高功率，互补，线路驱动器输出保证干净，长电缆长度超过清晰的信号。
A high power, complementary, line driver output assures clean, crisp signals over long cable lengths.
高功率免费线路驱动器输出保证清洁，多长的电缆长度清晰的信号。
High power complimentary line driver outputs assure clean, crisp signals over long cable lengths.
设计出传感器输入输出信号调理电路和试验台架液压激振系统、磁流变阻尼器控制器的功率放大电路。
Design the signal adjust circuit for sensor, and the power amplification circuit for the hydraulic pressure system of test platform and the controller of magnetorheological dampers.
以音乐信号瞬间能达到的峰值电压来计算的输出功率，其商业意义大于实际作用。
With the music signal in a moment can the worth electric voltage of attaining come the over and above and actual function of meaning of calculating exportation power, its business.
由于功率与电压平方成正比， 因此如果输入型号增大至两倍，输出信号将增大至四倍。
Since power is proportional to the square of the voltage, if the input signal is increased by a factor of two, the output signal is increased by a factor of four.
理论分析结果表明，单周控制开关功率放大器的输出信号与输入信号成线性变化关系，其控制性能由输出滤波器决定。
The theory research results of one cycle controlled switching power amplifier show that the output signal follow the input signal linearly, and the control performance is decided by output filter.
传感器的安装位置尽量远离大功率设备，因为它本身的输出信号就比较弱，通常为毫伏级，极易受到干扰。
Sensor is installed as far away from high-power devices, because its own output signal is relatively weak, typically millivolts, vulnerable to interference.
通过判断电动机输出功率信号中是含有一个直流分量和一个余弦分量还是仅含有直流分量，判断鼠笼转子有无故障，提出了一种感应电机转子故障检测的新方法。
A new method to detect rotor cage fault of induction motor is presented, which monitors if the output power signal comprises a direct component and an alternating component or only a direct component.
利用温度传感器测到被控对象的温度信号与设定温度值进行PID调节，从而控制高频输出功率的大小。
Temperature sensor will be used to measure the temperature signal and build temperature for PID adjusting to realize the automatic output high frequency power.
在该系统中，提供了一种用于减少来自无线通信设备的发射电路中的功率放大器的输出信号的谐波的电子电路。
In the system, an electronic circuit for reducing harmonics of an output signal from a power amplifier in a transmission circuit for a wireless communication device is provided.
功率放大器可以实现交流信号的准确跟踪和放大，输出频率范围可达1000赫兹。
And the power amplifier can realize accurately tracking and amplification for ac signals with frequency range up to 1000hz.
并用动态信号分析仪和功率计校准输出信噪比。
Then the output S/N is calibrated DA with the dynamic signal analizer and power meter.
控制所述发射信号通路中的各种元件的增益，以降低输出发射功率中的瞬变，并还确保所述瞬变是向下的。
The gains of the various elements in the transmit signal path are controlled to reduce transients in the output transmit power, and to also ensure that transients are downward.
算法利用输出信号和参考信号之间“几何功率”误差的最小化来求解最优权向量。
This new beamformer minimizes the "geometric power" error between the beamformer s output and the reference signal.
由于放大器的负载为调谐回路，所以能选出余弦脉冲中的基准分量，获得不失真的放大信号输出，因此这种放大器也称为调谐功率放大器。
As the amplifier tuned load circuit, they are able to select the base component cosine pulse to obtain undistorted amplification signal output, so this amp is also known as tuned power amplifier.
数据采集卡采集程控电源的输出以实现对程控电源的闭环控制，采集发电机控制器和汇流条功率控制器的保护信号以计算延时时间。
Data acquisition card collects data about the power output to realize a close-loop control, and protection signal of the two controllers to compute the delay time.
由PW M脉宽调制器驱动功率驱动电路，输出电流信号驱动比例电磁铁。
This output transferred thorough PWM driver circuit and changed into current signal to the proportional magnetic valve.
放大器的输出施加到信号检测器，其中信号检测器的输出信号是光接收机的输出功率电平的指示。
An output of the amplifier is applied to a signal detector, wherein an output signal of the signal detector is an indication of an output power level of the optical receiver.
高功率，互补，线路驱动器输出，保证廉洁，在长距离电缆长度清晰的信号。
High power, complementary, line driver outputs assure clean, crisp signals over long cable lengths.
该文介绍了在可控硅功率调节系统中，采用8098单片机hso端作为控制信号输出通道的硬件和软件设计。
This paper deals with the designs of the hardware and software based on the HSO of 8098 single-chip microcomputer as the way of control signal in the si-control power modulation system.
模拟部分主要包括电源、功率控制、信号产生、信号调制、高压输出控制和反馈控制电路。
The analog part mainly includes power source, power control, signal generation, signal modulation, high voltage output control and feedback control circuit.
这是最有效的方法，扩增，因为输出设备的最大功率耗散没有输入信号。
This is the least efficient method of amplification, because the output devices are dissipating maximum power with no input signal.
为实现光纤一体化设计及高功率输出，采用MOPA技术，对信号光进行放大。
MOPA technology is applied to achieve all fiber structure and high power output, the optic signal is amplified.
功率放大器两个基本要求：一是输出信号变化能够与输入信号的变化相一致，即：系统失真小：二是整个功率放大器的损耗低，即：系统效率高。
The requirements are: the change of output signal is consistent with input signal, namely, low distortion; and the loss of the power amplifier is low, namely, high efficiency.
理论研究表明，两点源信号幅度不相等时，脉冲积累后的导引头输出指向大功率源。
Theoretic study shows that the seeker points to the bigger power source via pulse accumulation when the dual sources have different amplitude.
射频功率放大器的主要功用是放大射频信号，并且以高效率输出大功率为目的。
The primary function of RF power amplifier is to amplify the RF singal with high efficiency.
文中给出倍压输出的功率主电路和数字信号处理器（DSP）控制电路。
Voltage-doubler output of main topology and control circuit based on DSP are given in the paper.
文中给出倍压输出的功率主电路和数字信号处理器（DSP）控制电路。
Voltage-doubler output of main topology and control circuit based on DSP are given in the paper.
应用推荐