负载率和电源功耗之间的关系是其比率为1：1。
The relationship between duty cycle and power consumption is a 1:1 ratio.
三是调整来自系统外的购买能值投入，减轻环境负载率；
Third is to adjust the purchase from outside the system energy inputs, reduce environmental loading rate;
作者在调查的基础上，确定了该航线的年运量、水深及负载率。
On the basis of his investigation, the author determines the annual amount of shipping, the water depth and the load rate.
根据“等效功率损耗法”推导出实用的电动机负载率计算公式。
According to the equivalent efficiency loss method, the practical formula for motor load rate is derived.
我们可以找到的唯一研究是，提高负载率导致的伤害多见胫骨应力骨折。
The only study we could find that measured injuries by loading rates found more tibial stress fractures when the loading rates were higher.
电机负载率和效率有着密切的关系，效率的高低直接影响着电机的节电。
The motor load resistance is strongly related to its efficiency which has a direct influence on energy saving.
介绍了电动机负载率的几种不同测算法，并举例说明电流法应用的局限性。
The diverse measurements and calculations for asynchronous motor load rate are mentioned and some examples are given to illustrate the limitations of electric current method.
因此，基本动态负载率和基本生活评级(根据相同的操作条件下)是显着改善。
As a result, the basic dynamic load rating and basic rating life (under identical operating conditions) is significantly improved.
以LED为基础的EMC负载率，与整个标识的亮度和电源功耗级是直接相关的。
The duty cycle of an LED-based EMC relates directly to the sign's brightness and its degree of power consumption.
本发明的优点在于：工艺简便， 重复性好，贵金属的有效负载率高，与载体的结合力强；
The merit of the invention is characterized in that: the technique is simple, and the effective load factor of noble metal is high;
本文简述了三相异步电动机运行中的效率、功率因数、负载率和功率的关系及各种节电措施。
This paper explained in brief the relation of three-phase asynchronous motor among efficiency, power factor, load rate and power and every power saving measures.
基于综合经济负载率提出了综合效率的概念，并以此为标准提出了经济运行状态的判定原则。
The integrate efficiency is brought forward based on the integrate economical load radio and the partitioning principle is presented.
通过技术分析和计算，确定变压器临界系数以及变压器的最佳负载率，合理选择变压器的容量。
Through technical analysis and calculation, the critical coefficient and optimal load rate of transformer are determined for the reasonable selection of transformer capacity.
当空压机负载率低于25%时，空压机不需要空载运行消耗电能，而可直接停机，将能耗降为零。
With the pressure machine load rate below 25%, air compressor no-load running power consumption need not, and can be directly downtime, energy consumption will be zero.
另一方面，根据美国能源部2002年的调研报告，各国空压机使用的负载率几乎不可能超过90%。
On the other hand, according to the energy department in 2002 the investigation report, countries the air compressor load rate almost can not be more than 90%.
双打有两倍的动态负载率和单一的单位，可以安装到位的单打在大多数应用中由于越来越多类似的足迹。
Doubles have twice the dynamic load rating of single units and can be mounted in place of the singles in most applications due to similar mounting footprint.
并在变压器静态经济负载率分析的基础上提出变压器动态最佳负载率，以此作为变压器经济容量的选择依据。
On the basis of the analysis of static economic load rate, a dynamic optimal economic load rate of transformer is provided, which is the basis for selection of trans-former capacity.
研究结果表明，该算法能够实现LIN总线带宽利用率的最优解，并能进一步降低LIN总线的总线负载率。
The results indicate that this algorithm can not only achieve the optimal bandwidth utilization of LIN bus, but also reduce the busload of LIN bus.
仿真结果显示，在正常负载率区间下，新的调度策略有效的降低了任务拒绝率，而运行开销在可接受范围内。
Simulation result shows that under normal system load range, the proposed strategy reduces the task rejection rate effectively while keeping runtime overhead manageable.
金刚石轴承具有在空气、油和水中摩擦系数低以及高负载率的特点，与不锈钢轴承相比一些技术方面有待提高。
Diamond bearing with the air, oil and water, low coefficient of friction and high load rate characteristics, compared with some of the technical aspects of stainless steel bearings to be improved.
文章从分析CAN总线协议入手，通过计算CAN总线的总线负载率，得出单个CAN总线传输报文帧的上限值。
Based on the analysis of CAN bus protocol, this paper obtains upper limit of frames in a single CAN bus through calculating its busload.
双人枕头块具有相同的动态负载率为双打是一个很好的选择时，只用一个枕头每块轴或申请使用悬臂式负荷或时刻。
Twin pillow blocks have the same dynamic load rating as the doubles and are a good choice when using only one pillow block per shaft or in applications used to cantilever load or moment.
由此导出变压器年运行费率、最低年运行费率、变压器最佳负载率以及变压器经济运行区宽和变压器损耗比的关系。
Then, relationships between the quantities mentioned above, the interval of economic operation and the loss factor of transformers are derived and discussed.
由此导出变压器年运行费率、最低年运行费率、变压器最佳负载率以及变压器经济运行区宽和变压器损耗比的关系。
Then, relationships between the quantities mentioned above, the interval of economic operation and the loss factor of transformers are derived and discussed.
应用推荐