理想变压器是指具有输入绕组与输出绕组的无损耗的设备。
An ideal transformer is a lossless device with an input winding and an output winding.
改良输出变压器还是基于麦氏的原始想法，也就是说，变压器还是按照传统的推挽输出设计，而且初级绕组具备中央抽头。
The output transformer USES the original idea presented by McIntosh, that is, the transformer is designed for a conventional push-pull output and the primary windings are halved.
绕组线的封装。第3部分：锥形筒式输出线轴。第3节：由热塑性材料制成的不能回收使用的绕线轴规范。
Packaging of winding wires. Part 3: taper barrelled delivery spools. Section 3: specification for non - returnable spools made from thermoplastic material.
绕组线的封装。第2部分：圆桶形输出线轴。第2节：由热塑性材料制成的可回收使用的绕线轴规范。
Packaging of winding wires. Part 2: cylindrical barreled delivery spools. Section 2: specification for returnable spools made from thermoplastic material.
绕组线的封装。第2部分：圆桶形输出线轴。第3节：由热塑性材料制成的不能回收使用的绕线轴规范。
Packaging of windings wires. Part 2: cylindrical barrelled delivery spools. Section 3: specification for non - returnable spools made from thermoplastic material.
增加次级绕组和电路可以获得多个输出。
Multiple outputs are possible with additional secondary windings and circuits.
从微马达结构、气隙磁场、转子厚度、转子写入磁极数和定子绕组的层数对微马达输出力矩的影响进行了分析和讨论。
The effects of structure, gap magnetic field, rotor thickness, magnetic pole Numbers of rotor and winding layers of stator of the micromotor on it's output torque are discussed in detail.
产品输入，输出的电压高低是根据，联接组别，调节抽头多少，绕组容量分配以及次级单相绕组，净化电路的运用。
Product input and output voltage level is based on, join groups, adjust the number of taps, winding single-phase capacity allocation, and secondary windings, the use of purification circuit.
若将他励直流电动机输出功率的机理等效为一个与电动机电枢绕组并联的可变电阻，可以得到他励直流电动机可变电阻型等效电路图。
The output power mechanism of a separately excited DC motor can be equivalent to a variable resistance, which is parallel with the armature winding of the motor.
本文对工作绕组为串联或并联的三相扼流磁放大器（带桥式整流输出）的电磁过程进行了理论分析；
This paper presents a theoretical analysis on the electromagnetic process of three-phase magnetic amplifier of the transductor type with bridge rectifier output circuit .
发电机的谐波组开路或短路，无三次谐波电压输出，检查绕组接头或拆换绕组。
If no triple overtone voltage, check the winding lug or replace with another winding.
双输出绕线式发电机的定转子绕组之间不仅有磁的联系，而且有电的直接联系。
There are not only magnetical connection but also direct connection of electricity between stator and rotor windings of the doubly fed slip-ring generators.
设计一种基于反激式同轴多绕组输出均衡电路，实现对多个串联单体的快速有效均衡。
One kind of equalization circuit based on CWT (coaxial windings transformer) was designed to achieve the destination of fast equalization on series connected ultra capacitors.
为了研究单磁芯饱和电抗器的控制输出特性，在单磁芯结构中增加一个检测绕组。
A measurement winding is added to study the control-output characteristics of the single core saturable reactor.
本发明采用双三相绕组，采用全波整流，在不增加体积的前提下增加发电部分的输出功率。
By adopting double three-phrase windings and full-wave rectification, the generator increases output power of a generation part without increasing volume.
网络变压器模块市场需求量非常大，提高生产效率的主要瓶颈是，变压器绕组的漆包线焊接到输入输出引脚上。
Network transformer module market demand is very large, and increase productivity of the main bottleneck is that the transformer windings of the wire soldered to the input and output pins.
研究得出，当磁芯中存在正偏磁时，检测绕组输出端电压的负峰值与直流偏磁磁势是线性关系；
Researches indicate that negative peak value of the output voltage of the testing winding is linear with the positive DC magnetic biasing potential;
结合绕组电流进行转矩估算，经过转矩误差pid反馈控制，实现电机输出转矩对转矩给定指令的跟踪。
Utilizing flux linkage and phase current, the output torque is calculated, and PID control is used to decrease torque error.
改良麦氏输出变压器的三个绕组采用三线并绕，当然，也需要考虑绕组的极性。
The three windings of this modified version of the McIntosh output transformer are wound trifilar, again with proper consideration given to polarities.
输出电压的特点是根据插槽潜力的星图，分析和电枢绕组的设计约束。
Characteristic of output voltage is analyzed according to the star graph of slot potential, and the design constraints of armature windings are provided.
考虑绕组漏阻抗，应用多绕组变压器理论导出了非阻抗匹配平衡牵引变压器的输出特性；
The output characteristic of non impedance matching balance traction transformer is deduced by employing the theory of multiwinding transformer and with considering the leakage impedance of windings.
由于直驱式风力发电机转速较低，定子绕组需要有较多的匝数以输出足够高的电压，因而绕组负载电流的去磁反应较大；
More turns of winding is needed to produce enough voltage because the DPMG rotates at low speed, but the armature reaction is high at same time.
输出变压器汇总这些生地阶段产生的电流输出波形中的二次绕组。
The output transformer sums these oppositely-phased currents to produce the output waveform in the secondary winding.
采用大、小绕组设计，保证大、小电流输出都能稳定输出。
Big and small winding design ensures steady output of both big current and small current.
该系列电机的定子采用集中式绕组，转子采用永磁材料加工，电机可根据电源的频率要求，输出恒定的转速。
The stator of motor adopts centralized winding and its rotor applies permanent magnet material. The constant speed can be achieved at a certain frequency of power supply.
针对大容量风电机组的中压变换问题，本文研究一种基于多绕组发电机的模块化级联型变换器，通过模块单元级联实现中压输出，从而省去升压变压器。
This paper has presented a module-cascaded system for multi-coil direct-drive permanent magnet wind generator system with high voltage output, eliminating the grid-side step-up transformer.
单片机的P 1.1、P 1.2、P 1.3口分别接步进电机CBA绕组，他们按照一定的规律输出，各端口输出高低电平时序随电机正反转的要求不同而不同。
MCU P1.1, P1.2, P1.3, respectively, then I CBA stepper motor windings, according to the laws of their output, the output ports with high-low-level timing of the positive electric requirements vary.
单片机的P 1.1、P 1.2、P 1.3口分别接步进电机CBA绕组，他们按照一定的规律输出，各端口输出高低电平时序随电机正反转的要求不同而不同。
MCU P1.1, P1.2, P1.3, respectively, then I CBA stepper motor windings, according to the laws of their output, the output ports with high-low-level timing of the positive electric requirements vary.
应用推荐