介绍了一种新型塑料外壳式断路器的过电流保护系统。
Introduction was made to a new kind of molded case circuit breaker over-current protection system.
介绍了一种新型塑壳断路器的过电流保护系统。
A new type of over current protection system of MCCB was Introduced.
电动机过载保护通常采用继电器，而配电线路过载保护多采用断路器的长延时过电流脱扣器来完成。
Protection against motor over - load usually adopt thermal relay, but protection against line over - load usually adopt long delay over- current release of circuit- breaker.
该附录经过3次修订，现刊出的为第三版中的附录，是最新标准。其内容着重带电子过电流保护断路器的附加试验要求。
The appendix published is the one to the 3rd edition, it is the newest standard with its contents stressed on the additional tests for circuit breakers with electronic over-current protection.
这些断路器应在每极上装有额定值从80%至160%可调的长延时过电流装置。
These circuit breakers should have the long time-delay over-current devices on each polar whose rated value can be adjusted from 80% to 160%.
KA5为跳闸报警继电器。当设备产生偏励磁、可控硅故障、过电流等故障时，KA5吸合，断路器分励线圈得电跳闸，切断主电源。
When there are bias excitation, controllable silicon failure, over current and other failures, KA5 gets absorbed and breaker loop trips by powered on so as for switching off main power supply.
同步关合是指断路器动、静触头在系统电压波形的指定相角处关合，以减小合闸操作的过电流和过电压的一种智能操作技术。
Synchronous closing is an intelligent control technique. It can make the moving and stationery contact-header of circuit breaker to close on the specified phase angle of the power system voltage wave.
同步关合是指断路器动、静触头在系统电压波形的指定相角处关合，以减小合闸操作的过电流和过电压的一种智能操作技术。
Synchronous closing is an intelligent control technique. It can make the moving and stationery contact-header of circuit breaker to close on the specified phase angle of the power system voltage wave.
应用推荐