼近法和最小二乘配点法求正交异性矩形薄板弯曲的几何非线性解。
Successive approximation and least square collocation are used to find the solution of geometrically nonlinear bending problem of orthotropic rectangular plates.
以幂函数为试函数，用配点法计算了夹层圆板和夹层扁球壳的非线性弯曲。
Taken power function as a trial function, nonlinear bending of circular sandwich plates and shallow spherical sandwich shells was discussed by means of point collocation.
本文介绍计算静电场的边界配点法和边界元法的基本原理，同时对电场的两个实例作了计算并加以比较。
The principles of point - matching and boundary element methods in calculating electric field are introduced in this paper. Two examples are presented. Some results and comparison are given.
其实，在最近发布的补丁前，配点方式都可行。但，事实是只有少数玩家尝试其他的配点法，特别是生存。
You can say that all the specs were viable before the recent patch, but the fact is that very few players were trying the others, especially Survival.
本文应用加权余量法中的子域法和配点法，求出了均匀圆板在径向和横向均布荷裁作用下的极限荷载的近似解。
An approximate solution on ultimate load of a circular plate under radial and lateral loads is derived from equations by subdomain Weighted Residual Method (WRM) and point by point WRM.
有两种常见的配准方法：基准点法和表面匹配法。
There are two common methods in the registration:fiducial points based matching and surface based matching.
有两种常见的配准方法：基准点法和表面匹配法。
There are two common methods in the registration:fiducial points based matching and surface based matching.
应用推荐