敏感性是心理负荷测量技术可靠性的基本要求。
Sensitivity is vital to the measuring reliability of mental workload.
这是一项关于操作人员的心理负荷测量的实验研究。
This is an experiment on workload measurement of human operators.
一般来说，应在样机上进行功率和负荷测量，然后与计算值进行比较。
As a rule, power and load measurements shall be performed at the prototype, after which they shall be compared to the calculated values.
国内研究集中在人体测量、视觉显工效学评价、个体防护装备工效学评价、工作能力和工作负荷测量等方面。
The researches at home were focus on anthropometry, ergonomic evaluation of visual displays and personal protective equipments, measurement of work ability and workload.
针对母联电流相位比较式母差保护接线的重要性，文章介绍了一种带负荷测量法去验证母联电流相位比较式母差保护接线正确的方法。
Seeing that the importance of the bus protection wiring in bus coupler current phase comparison, in this paper an on-load testing verifying its wirings is introduced.
可燃物负荷是测量每块地区可得燃料的数量，通常是每英亩的吨数。
Fuel load is measured by the amount of available fuel per unit area, usually tons per acre.
为一件事，压缩负荷细胞是最适当的推力测量，。
For one thing, a compression load cell is most appropriate for thrust measurement, .
在额定功率因素上施加150%额定负荷，并测量逆变器保护装置启动所需时间。
Apply150% rated load at rated power factor and measure the time required for the inverter protective devices to operate.
全部测量记录及负荷试验报告一式三份交大副。
All measuring records and load test reports need to be handed over to chief officer in three copies.
变电站综合自动化交流采样测量装置可采用虚负荷法和实负荷法检测。
Imaginary load method and real load method can be used to test AC sampling measurement device of integrated substation automation.
在测量负荷为零、而且一个套圈相对于另一套圈无轴向位移的情况下，这些限值对安装前的轴承有效。
The limits are valid for bearings before mounting under zero measuring load, and with no axial displacement of one ring relative to the other.
铁路通用设备。车辆每个车轮静态负荷的测量。称重设备和控制装置。
Railway equipment in general. Measurement of the static loads per each wheel of the vehicles. Weighing installations and control.
热沉能够保证有效地减小温度计上的热负荷，提高温度测量的精确度。
The heat sink can effectively guarantee the reducing of the heat load on the thermometer, and improve the accuracy of temperature measurement.
研究设计：这项研究是一个重复测量设计，以衡量健康儿童腰椎对典型学校背包负荷的反应。
Study design. This study is a repeated measures design to measure the lumbar spine response to typical school backpack loads in healthy children.
介绍了卷径计算、线速度测量、张力控制、同轴串联双电机控制、上下辊负荷平衡控制方法。
The paper introduces some methods for diameter compute, velocity measurement, tension control, the same shaft series twice motors control and load balance control of twin drive roll.
主要观察指标：测量神经断裂时的最大负荷、功耗，并描绘出神经应力—应变曲线。
MAIN OUTCOME MEASURES: the peak load and the power consumption were measured when the nerves ruptured and the nerve stress strain curve was described.
运用热沉能够有效地减小由引线导热引起的温度计的热负荷，提高温度测量的精确度。
Utilizing heat sink is effective to reduce the thermometer heat load due to the thermal conductor of the leads, and to increase the accuracy of the temperature measurement.
以YZ 4105柴油机热负荷为研究对象，利用热电偶测温技术，测量了不同工况下YZ 4105柴油机机体和冷却水的温度。
The thermal load of YZ4105 diesel engine was investigated, and the temperature fields of YZ4105 diesel engine cylinder block and cooling water were measured by using of the thermocouples.
本文通过测量气缸盖温度，找出气缸盖与气门间的“鼻梁”区域的最大热负荷处。
Through temperature measurement it is found that max. thermal load is in the bridge zone between valve seats of the cylinder head.
通过实例计算介绍了负荷率的测量和计算方法。
Through example, we introduced measure and calculate method of load rate.
原因之一就是至今还没有一种实用、准确的方法对磨煤机内的存煤量(磨负荷)进行测量。
One of the reasons is that there is still not a practical and accurate method to measure the coal storage (or mill load) of the mill.
呼叫接纳控制(CAC)是CD MA蜂窝系统无线资源管理的重要功能实体，它建立在对各小区负荷的测量基础之上。
As one of the most important function entity of RRM (Radio Resource Management) in CDMA system, CAC (Call Admission Control) is based on the measurement of burden on a cell.
呼叫接纳控制(CAC)是CD MA蜂窝系统无线资源管理的重要功能实体同，它建立在对各小区负荷的测量基础之上。
As one of the most important function entity of RRM (Radio Resource Management) in CDMA system, CAC (Call Admission Control) is based on the measure of burden on a cell.
还能测量一些可以称之为‘负荷’的数据——指的是球员跑动时脚着地的时间量。
It also measures something called 'the load' - and this is literally the amount of time a player's foot is on the ground while he is running.
材料力学应变测量实验中，试件在小负荷作用下所产生的应变信号十分微弱。
In the strain-data measured experiments of material of mechanics, the bar generates weak strain signal by the less force functioning on the bar.
该系统采取微流和汇聚流监测相结合，主动测量和被动测量相结合的策略，有效地降低了监测系统的负荷。
It employs a policy of combining micro-flows monitoring and aggregated flows monitoring, and associating active measurement with passive measurement to reduce the system load.
基于激光线扫描和力传感器原理设计了可以同时测量足部负荷和三维形貌的扫描仪。
A foot scanner was developed using laser-line scanning with mechanical sensors to simultaneously measure foot loads and 3-d foot shapes.
对于较小的负荷变化率，压力计算值与测量值偏差小于3%，而较大的负荷变化率时，偏差有增大趋势，但其误差小于5%。
The comparison result of computation value and measure value shows that their deviation is within 3% for low load ratio, and has increasing tendency for high load ratio, but it is within 5%.
本发明测量精度高，为电力用户和供电公司全面准确的测量电力负荷的用电功率提供了一个行之有效的方法。
The invention has high measuring accuracy and provides an effective method for power consumers and power supply companies to measure power consumption of electric loads comprehensively and accurately.
本发明测量精度高，为电力用户和供电公司全面准确的测量电力负荷的用电功率提供了一个行之有效的方法。
The invention has high measuring accuracy and provides an effective method for power consumers and power supply companies to measure power consumption of electric loads comprehensively and accurately.
应用推荐