同时使用不同的输入、输出共模电压的方法来提高调制器的动态范围。
Different input and output common mode voltages are used to improve the modulator's performance.
对变频输出共模电压及轴承电流的形成机理进行了研究，分析了其对潜油电泵轴承寿命的危害。
By the transmission line theory, the generation mechanism of common-mode voltage and the bearing current was discussed.
为有效减少共模电压和输出电缆对高压变频器的不良影响，提出了一种LRC滤波器拓扑结构，给出了滤波器各个参数选取原则。
For effectively eliminating the bad impact of the output cable, a topological structure of LRC filter is presented and its principle of parameter selection is given.
该放大器采用全差分结构以获得高输出摆幅，利用源反馈技术改善线性度，并设计了共模反馈电路以稳定共模输出电压。
The amplifier employs fully differential structure to obtain high output voltage swing, and uses source degeneration techniques to improve the linearity.
高精度大电流控制器有着广泛的应用，但在高共模电压情况下输出电流的检测电路比较复杂。
The high precision and large current controller are used widely. But in the situation where there is high common-mode voltage, the detection circuit of the output current is very complex.
该文对零输出换相策略、电压增益及开关动作顺序进行了详细的分析，并与双电压合成控制策略下共模电压的最大瞬时值进行了对比。
The paper analyzes in detail the synthetical method, the voltage gain and the switch action sequence of matrix converter based on the zero-output commutation strategy.
该算法产量低共模 电压和电流，在可接受哒PWM输入纹波 和输出哒逆变器，并没有过电压 提问题不要像AZSPWM1。
The algorithm yields low common mode voltage and current, acceptable PWM ripple at the input and output of the inverter, and has no overvoltage problems unlike AZSPWM1.
传统二极管箝位变换器的电压变化率和共模电压较高，且波形谐波含量较大，使得输出滤波器的设计变得复杂。
Traditional diode-clamped converters have high voltage variation rate, common-mode voltage and harmonics, which make the design of its output filter complicated.
文章对三电平逆变器输出中的共模电压进行了分析，为了减小共模电压带来的危害，文中采用了两种SPWM控制策略即传统三电平SPWM控制策略和降低共模电压的三电平SPWM控制策略。
The common mode voltage for the output of three-level inverter is analyzed. To diminish the harm caused by the common mode voltage, two control strategies of SPWM are adopted.
文章对三电平逆变器输出中的共模电压进行了分析，为了减小共模电压带来的危害，文中采用了两种SPWM控制策略即传统三电平SPWM控制策略和降低共模电压的三电平SPWM控制策略。
The common mode voltage for the output of three-level inverter is analyzed. To diminish the harm caused by the common mode voltage, two control strategies of SPWM are adopted.
应用推荐