安装搅拌器要求轴封处之径向跳动量调到最小程度，搅拌器不可反转，以免脱落。
When installing the mixer, you should miunimize diameter at shaft gland towards quaking magnitude. the mixer mustn ' s be counterclocked, otherwise it will drop.
根据通过计算得出的主变速器输出轴输出转速、径向跳动量以及水平跳动量来验证模型的正确性。
For validating the dynamic model, the output speed, radial runout, horizontal runout were obtained about the power take-off of the transmission.
该项研究不仅适用于实验室及生产中的实际测量，也为激光跳动量仪的设计和制造提供了可靠依据。
It is applied to not only the practical measurement in lab and manufacture, but also providing reliable basis to the design and manufacture of the run out measurement device by laser.
通过综合分析其优化计算结果发现，可将转子的跳动量进行分组，并找到适宜于该组范围内的指尖密封优化新结构。
Optimization calculation result was analyzed and the whole rotor jump range was grouped up, a new finger seal structure for each group was found.
用压缩矩形的最小二乘法拟合工件端面图像的边缘以及用DFT变换对工件端面的跳动量进行测量，使端面跳动测量的准确性得到了很大的提高。
Accuracy of measurement of face runout is enhanced effectually by use of least square method of compressing rectangle fitting edge of image and transforming of DFT.
用压缩矩形的最小二乘法拟合工件端面图像的边缘以及用DFT变换对工件端面的跳动量进行测量，使端面跳动测量的准确性得到了很大的提高。
Accuracy of measurement of face runout is enhanced effectually by use of least square method of compressing rectangle fitting edge of image and transforming of DFT.
应用推荐