由此得出了水合速率方程。
该反应的速率方程和速率常数亦被确定。
对实验数据进行拟合，得到该反应速率方程。
According to the experimental data, the rate equation was deduced.
文章讨论了气固相催化反应的基本过程和速率方程。
The basic process of gas solid catalytic reaction and rate equation have been discussed in this article.
并求得初始传质速率方程，计算了表观传质反应热。
The transfer rate equation is experimentally obtained and the superficial transfer energy is calculated.
在日冕和非日冕两种模型下，分别求解了电离速率方程。
Using model of coronal and non-coronal radiation, ionization rate equation has been solved respectively.
通过求解速率方程，建立了环形掺铒光纤激光器的理论模型。
A theoretical model has been established based on the solution of the rate equations for the erbium-doped fiber ring laser (EDFL).
由溅射速率方程和反应粒子输运方程得出了靶面化合物的覆盖度。
The compound fraction of target surface was gotten from the rate equations of sputtering and the transport equations of reactive particles .
针对线性光放大器(loa)的结构特点，建立了基于速率方程的模型。
According to structural property of linear optical amplifier (LOA), a model was built using rate equations.
以四能级系统为理论模型对脉冲可调谐掺钛蓝宝石激光系统建立了速率方程。
The rate equation of tunable pulse ti: sapphire laser is given using the theoretical model of four-level system.
然后基于半导体的速率方程理论，建立了载流子浓度随时间变化的数学模型。
Secondly, mathematical model of time-resolved carrier density has been established on the base of semiconductor rate equation theory.
通过合理简化固体脉冲激光器的速率方程，得到了其输出能量的解析表达式。
The general expression of the output energy of a pulsed solid state laser is derived by properly simplifying the laser rate equations.
吸附动力学研究表明，噻吩在活性炭上的吸附速率可以用拟二级速率方程来描述。
Kinetics study indicated that the adsorption rate of thiophene on activated carbon can be described as a pseudo-second order rate equation.
将吸附速率方程、吸附等温方程与物料衡算相结合预测了其他条件下的穿透曲线。
The breakthrough curve inside the bed under another operation is predicted by the adsorption rate equation, the adsorption isotherm equation and the material balance equation.
模型中采用传质、传热速率方程表征实际塔板上的传递过程，避免了级效率的计算。
Mass and energy transfer rate equations are used in describing the transfer processes on real trays and thus the computations of stage efficiencies are entirely avoided.
同时根据非等温变体积条件下的动态法液-固相反应的特点，导出了反应速率方程。
According to the catalytic characteristic of dynamic method, the equation of reaction rate has be deduced under the non isothermal and volume varying conditions by kinetic calculation.
利用非线性薛定谔方程和速率方程，研究了啁啾脉冲在增益介质中多程放大的特性。
The multipass amplification characters of the chirped pulse in gain medium were studied with the Schrdinger equation and population equation.
同时根据非等温变体积条件下的动态法，液-固相反应的特点，导出了反应速率方程。
According to the catalytic characteristic of dynamic method, the equation of reaction rate has be deduced under the non-isothermal and volume-varying condition.
建立了只有发酵速率方程斜率和截距两个实验参数，方便、实用的酒精发酵速率方程。
The alcohol fermenting rate equation with only two experimental parameters including slope and intercept was set up, which was simple and practical.
通过所得动力学参数的精度比较，获得了最佳拟合的2-甲基呋喃HDO反应的速率方程。
By means of comparing the accuracy of the kinetic parameters, the best fit rate expression for HDO reaction of 2MF was obtained.
并建立了只有发酵速率方程斜率和截距两个实验参数，实用范围更广的酒精发酵速率方程。
The alcohol fermentation rate equation with parameters of slope and intercept, which is simple and practical, is established.
结合激光器的等效电路和速率方程分析，避免了单独测量寄生网络和估计有源区电路参数。
The advantage of this method lies in that there is no need to measure the parasitic network separately and estimate the circuit parameters of active region.
本文从四能级结构激光速率方程出发，对脉冲掺钛蓝宝石激光器的时间特性进行了理论研究。
The time characteristics of a pulsed ti: sapphire laser have been studied theoretically based on the rate equation of four-level system.
由包含弛豫作用的速率方程出发，建立了关于放大器能流密度空间分布最优问题的数学模型。
Based upon the laser rate equations including relaxation between energy levels, the optimum model of a multipass amplifier is constructed.
对声光调Q技术进行了分析，依据考虑Q调制之后的速率方程，研究了调Q激光器的优化问题。
Q-switching technique is studied based on the Q-switching rate equation. And the optimum problem of Q_Switched lasers is also studied.
基于速率方程建立了线性光放大器(loa)的数值模型，模拟了线性光放大器的增益钳制特性。
The numerical model of the linear optical amplifier (LOA) is built based on the rate equations. The gain clamping characteristics of LOA are simulated.
吸附动力学过程包括吸附快反应阶段和慢反应阶段，可用动力学一级方程和双常数速率方程描述；
The sorption kinetics included the initial fast phase and the final slow phase. The first-order kinetic reaction and double constant rate equation could describe the sorption kinetics well.
根据染料产生激光的能级系统，考虑了准连续泵浦的特点，导出了准连续泵浦染料激光速率方程。
According to characters of quasi-CW pumped dye laser, as well as energy system pertaining to dye lasers, we have derived the rate-equation of quasi-CW pumped dye laser.
并推导出上述四个过程的传质速率方程，以利于进一步了解EDI的性能，便于EDI的推广应用。
Equations of four processes were given and thus, we could understand further the performance of EDI, and make it used widely.
从速率方程出发，利用线性稳定性分析方法，分析了单片集成双稳半导体激光器输出光强的稳定性。
We have investigated the stability of the output laser intensity of an integrated bistable laser diode starting from the rate-equations and by means of a linear-stability analysis method.
应用推荐