最终的进胶位置根据模流分析。
可满足各样式的进胶方式。
由于此处没有足够空间下热咀，所以需做一个柱子进胶。
This position need to make a pole for gating because there have no enough space for hot sprue.
然后模具再次闭合，顶针复位，进胶部分前行，料桶再次与相关部位相连以实现下一次新的注塑。
The mould then will be closed again, the ejectors will return, the unit will advance and the sprue tube will come again in contact with the tools to carry out a new injection.
在这段时间里，螺杆回复到原位，同时旋转以实现下一环节的动作，即将熔化的材料带入进胶管前端。
During this time, the screw moves back while turning to carry out a new proportioning by bringing material melted to the front of the sprue tube.
自进式钻头带动为其提供高压水动力的特制胶管向前连续钻井。
The self-feeding bit carries the special rubber tube that provides high-pressure hydrodynamics for the bit to drill continuously.
注墨口与进气孔采用不同出口，使用墨盒时请取出进气口胶塞或撕掉胶膜。
The refilling hole and the air hole are different. Take out the rubber plug or tear film when use cartridge.
广州市诚进汽配位于中国广州市，本公司是一家主要经营汽车底盘橡胶件机脚胶前机顶胶 防尘套 球头 拉杆橡胶件等产品的经销批发零售。
Cheng Jin Auto Parts is located in Guangzhou City, The company is mainly engaged in automobile chassis rubber ENGINE MTG, CV BOOT, ABS MTG, and retail distribution.
广州市诚进汽配位于中国广州市，本公司是一家主要经营汽车底盘橡胶件机脚胶前机顶胶 防尘套 球头 拉杆橡胶件等产品的经销批发零售。
Cheng Jin Auto Parts is located in Guangzhou City, The company is mainly engaged in automobile chassis rubber ENGINE MTG, CV BOOT, ABS MTG, and retail distribution.
应用推荐