本文介绍了抗高过载电路的封装技术与封装材料，对抗高过载电路的封装工艺作了详尽的探讨。
The paper introduces the packaging technology and materials for the anti-high load circuit. It explores the packaging craftsmanship in details.
在这种情况下，就需要附加的过载保护功能以避免损坏仪器的输入电路。
In these cases, additional overload protection is required to avoid damaging the input circuitry of the instrument.
检查电器箱接线及紧固情况，调整延时继电器及过载保护器，接通电路，试验电机转向，选择合适规格的保险丝。
Check the electrical box wiring and tighten the situation, adjust delay relays and overload protector, connect circuits, test motor steering, select the appropriate specifications of the fuse.
检查是否有损坏的电线，松动的插头或过载的电路等电气问题。
Check for electrical problems such as damaged cords, loose plugs or overloaded circuits.
如果我们要在过多方面做各种不同事情，我们的大脑就开始和其的本质一样：电路过载。
If we try to multi-task in too many directions, our brains begin to act exactly like what they are: overloaded electrical circuits.
图2 - 24示出静电计或皮安计的过载保护电路，其中包括一个电阻器和两个二极管(1n3595)。
Figure 2-24 shows a protection circuit for an electrometer ammeter or picoammeter, consisting of a resistor and two diodes (1n3595).
电路在任何情况下都不得过载。
电压调节器具有耦合在反馈网络和调节部分之间的过载保护电路。
The voltage regulator has an overload protection circuit coupled between a feedback network and a regulation section.
如果延迟超过预定的时间量，则过载保护电路关闭电压调节器。
If the delay exceeds a predetermined amount of time, the overload protection circuit shuts down the voltage regulator.
一种具有过载保护电路的电压调节器和用于防护输出电压大于预定的电平的方法。
A voltage regulator having an overload protection circuit and a method for protecting against an output voltage being less than a predetermined level.
本文阐述一种随机信号过载检测器的原理和电路结构，它兼有既能识别过载又能实现信号灵敏可靠检测的功能。
The paper describes the circuit principle and the construction of a overload detector which has functions of discriminating overload signal and detecting valid signal for a random acoustic pulse.
采用最严格的充电管理电路，具有过载，欠压，短路等多重保护，标准usb电源接口输出。
Adopt strict charge to manage the circuit, it can protect with overload, undervoltage, short circuit, etc. output for standard USB power supply interface.
该放大器单位有内置的过载保护电路，监测产出水平和保护司机。
The amplifier unit has built in overload protection circuitry to monitor output levels and protect the drivers.
也要谨防电路过载，因为水瓶座满月的关系，你有可能烧了保险丝或者更糟。
Also be sure the electrical circuits are not overloaded, as you could blow fuses or worse with a full moon in Aquarius.
煤电钻采用热继电器进行过载保护方式已逐渐被IC型过载保护电路取代。
IC type overload protection circuit has gradually replaced thermal relay overload protection mode.
文中结合遥控装定引信电路设计，给出了实现抗高过载、小体积、低成本和低功耗的具体方法和措施。
Combining the design of remote setting fuze, the dissertation presents the concrete means and measure to realize high over loading, small bulk, low cost and low consumption.
内置智能保护电路，能在过载的情况下保护12寸铝锥盘低音单元不受损害。
Smart protection circuitry is incorporated into the SI-12 to prevent damage to the 12-inch aluminum cone subwoofer if ever over-driven.
本系列配电箱可作为动力照明、电动机控制，对电路进行过载、漏电及短路保护之用。
This series of distribution box can be used as lighting power and electric motor controlling to avoid the overloading, electricity leaking, short-circuit of circuit system.
当电路出现故障使回路电流增大时，过载保护PT C热敏电阻的电阻值因自热温升而出现阻值阶跃，直至把电路切断。
When the circuit breaks down and the return circuit current increases, the resistance of restricting overloading protection PTC Thermistor goes up sharply for being warm, until the circuit is cut off.
对记录器抗高过载能力进行理论分析和试验证明，从电路和结构设计方面考虑提高抗高过载能力。
Theoretic analysis and experiment prove to the anti-high over-loaded capacity of recorder, the anti-high over-loaded capacity in circuit and structure design is improved.
下次电路再出现故障时，过载保护PT C热敏电阻又可以进入保护状态。
When the circuit breaks down next time, the PTC Thermistor can enter the state of protection again.
其内部部件备有与高频保护电路在一起的无源分频器，高频保护电路可防止高音驱动器过载损坏。
Its internal components available high-frequency and circuit protection with passive divider, high-frequency driver protection circuit to prevent high-overload damage.
在电路故障排除后，过载保护PT C热敏电阻冷却并恢复到低阻态，同时电路也进入正常工作状态。
After the clearing of the circuit trouble, the PTC Thermistor begins to cool and come back to the state of low resistance, and then the circuit enters normal working condition.
该线性电源采用了双重过载保护电路和抗干扰技术。保证了系统的良好运行。
The linear power supply adopts double means to defend over load and puts technology that can resist electrical interferences to use, and this ensures the system running well.
该线性电源采用了双重过载保护电路和抗干扰技术。保证了系统的良好运行。
The linear power supply adopts double means to defend over load and puts technology that can resist electrical interferences to use, and this ensures the system running well.
应用推荐