所有输入和输出连接器提出了关于此案的一个表面，并与相应的模块线。
All input and output connectors are presented on one surface of the case and in line with their corresponding modules.
与操作映射一样，您将一个操作的输入和输出连接到另一个操作的对应输入和输出。
As with an operation map, you connect inputs and outputs of one operation to the corresponding inputs and outputs of another operation.
当将其中的一个本地任务连接到另一个元素时，要确保如图2所示使用现有的输入和输出连接。
When connecting one of the Local Tasks to another element, make sure that the existing input and output connections are used as shown in Figure 2.
与其他细分不同，If、Else if和 Else 细分都可以具有多个输入和输出连接，这为嵌套映射将操作的内容提供了基础。
Unlike other refinements, If, Else if, and Else refinements can each have multiple input and output connections, which provide the basis of what nested mappings will operate on.
对于操作参数，该编辑器底部显示了您通过连接每个操作的各个参数(输入和输出)来创建的映射。
For the operation parameters, the bottom of the editor shows mappings that you create by connecting the respective parameters (inputs and outputs) of each operation.
不要将网关或活动的所有输入或输出直接连接到开始、结束和停止节点。
Do not connect all inputs or outputs of a gateway or activity directly to start, end, and stop nodes.
悬空输入和输出往往作为您决定删除或重定向的连接的残余部分遗留下来。
Dangling inputs and outputs often remain as residues of connections that you decide to delete or redirect.
文中展示了如何通过定义任务、输入和输出以及如何连接到工作流之上来创建流程。
It showed how a process can be created by defining tasks, inputs, and outputs and how they can be linked into a workflow.
UIMA通过一个层级类型系统定义连接、输入和输出。
The connection, inputs, and outputs are defined by UIMA through a hierarchical type system.
由于其复杂的结构，你可以对活动递归地进行分组并对流进行连接以形成更高的层，这种层次清晰地定义了输入和输出。
As with complex structures, you can recursively group activities and their interconnection flows into higher-level activities with clearly defined inputs and outputs.
然后，与 CanaryHandler 类似，它打开一个radiostream连接以及数据输入和输出流。
Then, similarly to CanaryHandler, it opens a radiostream connection and data input and output streams.
port类型将操作连接到消息以获取输入和输出参数。
The port type links an operation to messages for its input and output parameters.
当您删除某个连接时，Business Modeler不会删除曾连接的输入和输出，因为您可能希望重新连接它们。
When you delete a connection, Business Modeler does not automatically delete the inputs and outputs that were connected, because you might want to reconnect them.
因此，如果您只是连接某些输入和输出，那么您马上就能获得悬空输入和输出，它们是无法在基本编辑模式中直接显示的，如图2所示。
Thus, if you only connect some of the inputs and outputs, you immediately have dangling inputs and outputs that are not directly visible in basic editing mode, as Figure 2 shows.
设置连接器的输入和输出参数。
图6显示的是第二种方法，该方法只使用单个输入和输出条件，但它会把所有未连接的输入和输出的最小增殖次数设置为零。
Figure 6 shows the second approach, which USES only a single input and output criterion, but sets the minimum multiplicity of all disconnected inputs and outputs to zero.
流程模型中出现的一个常见现象是悬空输入和输出，即模型中保持未连接状态的活动或网关的输入和输出。
A phenomenon that we often observed in process models is the occurrence of dangling inputs and outputs, i.e., inputs and outputs of an activity or gateway that remain unconnected in the model.
为了减少复杂的数据流模型中出现的混乱，请显示未连接的数据输入和输出。
To reduce clutter in complex data flow models, show disconnected data inputs and outputs.
只有当输入和输出LO端被连接到相同点时，这种假设才成立。
This is valid only if input and output LO are connected at the same point.
它遵循了输入电压和负载变化连接良好的输出稳定，他们在正常使用下几乎不会有损坏。
It has excellent output stability by following up the variation of input voltage and connected load, they almost can't be damaged in normal use.
将新的InvokeOrderValidation活动连接到上面创建的合作伙伴链接和操作以及输入和输出流程变量，如图15所示。
Wire the new InvokeOrderValidation activity to the partner link and operation and to the input and output process variables you created above, as shown in Figure 15.
当连接和配置后，头戴式耳机可以充当远程设备的输入输出接口。
When connected and configured, the headset can act as the remote device's audio input and output interface.
型号500包含了立体声线性电平输入和输出，这能够使扩音器在前置扩音器与扩音器间连接，不需要Y型连接器。
The MODEL 500 incorporates stereo Line-Level inputs and outputs that permit the amplifier to be connected between a preamplifier and amplifier without the need for Y-connectors.
连接阶段。可移动输入口和输出口。可指定输入口和输出口数量。
Connecting stage. Inlets and outlets can be moved. Inlet and outlet quantities can be specified.
多个交换单元以及输入输出端口模块以一定的拓扑结构和内部协议连接就构成了路由器内部的交换网。
The certain topology which interconnected by switching modules, input and output modules, and internal protocol constitutes the internal switching network in a router.
有很多其它的输入和输出设备能够被连接到计算机。
There are many other input and output devices that can be attached to computers.
由输入连接和输出连接组成的一种双向通路，两个连接都有同一交换机接口。
A bi - directional path comprised of an input connection and an output connection, both having the same exchange interface.
并通过键盘和LCD与单片机的连接，实现数据的输入、数据输出及人机交互。
And through the keyboard and LCD and MCU connection, realize the data input, data output and human-computer interaction.
与计算机连接的设备，包括输入设备，存储设备，和输出设备。
Device that interact with computers, including input devices, storage devices, and output devices.
自组织系统的处理信息的控制程序把上述客体的被动的信息（输入）和主体的施动的信息（输出）连接起来。
Self-organizing system's commanding programs processing information link above-mentioned objective passive information (input) and subjective active information (output).
应用推荐