最后，得到实验数据，并对其进行了分析比较。
At last, the simulation data is analyzed and compared with each other.
对随机信号和混沌信号的特性进行了分析比较。
The characteristics of stochastic and chaotic signals have been studied.
对影响图像质量的采集卡的几个参数进行了分析比较。
We also discuss and compare some parameters that affect the quality of the imaging card.
并通过实例将其突破时间与底水的突破时间进行了分析比较。
The time of the breakthrough of edge water and that of bottom water are analyzed and compared with.
最后，通过数值例子对协作和分散两种模式进行了分析比较。
At last, the new model is employed to analyze the results with numerical examples.
介绍了几种信息驱动路由的具体算法，并对其进行了分析比较。
This paper introduces some typical algorithms of information-directed routing, and compares the capability of these algorithms.
在此条件下对自然发酵和接种发酵的风味成分进行了分析比较。
Upon these conditions, the flavor components of natural fermentation and inoculating fermentation sauerkraut were analysed comparatively.
对软件计算结果进行了分析比较，以确保软件计算结果的正确性。
An analytical comparison of the software's calculation results is conducted to make sure its validation.
对LS、MMSE和LMMSE及其改进算法的性能进行了分析比较。
Analyze and compare the performance of LS, MMSE, LMMSE and their modified algorithm.
将流速和潮位的计算结果与实测资料进行了分析比较，二者吻合良好。
Comparing calculation result of velocity and tidal phase with the real data, they are merged well.
在可靠性、调光等方面，对该系统与常规电子镇流器系统进行了分析比较。
Some characteristics have been compared with the conventional electronic ballast in dimming capability and reliability.
对圆柱面——平面型平凹柱透镜和棱镜的扫描角放大特性进行了分析比较。
The planoconcave cylinder lens and prism properties of angular magnification in light scanning are analysed in the paper.
同时，对在稀释浓度和实际浓度条件下测定污泥指数的两种方法进行了分析比较。
Two methods determining the sludge volume index under diluting sludge concentration and practical sludge concentration are analysed and compared.
特别对多种前缀树型结构进行了分析比较，分析了各自的特点以及内存占用情况。
Especially, we analyzed many kinds of prefix-trees structures, has compared the characteristic and the usage of memory of each other.
对浮顶油罐上使用的机械密封的类型、结构进行了分析比较，并提出了选择建议。
The type and structure of mechanical seal for used in floating roof oil tank were analyzed and compared. The selection recommendation was proposed.
作者对所取得的成果进行了分析比较，并在此基础上推荐了氧化矿选别的合理流程。
The author made analysis and comparison between the obtained achievements and proposed a rational process flow for the beneficiation of oxidized ore.
总结了萃取法和连续电积法两种铜电解液净化脱砷新工艺的特点，并进行了分析比较。
This paper summarizes the process features of purification arsenic removal of copper electrolyte by solvent extraction or continuous electrowinning and makes analysis and comparison.
并在简单定时提取电路（STC）的具体情况下与其它推导方式的结论进行了分析比较。
Their specific results in the simple timing extraction circuit(STC) condition are compared with those from other deductive methods.
并在计算结果基础上，对两种方案结构进行了分析比较，指出了瓦楞结构的防热效果更佳。
Based on comparative analysis, it shows that the corrugated sheet structure has better thermal protection effect.
对施工中的不确定因素，诸如边跨合拢方案和不同桥墩悬浇进度不一致等进行了分析比较。
Uncertain factors in construction of continuous girder bridge such as side span joint scheme and different balanced cantilever construction speed are analyzed.
以澧水流域并联系统为例进行了优化调度计算，并以常规调度方案成果进行了分析比较论证。
The optimization operation is calculated taking Lishui river basin parallel connection system as the example compares it and the conventional operation scheme results.
本文对管道直饮水系统中用水标准、水处理工艺、供水管网、管材选用等问题进行了分析比较。
Analyses and compares water standard, water treatment process, water supply piping line, system, pipe materials and other problems in the piping drinking water system.
利用经济分析方法，结合实际供热工程，对区域供热热源方案的技术性、经济性进行了分析比较。
The technicality and economy of heat source scheme of district heat-supply are analyzed and compared with a practical heat-supply scheme by economical analysis methods.
文章介绍了回收铬鞣液中铬的几种方法，并对这几种方法的优缺点及其经济效益进行了分析比较。
This paper introduces some methods for recovering chromium from chrome tanning waste water, compares the merits and demerits of these methods, and analyses their economic benefit.
以上海地区的气候条件和能源价格为基础，对燃气机热泵供暖的能耗和运行费用进行了分析比较。
Based on the climate and energy costs in Shanghai, energy consumption and running costs of the gas engine heat pump was analyzed and compared with electric heat pump.
对目前出现的几种分户式热计量采暖技术方式进行了分析比较，并对其特点和使用条件进行了讨论。
This paper makes analysis on and comparison between current metering technologies of individual household heating system, and discusses on their characteristics and applications.
最后，就这两种计数器在电路结构和经济性能方面进行了分析比较，论证了二—N进制计数器的优点。
Finally an analytic comparison is made between those two kinds of counters in both their circuit structure and economic property, and hence the advantages of the binary-N carry counter are proved.
对直流TIG电弧阳极板表面电流密度的测量方法——分离极板法和探针（自制）法进行了分析比较。
The measuring methods of D C TIG welding arc anode sheet surface current density split sheet method and probe (made by ourselves) method were analysed and compared.
对煤层气的几种集输方式和增压方式进行了分析比较，总结了它们适用的气田条件，给出了工程实例。
Several gathering modes and boosting modes of coal-bed methane are analyzed and com- pared. Their applicable conditions are summarized, and an engineering case is given.
本文采用粗（米用）分析法对我国中小型合成氨厂的氨合成流程进行了分析比较，绘制了（米用）流图。
The paper aims at analysing several ammonia synthetic processes used in some middle and small-sized plants by the method of exergy analysis.
应用推荐