电机转子不进行退火处理，并不会影响电机的性能。
If the motor rotor is not carried out annealing treatment, motor's performance couldn't be influenced.
之后，利用氨气等离子体促进化学气相沉积法对上述经电镀制程而形成的电镀金属层进行退火处理。
Finally, annealing process is carried out in the electroplated metal layer formed by the electroplating process through chemical vapor deposition method under promotion of ammonia plasma.
在氮气气氛下进行退火处理，X射线衍射（XRD）谱表明ZAO薄膜具有六角纤锌矿的晶体结构。
The X-ray diffraction(XRD) patterns show that ZAO thin films has a hexagonal wurtzite structure.
利用短时矩形脉冲电流对近零磁致伸缩系数钴基非晶态合金带进行退火处理，得到约114%的巨磁阻抗变化率。
The GMI ratio of about 114 % is obtained in near zero-magnetostrictive Co-based amorphous alloy ribbon annealed by short time rectangular pulse current.
通过对材料进行干燥和退火处理，科学家们移去了弱的结合水以使陶瓷纤维形成致密结构。
By drying and annealing the material, the scientists mainly remove weakly bound water to make the ceramic fibres form a denser structure.
另外，对碳化硅薄膜的退火处理大多是在真空、空气、氩气或氮气气氛下进行。
In addition, the annealing process of SiC films is mostly carried out in vacuum, argon gas or nitrogen gas ambience.
介绍了无涂层电工钢冲片迭片成型后的电机定子和转子在罩式炉内进行退火和发蓝处理一次完成的新工艺及装置。
A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hydrogen furnace was introduced.
样品采用电流退火进行焦耳热处理。
结果表明，退火态2224铝合金经e CAP挤压后，进行固溶和时效处理，明显提高了合金的力学性能，细化了合金的晶粒。
It is shown that the mechanical properties of annealed sample of 2224 aluminum alloy are improved by the combination of solid solution and aging treatment after ECAP, the size of grain is refined.
对三种不同热处理(正火、退火、球化)的低碳钢中微空洞的形成进行了一些观测。
Some observations of voids formation were carried out by using low carbon steel with three kinds of heat-treatment, namely, normalizing, annealing and spheroidizing.
介绍了无涂层电工钢冲片叠片成型后的电机定子和转子在罩式炉内进行退火和发蓝处理一次完成的新工艺及装置。
A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hytrogen furnace was introduced.
对铜材进行异步累积叠轧并退火处理，制备出了均匀稳定的超细晶铜材。
The uniform ultra-fine grained copper was prepared by asymmetrical accumulative rolling bonding(AARB)and anneal.
维修方法：更换表离合轮和小钢轮或者把磨损齿轮经过退火处理，修复磨损齿轮再把退火的齿轮进行淬火处理。
Maintenance methods: replace the rolex clutch wheel and small steel wheel or the wear gear after annealing treatment, repair the wear gear quenching of gears to the annealing treatment again.
维修方法：更换精准表离合轮和小钢轮或者把磨损齿轮经过退火处理，修复磨损齿轮再把退火的齿轮进行淬火处理。
Maintenance methods: replace the precision of the clutch wheel and the small steel wheel or wear the gear after annealing treatment, repair the wear gear and then annealing the gear quenching.
不锈钢生产退火酸洗过程会产生大量废混酸（HF/HNO3），通过酸净化系统对废酸进行处理。
The stainless steel annealing and pickling process can product large quantity of waste mixed acid(HF/HNO3) that must be treated through acid purification system.
简要叙述了堇青石基微晶玻璃的主要制备方法。并以熔融法为主，对本系统微晶玻璃的性能控制工艺，如组成设计、热处理、退火工艺等进行了综述。
The main several preparations of cordierite-based glass ceramics are reviewed. And the properties control methods, such as component design, the heat treatment and the annealing are presented.
对多孔硅进行真空退火处理和暴露大气快速退火处理，将有机染料香豆素102（C102）镶嵌其中，研究镶嵌复合膜发光特性的变化。
In this article, porous silicon was annealed diversely in vacuum and in atmosphere, then, C102 dyes were embedded into both PS samples.
应用有限元分析程序对300MW汽轮机转子直轴进行了应力计算，并对各影响因素进行了分析，结果表明退火处理过程中残余应力产生的塑性变形量不可忽略。
Finite element analysis program was used to calculate the stress of 300mw turbine rotor in straightening the axle, and the effect of each factor is analyzed combined with the trial result.
导致轧制时出现边裂，采用重新退火，进行退氮处理可解决这一问题。
This will bring out edge crack when strip steel rolling. This problem can be solved by annealing again.
对制备的薄膜进行了真空退火处理，并对退火前后的薄膜进行了拉曼结构分析。
The prepared films were treated by vacuum annealing, and the structure of films before and after annealing was studied by Raman Spectrum.
分别对不同生长速度的DKDP晶体进行了退火处理。
The influence of thermal annealing on DKDP crystals grown at different rates was studied.
根据本发明，提供在进行了应变消除退火等热处理的情况下也几乎不会引起强度降低且耐热性优良的铜合金及铜合金板的制法。
The invention provided one method to produce copper alloy with fine heat resisting and its slab and its intensity wasn't mostly decreased under the heat treatment, such as strain relief anneal.
在空气中对样品进行不同温度的退火处理。
The samples prepared were annealed in air atmosphere at different temperatures.
对铸态可锻铸铁的材质、孕育处理及石墨化退火工艺进行了研究。
Effect of inoculation treatment on the low temperature graphitization of malleable cast iron;
热处理1949年前，北京已采用电炉、盐溶炉、热电偶等手段进行零件退火、回火、淬火、正火、调质、渗碳等热处理。
Before 1949, Beijing has heat treatment furnace, salt dissolved by thermocouples means furnace, quenching and tempering, parts of annealing, normalizing, quenching and tempering, carburizing and etc.
此外，沉积后的薄膜无需进行后退火处理，所以它还具有成本低，制备简单等优点，适用于未来的生产。
In addition, the deposited film needs no annealing treatment, so that the present invention has also the advantages of low cost, simple preparation, etc and is suitable for future application.
此外，沉积后的薄膜无需进行后退火处理，所以它还具有成本低，制备简单等优点，适用于未来的生产。
In addition, the deposited film needs no annealing treatment, so that the present invention has also the advantages of low cost, simple preparation, etc and is suitable for future application.
应用推荐