过冷却的水滴比冰晶容易蒸发。
一旦经过冷却和测验，这些钢块就已经准备好用于太空事业和石油钻探这两个十分需要高强度钢材的领域。
Once cooled and tested, the blocks of steel are readyfor use in aerospace and oil-drilling, where high-strength steel is prized.
内部热交换产生的热量，通过冷却水系统在冷却塔中向空气中排放。
Internal heat exchanger, the heat generated by cooling water system in cooling tower in the air emissions.
能否在采用自然通风冷却塔的电厂将处理后的烟气通过冷却塔排放？
Whether in will use well ventilated the cooling tower power plant will process after the haze to discharge through the cooling tower?
上述两种装置都可以将干燥器中一定流量的压缩空气冷却至恒定的温度，避免过冷而导致过多的冷凝液体产生。
The above two kinds of devices can be in a dryer the flow of compressed air cooling to constant temperature and avoid a cold and led to excessive condensing liquid produce.
燃气轮机的性能与环境温度有关，其出力随燃气进气温度升高而降低的问题可通过冷却燃气进气来解决。
The performance of a gas turbine is related to environmental temperatures and its output decreases with the increase of gas inlet temperature, which can be solved by cooling the inlet gas.
通过在石头底部嵌入一个冷缺系统，使得空气中的湿气经过冷却后在石头表面上凝结成水珠。
A cooling system is inserted and the condensation of moisture is functioned from the atmosphere into surface water.
用磁秤模拟方法研究了冷却速度和过冷温度对镍铬钢排氢速度和排氢量的影响。
The effect of cooling rate and undercooling temperature on the rate and amount of dehydrogenation was studied by magnetic balance simulation method.
过冷器是高温超导电缆（HTS）低温冷却系统的关键设备之一。
The subcooler is a key device of cryogenic cooling system in High Temperature Superconducting (HTS) cables.
对落管中冷却速率和过冷度随液滴直径的变化规律进行了分析。
The transformation rule of diameter of droplets between cooling rate and undercooling can be analyzed in drop tube.
白葡萄佐餐酒允许发酵完全到干或者通过冷却中止发酵到预定的甜度水平。
White table wines are allowed to either ferment to dryness or their fermentation are stopped, by cooling, at a predetermined sweetness level.
液态空气：处于液体状的空气，呈蓝色，极度冰冷，通过冷却和压缩而成。
Air in its liquid state, intensely cold and bluish, obtained by cooling and compression.
为保证往复活塞式压缩机的运行可靠性和经济性，必须通过冷却系统对其进行良好的冷却。
Reciprocation compressor must be well cooled by cooling system in order to ensure its reliability and economy in the course of running.
对大多数模具，冷却是通过冷却液在冷却管网内的流动来实现的。
To most injection mold, the cooling is realized through the coolant flowing in pipe network.
冷却速率增加，UHMWPE需更高的过冷度才能结晶。
The highly undercooled was need for UHMWPE crystallization with the increasing of cooling rate.
利用差热分析法测定了试样在相同冷却速度下的过冷度。
The DTA method was employed to measure the undercooling of samples during solidification.
空冷器设计应注意其逆流段出口的过冷却符合HEI标准的要求；
Outlet subcooling degree of reverse flow section should be in conformity with the requirement of HEI Standard.
排出的含有二甲基甲酰胺溶剂的空气或惰性气体被连续送到回收系统，通过冷却或吸收的方式被回收。 收藏。
Exhaust air or inert gas containing the DMF is continuously sent to a recovery system where the solvent is recovered by condensation or absorption.
AZ 91d镁合金半固态液相的凝固方式与冷却速度所决定的过冷度有重要关西安理工大学硕士学位论文系。
The solidification modes of liquid phase of semi-solid AZ91D Mg alloy were in close relationship with the degree of supercooling determined by cooling rate.
过冷却点比冰点的变化幅度更大。
针对越冬期东西方蜜蜂的过冷却点进行了测试并对其与越冬性能的关系进行了分析。
The supercooling points of honeybees were tested, and the relationship between the supercooling point and the cold resistance was analyzed.
热的冷却气离开冷却区域后，经过冷却、压缩，再循环使用。
The hot cooling gases flow away the cooling region and then are cooled, compressed and recycled.
燃气轮机的性能与环境温度有关，其出力随燃气进气温度升高而降低的问题可通过冷却燃气进气来解决。
The performance of gas turbine has relation with the environmental temperature and its output is reduced with increase of gas inlet temperature, which can be solved by means of cooling the inlet gas.
通过冷却循环水系统的现场应用，达到了计量标准的要求，降低了计量误差，验证了该系统在原油计量中的作用。
It is proved that the field application of cooling water recirculation system can meet the measurement standards and reduce metering errors.
吉林陨石中的球粒分为正常快速冷却和过冷冷却球粒两种。
Chondrules in the Jilin meteorite may be divided into two groups: normal rapid cooling(granular and porphyritic) chondrules and supercooling(grating and excentro-radial)chondrules.
本文通过冷却强化、板形控制等机理研究，论述中厚板淬火控冷装备技术的进展。
Progression of the quenching and control-cooling equipment technology of plate is discussed in the paper through the mechanism study on enhancing cooling, plate shape controlling and etc.
通过以上的研究工作，本论文得到以下具有创新性的研究成果：在电沉积制备活性锌粉时，通过冷却电解液的更换可以有效缩短电沉积开始时槽压上升的时间。
By the above work, some technologic innovation results are attend as follows: in zinc electrochemical deposition, electrode voltage's upper time may be shorter by altering cold electrolyte.
电线(30)内产生的热在保护管道内传递到流通通过冷却管(20)的冷却水，并耗散到保护管道(11)的外部。
Heat generated in the wire (30) is transmitted in the protective pipe (11) to the cooling water flowing through the cooling pipe (20) and discharged in the outside of the protective pipe (11).
过冷奥氏体高速冷却，几乎全部形成脆硬的马氏体薄层，造成踏面剥离。
The supercooled austenite transforms into friable martensite layer during the following rapid cooling process, leading to cracking and spalling at wheel tread.
过冷奥氏体高速冷却，几乎全部形成脆硬的马氏体薄层，造成踏面剥离。
The supercooled austenite transforms into friable martensite layer during the following rapid cooling process, leading to cracking and spalling at wheel tread.
应用推荐