待系统稳定后，重新调整载气流量。
而当载气流量增大时，样品质量改善。
The quality of the samples was improved with increasing carrier gas flow rate.
检查载气流量，将进样模式改为手动。
To check the carrier flow, put the injection mode in manual.
当一个低载气流量报警出现有30秒时，等离子体或者TCD关闭。
When a "Low carrier flow" alarm remains active for 30 seconds, turns the plasma or TCD off.
研究了液体流量、载气流量、壁面热负荷及料液物性等对降膜载气蒸发传热的影响。
The effects of liquid flow rate, carrying gas flow rate, heat flux and liquid properties on heat transfer coefficient were measured.
实验表明：通过调节柱温和载气流量可获得较好的分离图谱。并可以用峰分离度指标来衡量。
The experiment indicated that the better separation diagram may be obtained and measured with target of peak resolution through adjusting column temperature and carrier gas flow rate.
实验结果表明：当载气流量增大、加热温度增高、饱和煅后焦量减少，都有利于再生效率的提高。
The experiments showed that more loaded gas velocity, higher temperature and less saturated calcined-coke did well to the increase of the regeneration efficiency.
在卷烟鉴别问题中详细研究了测试气室、载气流量、样本温度等实验条件对系统的识别性能的影响；
The influence of the array chamber, carrier gas flux and sample temperature on the performance of the system was discussed in the identification of different brands of cigarettes.
对样品的溶解、元素波长、载气流量、辅助气流、观察高度等工作条件进行试验，选定了最佳测定条件。
The testing was done on the working conditions such as the sample resolution, element wave-length, air-carrier flow, auxiliary air flow, observed altitude, etc.
在一定加液量范围内，加液量的变化对雾化速率影响不大，雾化速率随载气流量和雾化功率的增大而增大；
The atomizing rate changed slightly with the sample volume decreasing, and increased with atomizing power and the flow rate of carrier gas.
利用光学温度控制器使测量硅的峰高信号增强一倍，试验了时间常数、载气流量、常用酸和盐对测硅灵敏度的影响；
Using the optical temperature control accessory, silica peak height signal was enhanced doubly, reducing atomization time, extending useful time of graphite tube.
其中反应器温度做为最重要的影响因素对生物油的产率起决定作用，而生物质颗粒粒径、载气流量对生物油产率的影响相对较小。
Reactor temperature is the most important influence factor and plays the decision role to the bio-oil production rate, the particle size and fluidization gas amount play the relative small role to it.
对气相色谱和原子荧光的在线联用进行了设计，优化了进样口温度、载气流速、尾吹气流量及氩气流量等实验条件。
The hyphenation system was carefully designed and the operation (conditions) such as injector temperature, carrier gas flow rate, make-up gas flow rate and argon flow rate were optimized in detail.
流量组合框里的传感器、I/O、压力是用来显示分析仪上样品气和载气流路。
The Flow association represents which sensor on which I/O Board or Pressure Board should be used to view the sample flows and carrier flows in the analyzer.
首先，在不同气流温度、温度、流量及不同刨花初含水率、载带率条件下进行刨花对撞流干燥实验。
First, experimental study on the influence of air temperature, velocity, initial moisture content of wood particles and mass flow rates ratio in the process of ISD has been performed.
首先，在不同气流温度、温度、流量及不同刨花初含水率、载带率条件下进行刨花对撞流干燥实验。
First, experimental study on the influence of air temperature, velocity, initial moisture content of wood particles and mass flow rates ratio in the process of ISD has been performed.
应用推荐