对小扰动下感应电动机的动态电压稳定性进行了仿真，并运用其负荷特性对仿真结果进行了分析。
Simulation of dynamic voltage stability of induction motor in the context of small disturbances and analyses of the simulation results with its load characteristics.
本文针对负荷特性和有载调压变压器对电力系统静态电压稳定性的影响展开研究。
This thesis carries out studies aiming at the impact of load characteristics and on load tap changer on voltage stability.
针对这种情况，提出了一种基于负荷裕度随机特性的方法来计算系统电压失稳的概率。
Therefore, this paper proposes a method to calculate the probability of voltage instability based on the stochastic characteristic of load margin index.
电力系统的静态电压稳定问题是系统特性与负荷特性共同作用的结果。
The steady state voltage stability is concerned with both system characteristics and load characteristic.
在分析中小屏幕TFT - LCD驱动芯片的负荷特性的基础上，提出了一种新型的驱动电压输出缓冲电路结构。
Based on the detailed analysis of the loading properties of a medium or small size TFT-LCD driver IC, a novel output buffer circuit of driving voltages is proposed.
论述了负荷特性对相对电距离指标的影响，并与电压稳定性负荷节点指标进行了比较，论证了两种方法的等价性。
The influence of load characteristics to the relative electrical distance index is discussed and compared with the voltage stability load bus index. The equivalence of both indexes is proved.
有载分接开关(OLTC)的调节特性和负荷特性对电力系统电压稳定性具有极大的影响。
Both regulating characteristics of on-load tap changer (OLTC) and load characteristics greatly impact power system voltage stability.
在此基础上，进一步考虑负荷的电压/频率调节特性，建立了微电网三相潮流模型。
Furthermore, loads voltage/frequency characteristics were considered. Based on these considerations, a microgrid power flow model has been presented.
对一个三相系统模型进行仿真，分析了感应电机动态负荷特性对系统电压稳定性的影响，并给出改善电机节点电压性能的措施。
The paper simulates a three-phase system, analyzes influence of induction motor dynamics on voltage stability, and gives methods to improve voltage stability of induction motor nodes.
应用电力系统负荷的电压-功率特性曲线，分析了不同负荷的负荷特性对静态电压稳定性的影响。
Analyses of the impact of different load characteristics on static voltage stability with the V-P-and-V-Q curves of power system loads.
该方法考虑了风速和负荷变化对风电场输出有功功率和无功功率的影响，对风电场节点的处理较准确地反映了其无功和电压特性。
This method considered the influence of wind speed and load on active power output and reactive power output of wind farms. The processing of the wind farm node reflects its character accurately.
该方法适合对容量、负荷工作特性和谐波发射特性不同的负荷谐波(电压和电流)限值的确定。
It is available for specifying the harmonic emission (voltage or current) limits from distorting loads concerned with the capacity, operation and harmonic nature.
该方法适合对容量、负荷工作特性和谐波发射特性不同的负荷谐波(电压和电流)限值的确定。
It is available for specifying the harmonic emission (voltage or current) limits from distorting loads concerned with the capacity, operation and harmonic nature.
应用推荐