三极管的信号输出端亦可接到行输出变压器的初级。
The signal output end of the triode can also be connected to the primary of the horizontal output transformer.
的输出变压器平衡的XLR接口和旋转主电位器控制。
The outputs are transformer balanced on XLR connectors and controlled by rotary master potentiometers.
本文分析了导致逆变电源输出变压器直流偏磁的原因。
By analyzing the causes of the flux imbalance in the output transformer of the inverter.
输出变压器具有二维调节功能,使感应器与工件对中心极为方便。
Output transformer has 2-dimensional regulating function, which makes center alignment of inductor and workpiece be easy.
输出变压器汇总这些生地阶段产生的电流输出波形中的二次绕组。
The output transformer sums these oppositely-phased currents to produce the output waveform in the secondary winding.
这种利用当地的负反馈到屏幕上电网的输出级通过利用输出变压器初级。
This USES local negative feedback to the screen grids of the output stage by means of a tapped output transformer primary.
改良麦氏输出变压器的三个绕组采用三线并绕,当然,也需要考虑绕组的极性。
The three windings of this modified version of the McIntosh output transformer are wound trifilar, again with proper consideration given to polarities.
首先,偏置电流为每一方都在流动方向相反的主要输出变压器,所以他们有效地相互抵消。
First, the bias current for each side is flowing in opposite directions in the primary of the output transformer, so they effectively cancel each other out.
然而,这些结论基本上都是在无输出变压器及忽略了三磁柱电感磁路耦合的前提下得出的。
However, these conclusions are normally drawn out without considering the magnetic couples caused by the three-pole transformers and three-pole reactors.
该电路采用脉冲变压器耦合MOSFET管驱动电路,具有输出变压器原边平均电流和副边峰值电流的过流保护功能。
The circuit, with over-current protection of output transformer original side average current and side peak current, adopts pulse transformer coupling MOSFET driving circuit.
改良输出变压器还是基于麦氏的原始想法,也就是说,变压器还是按照传统的推挽输出设计,而且初级绕组具备中央抽头。
The output transformer USES the original idea presented by McIntosh, that is, the transformer is designed for a conventional push-pull output and the primary windings are halved.
这种缺乏静态,直流偏移电流输出变压器的核心手段,可更小,因为它不需要空气间隙,以防止核心饱和从静态直流偏移电流。
This lack of static, DC offset current in the output transformer means that the core can be made smaller, because it requires no air gap to prevent core saturation from the static DC offset current.
电线适用于电视接收机行输出变压器高压输出,连接高压整流硅与头像管高压及,以及其他电子仪器仪表内部作高压安装及讯号连接作用。
This wire si suitable for TV High voltage as connecting wire between rectify and kinescope, or as connecting wire or fixing wire in other appliance and instrument.
电线适用于电视接收机行输出变压器高压输出,连接高压整流硅与头像管高压及,以及其他电子仪器仪表内部作高压安装及讯号连接作用。
This wire si suitable for TV High voltage as connecting wire between rectify and kinescope, or as connecting wire or fixing wire in other appliance and instrument.
应用推荐