现在，对管道设置的更改就再简单不过了：只需一次调用，将探测器添加到tee过滤器的一个输出pad中。
At this point, the change to the pipeline setup is simple enough: a call to add a probe to one of the output pads of the tee filter.
如果目标超出了温度敏感性指定，探测器的输出将被激活。
If the target temperature exceeds the sensitivity specified, the output of the detector will be activated.
双色(中短波)同步工作模式的红外探测器，其输出光电流信号为中波信号和中短波混合信号。
The output signals of two-color (MWIR and SWIR) infrared detectors with simultaneous mode are MW current signal and MW-SW current signal.
该系统具有超阈报警，采集记录探测器输出信号和温度等功能。
The data recorder has the functions of alarming over threshold and recording output signals of detector and temperature.
并分析了反射镜作用范围与需要校正的误差的关系，跟踪探测器输出误差信号与物方跟踪误差，以及与跟踪镜控制量的关系。
The relationship of the steering range of FSM and the errors corrected, the detector output and objective error, tracking control system input are analysed.
根据激光对潜通信系统的信道特性和探测器特性，推导并简化了输出信噪比公式。
Based on the channel and detector characteristics of a submarine laser communication system, the output equation for the signal to noise ratio is derived and simplified.
将该方法应用于实际物镜设计，发现光学系统波长及权重符合探测器焦平面输出信号光谱响应特性。
Applying this method to the lens design, the lens' wavelength and weight corresponds to spectral response features of the output signal in the detector's focal plane.
在分光型红外气体分析器（DIGA）设计原理基础上，建立了基于热释电探测器的红外气体分析系统输入输出数学模型。
The input and output mathematical model of DIGA (Dispersive Infrared Gas Analyzer) system with pyroelectric detector was established according to the design principle of DIGA.
探测器输出的电脉冲信号幅度与入射粒子或射线的能量成正比，通过测量脉冲信号的幅度，得到入射粒子或射线的能量。
Detector output electrical pulse signal amplitude is proportional to the energy of incident particle or ray, by measuring the pulse amplitude, get the energy of incident particles or rays.
针对火灾探测过程中的光电探测器输出的微弱信号设计了一个微变信号提取放大电路。
A new circuit has been designed and developed for picking up and amplifying the weak signals of a photoelectric detector in fire detecting system.
指出基于最大相关原理（光电探测器输出信号极值判断法）的匹配解调只适用于两个光纤光栅具有相同的反射谱型。
The wavelength-matched demodulation based on maximum correlation, extremum judgment of photodetector output signal, are only available for alike reflective spectra.
指出基于最大相关原理（光电探测器输出信号极值判断法）的匹配解调只适用于两个光纤光栅具有相同的反射谱型。
The wavelength-matched demodulation based on maximum correlation extremum judgment of photodetector output signal are only available for alike reflective spectra.
ROIC芯片是实现探测器的信号输出的重要部件。
The ROIC chip is an important part to implement signal output from detectors.
好相反，环境背景辐射对两个热释元件几乎具有相同的作用，使其产生释电效应相互抵消，于是探测器无信号输出。
Good contrary, environmental background radiation on almost two pyroelectric devices have the same role to produce a pyroelectric effect of offset each other, so no detector signal output.
实验采用单光路临界角法，用四象限探测器探测输出信号，物面微位移采用压电陶瓷作为驱动元件。
The experiment came into use single light path critical angle method, output signals were detected by four-quadrant receiver, micro-displacement drive element were piezoelectric ceramics.
本文从理论上推导出差分探测光学相移时探测器输出信号与光学相移的关系式。
The relations between the detector output signal of the differential detection of optical phase shifting and the optical phase shifting have been derived theoretically in the paper.
理论上用一维热模型计算了探测器在激光辐照过程中温升和输出信号的变化过程，对实验结果进行了分析。
The temperature rise and output signal of PV InSb detector illuminated by CW laser were calculated with one dimensional thermal model and the experimental result was analyzed.
采用大含量氟利昂气体，用宇宙线测量该探测器的探测效率，输出电荷，时间分辨。
The efficiency, output charge and time resolution were measured by cosmic muons when the detector was operated with F134a rich mixture in avalanche mode.
PMT高压电源线盒信号输出线连接了探测器封装和放大器单元。
Coaxial cables for the high voltage and PMT output current signals connect between the detector housing and the amplifier unit.
火灾探测系统常常因为光电探测器输出信号的微弱而不能工作。文中介绍了为此设计的一个微变信号检测电路。
A new circuit has been designed and developed for picking up and amplifying the weak signals from a photoelectric detector in fire detecting system.
通过比较探测器的输出值与其附近湿度变化曲线，从原理上分析了误报发生的原因。
The humidity curve near the fire detector was compared with the output of the smoke fire detector to analyze the cause of false alarms.
本文还叙述了斯塔克盒锁定CO_2激光器频率的实验，并且观察到的探测器输出信号与计算机计算的结果吻合。
The experiment of CO_2 laser frequency controlled by MH_2D Stark cell is also introduced. The observed detector output signal is consistent with compu…
红外凝视成像系统辐射定标就是在系统焦平面阵列探测器单元的数字化输出与其接收的目标红外辐射之间建立精确的定量关系。
The calibration of infrared staring imaging systems is to acquire the accurate quantitative relation between its digital output and radiance energy of objects.
本文介绍一种与高阻红外探测器相匹配的积分放大器，用来读出探测器的输出信号。
An integrating amplifier working together with the infrared detectors with high impedance, for example InSb (pv), will be here introduced.
整套系统将二维位敏探测器输出的电流模拟信号，转换成电压信号，并接进行放大处理。
For the current signal of PSD (Position Sensitive Detectors), the system translates it to voltage signal, which then is amplified to a suitable scope.
当输入为单波长信号光时，可以通过测量探测器输出的电信号来获得光纤光栅所承受的温度和应变信息。
The amount of the temperature or strain imposed on this device was obtained by measuring the electric signals changing with the shift of resonant wavelength.
初步对“振荡现象”进行了实验研究，认为光电探测器的输出存在振荡现象并不是由于激光器出光功率不稳定引起的。
Some experimental study on the vibrating phenomenon has been done primarily. We conclude that the output of laser is stable and the reason of vibrating phenomenon isn't the unstable incident laser.
在脉冲射线束测量中，射线以束流形式作用在探测器上，输出电流是许多射线粒子同时作用的叠加效果。
When the waveform of a radiation pulse is measured, a large number of radiation particles interact with the detector simultaneously.
同时以探测器特定时刻输出电压作为观测量，建立了称之为模型2的探测器光路逆模型。
At the same time, a model called model 2 is modeled using the voltages of the output of photodetector at special time as observed quantities.
同时以探测器特定时刻输出电压作为观测量，建立了称之为模型2的探测器光路逆模型。
At the same time, a model called model 2 is modeled using the voltages of the output of photodetector at special time as observed quantities.
应用推荐