通过变化模型参数,可模拟变形特性较为复杂的土体。
Through varying model parameters, more complicated deformation behaviors can be simulated by the modified model.
再利用此模型,通过变换组合梁的高度和各钢板的厚度等参数比较分析梁的承载能力,应力,挠度的变化等。
Again USES the model, through transformation composite beam highly and various steel plates parameter comparative analysis beam and support capacity, stress, deflection change and so on.
通过岩心驱替以及砂岩微观孔隙模型驱替实验,研究了高含盐油藏水驱储层参数变化机理和规律。
By performing core displacement and micro pore model displacement experiments, the mechanism and changing law of saliferous reservoir parameters were studied.
可变模糊集方法以可变模糊集理论为基础,通过模型参数的变化,提高评价结果的可靠性。
Variable fuzzy sets methods are based on variable fuzzy sets theory. Through variability of model parameters, the reliability of evaluation could be enhanced.
该模型通过设计信号幅度和相位参数的不同变化,可以实现压缩前后信号可控的解相关性。
By changing amplitude and phase of the simulated signal, controllable decorrelation between the pre-and post-compression signals can be practiced.
通过数学模型获得了富氧喷煤高炉参数的变化,计算结果表明,随着喷煤量的增加,置换比将会降低。
The change of blast furnace indices with the oxygen enrichment and PCI were obtained by a mathematical-simulation, which indicates that the replacement ratio will decrease with increasing of PCI rate.
通过对垃圾进行淋滤实验,分析了垃圾场中垃圾渗滤液污染物组分的变化特点,求得了数值模型所需的有关参数。
Through the leaching test, the variation characteristics of the landfill leachate were analyzed, and some model parameters were estimated.
通过试验,确定了模型中的相关参数,得到了湿陷速率随压力变化曲线。
The model parameters and the curves of the relation were obtained by experiment.
通过分析该模型中物与像的对应关系,得出了射影失真产生的根源是光学系统放大率的不恒定,并与相机的外参数:倾角及视场的大小有着非线性的变化关系。
The reason for Projective distortion that the amplification ratio is not constant but has nonlinear relation with pitch and tilt angles and field of view of cameras was found out.
本文还建立了此闭环控制系统的数学模型,通过数字仿真分析了其动态特性,探讨了控制器参数对转子运动的控制效果以及与电磁轴承动刚度之间的变化关系。
Also this closed loop controlled system is modelled and its dynamic behaviors are analyzed by digital simulation. The influence of controller parameters on motion of the rotor and th...
通过敏感性分析功能,可以研究模型变量之间相互作用的规律;通过想定研究方法,可以定量评价输入参数变化对流行的影响。
By sensitive analysis, we were able to study the interaction between model variables and by scenario method, we could evaluate impacts of value changes of input variables on epidemic quantitatively.
然后,通过对DTC系统进行数学分析和实验研究,归纳了DTC的特点,分析了磁链模型中参数变化的影响。
After analysis and experiments on DTC system, the disadvantages of DTC are summarized. Also sensitivities between parameters and control character are analyzed based on each type of flux model.
诊断过程通过动态模型的在线参数估计完成,在实现模型校正的同时可以预测流动过程的变化趋势并判断是否存在故障。
In this paper we propose a novel leakage fault detection and diagnosis method, using dynamic simulation to monitor the fluid flow process and identify leakages when large flow rate deviations occur.
仿真结果表明,通过对模型运行状态的有效控制,模型能够正确地反映出不同区域的消失或出现,模型参数变化光滑并符合机理分析。
Special attention is given to the study of modeling the possible operating status of refrigerant in the evaporator. The results show that the model is general and flexible.
仿真结果表明,通过对模型运行状态的有效控制,模型能够正确地反映出不同区域的消失或出现,模型参数变化光滑并符合机理分析。
Special attention is given to the study of modeling the possible operating status of refrigerant in the evaporator. The results show that the model is general and flexible.
应用推荐