概述了其工作原理及负载电压变化。
Its working principle and load voltage variation are all presented.
规格书上的输出电压范围包含电线和负载电压。
Specified output regulation limit includes line and load regulation.
负载电压的平方值表明了功率消耗为阻性负载的持续温度。
The square of the r. m. s . load voltage represents the power dissipated in a purely.
该控制方式的指令信号通过同时检测电源电流和负载电压得到。
The reference signal in this control approach is obtained by detecting both source current and load voltage.
非线性负载电压和电流之间是非线性关系的负载称为非性形负载。
Nonlinear load a nonlinear load is a load for which the relationship between voltage and current is not a linear function.
利用上述的开关策略进行跟踪，达到对负载电压和电流补偿的目的。
Using the proposed switch control strategy to track the references, load voltage and current are compensated.
分析了汽车发电机抛负载电压的形成过程及其与发电机的相电动势、激磁电流和转速之间的关系。
This paper analyzes the forming process of unloading voltage and the relations among unloading voltage, phase electromotive force, exciting current and rotational speed in art alternator.
文中针对船用恒电位仪单相可控桥式整流电路，推导了负载电压表达式，分析了负载电压的谐波组成；
To single phase SCR bridge rectification circuit of constant potential instrument, the expression of load voltage is derived and harmonic component of load voltage is analyzed in detail.
同时断开电容器C3与地的连接，由此电容器C4上的负载电压波动不会影响IGBTQ2的栅极电压。
The same time capacitor C3 is disconnected from the ground so that the load voltage ripple on capacitor C4 does not influence the gate voltage of IGBT Q2.
提出一种利用无功补偿技术进行并网发电系统孤岛检测的方法，通过对负载电压频率的判断即可有效检测是否进入孤岛状态。
A new method for islanding detection is presented, and the status of the islanding can be detected by the change of the frequency of the load voltage.
简要分析了串联型电力有源滤波器（APF）的工作原理，提出了一种负载电压检测控制方式，给出了其主电路的参数设计方法。
The paper analyzes briefly the basic operation principle of a series APF and proposes a control approach of detecting its load voltage.
这个火箭发射场现在能对闪电电压进行精确测量，并可以让工程师们检测电气设备的负载。
The rocket site is providing precise measurements of lightning voltages and allowing engineers to check how electrical equipment bears up.
噪声与波纹电压为50mV p-p，输出负载瞬时恢复时间0.5ms。
Noise and ripple is 50 mV p-p and output load transient recovery is 0.5 milliseconds.
具有短路保护、过电流保护、过负载保护以及电压保护多重保护。
With short circuit protection, over current protection, the load voltage protection protection and multiple protection.
为了监测输出电压，将一个伏特计与负载电阻并联在一起。
To monitor the output voltage, a voltmeter is connected in parallel with the load resistance.
它遵循了输入电压和负载变化连接良好的输出稳定，他们在正常使用下几乎不会有损坏。
It has excellent output stability by following up the variation of input voltage and connected load, they almost can't be damaged in normal use.
电枢电压和外负载转矩是系统的输入。
The armature voltage and external load torque are inputs to the system.
在有些应用中，则可能希望测量每一单体电池的电压，包括负载和空载。
In some applications, it may be desirable to measure each cell voltage, both with and without a load.
软加载软加载是指在给发电机组增加或减少负载时要逐渐进行，以减少电压和频率对系统的瞬变影响。
Soft loading Soft loading refers to the ramping of load onto or off of a generator in a gradual fashion for the purpose of minimizing voltage and frequency transients on the system.
仿真和实验结果证实了该逆变器具有开关频率固定，输出电压波形质量好，非线性负载适应能力强等优点。
The simulation and experimental results illustrate advantages of the inverter:fixed switching frequency, high output-voltage performance, and strong nonlinear load adaptability, etc.
系统利用重复控制抑制非线性负载下的电压畸变，利用瞬时值反馈控制加快负载突变时的动态响应过程。
Repetitive control is used to reduce voltage distortion under nonlinear loads and instantaneous feedback control is designed to quicken the dynamic response process under abrupt load variation.
负载电流的计算应该根据工作电压和负载的功率计算。
The load current is calculated from the supply voltage and the load power.
在某些场合，需要使用多种电压的负载时，也要用到DC - DC逆变器，如将24vdc的电能转换成5vdc的电能(注意，不是简单的降压)。
In some cases, the need to use a variety of load voltage, but also used for DC-DC inverter, 24vdc power if converted to 5vdc power (note, not a simple step-down).
短路保护，过电流保护、过负载保护以及电压保护。
Short circuit protection, over current protection, overload protection and voltage protection.
短路保护，过电流保护、过负载保护以及电压保护。
Short circuit protection, over current protection, overload protection and voltage protection.
应用推荐