产品系列化，输出转矩与气动装置，各种阀门匹配；
Series of products, torque and pneumatic device, various valves;
齿轮材料为合金钢，硬齿面，输出转矩大，可靠耐用。
Alloy steel gear, hard tooth surface, large in output torque and durable in use.
运行实验结果表明，样机运转平稳，具有较大的输出转矩。
The experiment results show that the motor operates smoothly, and has a bigger output torque.
为了使电机工作稳定，电机的输出转矩不能超过最大堵转转矩。
The output torque of motor are not exceed maximum locked torque rotor.
如果在组配电动阀门时选用的电动装置输出转矩过大或不足都是不可取的。
If the group when equipped with optional electric valve electric actuator output torque is too large or less are desirable.
结果表明，设计的风扇离合器输出转矩能够满足发动机冷却风扇的驱动要求。
The results indicate that the output torque of MR fluid clutch can meet the requirements of engine cooling fan.
这一特殊结构使得正反转电机的驱动问题尤其是输出转矩平衡问题显得尤为突出。
Based on the single DC motor model, the mathematic model of dual-motors was established to analyze the problem of output torque balance of dual-motors.
本文利用磁粉制动器输出转矩与激磁电流成线性这一特性来实现对张力的恒值控制。
This thesis uses the linearity relation of output torque and excitation current to control the tension.
采用离散占空比控制技术的直接转矩控制能够在减小输出转矩脉动的同时保持算法简单的特性。
Applying discrete duty ratio control technology into direct torque control can reduce the ripple, and keep the feature of simplicity.
研制了一种基于四换能器协调驱动的球型超声电机，该电机具有结构简单、输出转矩大等优点。
A quadric transducer coordinately driving spherical USM was proposed and fabricated. This kind of USM has merits such as simple structure and high output torque.
通过与单定子永磁电机的对比，分析增加一个内定子对电机输出转矩及空间和材料利用率的影响。
By compared with single-stator permanent magnet motor, the influence of adding an inner stator on the output torque, space and material utilization ratio were analyzed.
针对目前国内车用驱动电机性能的现状，分析了电机输出转矩误差对车辆直线行驶稳定性的影响。
In view of the current technical status of automotive driving motor in China, the effect of motor output torque error on straight line driving stability is discussed in detail in the article.
因为一般情况，电动装置生产厂在产品出厂时均需进行输出转矩值的测试与调整，是相对比较准确的。
BecauseCheck Valves the general situation, the electric equipment manufacturing plant in the products the factory torque values required for testing and adjustment is relatively accurate.
结合绕组电流进行转矩估算，经过转矩误差pid反馈控制，实现电机输出转矩对转矩给定指令的跟踪。
Utilizing flux linkage and phase current, the output torque is calculated, and PID control is used to decrease torque error.
通过合理设计电机的结构参数和电磁参数，可有效提高电机输出转矩，降低转动惯量，提高电机响应特性。
By optimization design on the configuration and electromagnetism parameters, the output torque can be effectively enhanced with lower moment of inertia and faster response characteristics.
采用该方法能够使电机在整个弱磁阶段输出转矩保持最大，并确保非理想磁场定向条件下的转矩和升速性能。
The proposed algorithm guarantees producing the maximum torque over the entire field weakening region and ensures the torque and speed-rising capability under imperfect field orientation c.
双凸极电机的凸极结构及其供电电源的开关形式 ，导致了在输出转矩中存在稳态转矩脉动和换向转矩脉动。
The torque-ripples of the double-salient motor are inevitable for its double salient structure and switch power source.
并针对低速大转矩永磁同步电动机的特点采用基于ANSYS软件的分析方法，计算了不同转子位置时电机的输出转矩。
According to the feature of low-speed and high-torque permanent magnetic synchronous machine, the output torques are also calculated in different positions based on the ANSYS software.
同时，通过对这种电机的样机进行实验检测，输出转矩较同型号超声波电机增加80%，表明该电机具有实际生产价值和广阔的应用前景。
At the same time, experimental test of samples show at its output torque increases 80% in contrast with the same type motor.
在电动机实际工作的电压和电流约束条件下，提出了多相永磁电动机的一种最佳转矩控制方法，该方法能够使电动机在给定的控制电流下获得最大的输出转矩。
Under the actual operation lim its of motor voltage and current , a high-efficiency optimum torque control met hod for poly-phase PMSM is proposed.
进行了死区补偿，使逆变器在低频输出时波形明显改善，提高了系统在低频时的转矩输出。
Because dead time is compensated at the same time, the output waveform is improved, and output torque is strengthened in low frequency.
结果表明，死区效应引起了逆变器输出电压波形畸变，引起了电机电流波形畸变和转矩脉动。
The results indicate that the dead time effect distorts inverter output voltage and current waveform and increases torque ripples of the motor.
转矩的快速响应和稳定输出是电动螺旋压力机稳定运行的关键。
The fast response and stable output of the torque are key techniques of electric screw press.
认为以满足螺旋桨额定推力为目的，推进电动机只需要低速输出额定转矩来实现，即输出功率较低。
In order to satisfy the operation requirement of the rated thrust of the propeller, the propulsion motor performs only in rated torque on the low speed, so the motor power is low.
理论分析和实验研究证明了上述系统具有优良的动静态性能，并且在转矩输出、功率因数及装置容量等方面具有良好的综合性能指标。
The theory analysis and experimental research proved that above system has excellent dynamic and static performance, and with better torque output, power factor and device capacity.
维持滑差频率不变，就可获得近似于恒定转矩的输出特性。
Keeping slip frequency constant we can get nearly constant torque output characteristic.
维持滑差频率不变，就可获得近似于恒定转矩的输出特性。
Keeping slip frequency constant we can get nearly constant torque output characteristic.
应用推荐