作为一个完备性测试,请测试计算机中的软盘镜像,以检查flash 是否自动运行,并应用了正确的配置。
As a sanity check, test the floppy image you have in a computer to check that the flash happens automatically and the correct settings are applied.
用软盘镜像启动一台计算机(如果计算机没有软驱,可以使用usb软驱)。
Boot a computer with the floppy disk image (use a USB floppy drive if the computer does not have one).
把磁盘插回刚才更新完并设置好BIOS配置选项的计算机,从修改后的软盘镜像启动。
Insert the disk back into the computer where the updated and configured BIOS options are set, and boot from your modified floppy disk image.
用当前的方法不能合理地刷新大型集群,需要写入一张软盘或CD镜像,并需要对每台计算机分别执行刷新;所以需要另一种方法。
It is not reasonable to flash a large cluster with current methods, which involve writing a floppy disk or CD image and attending to each computer individually; an alternative is required.
下载最新的BMC固件更新dos镜像,按照说明创建软盘启动镜像。
Download the latest BMC firmware update DOS image and follow the instructions to create a floppy disk boot image.
请下载最新的BIOS更新dos镜像,并按说明创建软盘启动镜像。
Download the latest BIOS update DOS image, and follow the instructions to create a floppy disk boot image.
下载Broadcom固件(请参阅参考资料),并按说明创建软盘启动镜像。
Download the Broadcom firmware (see Resources), and follow the instructions to create a floppy disk boot image.
对修改后的BIOS更新镜像满意之后,就可以用以下命令用软盘创建PXE启动镜像。
Once you are satisfied with your modified BIOS update image, you can create a PXE boot image from the floppy disk with the following command.
在一个软盘中,磁盘镜像的扇区的开始地址。
Start address in sectors of the ramdisk image on a floppy disk.
在一个软盘中,磁盘镜像的扇区的开始地址。
Start address in sectors of the ramdisk image on a floppy disk.
应用推荐