零相位误差法具有经济适用、便于实现的优点。
The zero mean phase error method is (economical) and easy to realize.
尝试和误差法表明，最好在环氧化之前引进酰胺基。
Trial and error revealed that it was best to put in the amide before the epoxide.
输出误差法是飞行器气动参数辨识最广泛采用的一种方法。
The controller output error method (COEM) is used to design the adaptive fuzzy controller.
输出误差法是飞行器气动参数辨识最广泛采用的一种方法。
Output error method is one of the most widely applied methods in the region of aerodynamic parameter identification for aircraft.
推导了用最小平均误差法获得最佳配齿及误差的计算公式。
Calculating formula has been inferred. We minimum average error method to attain best gear distributed rate and to calculate minimum error.
本文提出了可进行条纹非均匀性校正的最小均方误差法(MMSE)。
We develop the minimum mean square error (MMSE) method for stripe nonuniformity correction (NUC).
分别讨论输出误差法(OEM)和方程误差法(EEM)在设计自适应滤波器的应用。
Output error method (OEM) and equation error method (EEM) was desired for adaptive IIR filter design.
大系统的模型最优简化的积分平方误差法，至今仅仅对输入函数为脉冲、幂函数和正弦函数时有效。
For optimal model - reduction of large scale systems, up to now, the integral-square - error method has been developed for systems with impulse, power or sine function inputs only.
本文首先采用定时调度的方式判断起动状态，并采用最小均方误差法(LMS)逐步修正起动扭矩。
In this paper the start station was judged by the time scheduling approach. LMS method was used to amend the starting torque.
通过误差平方和的比较，确定利用基于输出误差（OE）模型的预报误差法所建立的模型的精度最高。
Through comparing their sums of squared error, it was concluded that prediction error algorithm-based OE model has the best precision.
MinkowskiMethod算法，预报误差法参数辨识-松弛的思想，借鉴了主成分分析算法(PCA)。
MinkowskiMethod algorithm, Prediction Error Method for Parameter Identification - the idea of relaxation, it draws on principal component analysis algorithm (PCA).
基于导频的信道估计方法已经受到广泛的研究，主要估计算法有最小二乘法(LS)、最小均方误差法(MMSE)和最大似然(ML)估计法等。
The channel estimation method based on pilots has received much research. It adopts the algorithms such as least squares (LS), minimum mean square error (MMSE), maximum likelihood (ML), and so on.
很多研究员都指责案例对照法不是展现因果关系直接有力的方法，尤其因为它受制于大量的记忆误差。
Many researchers fault case-control work as being a weak method for showing direct causality, especially because it is subject to substantial recall bias.
建立头图法的误差是固定的。
同时进一步提出对称校正的方法以解决逐点成像法固有的误差累积。
Meanwhile, we put forward symmetric correction to resolve inherent error cumulation of point-by-point imaging modality.
本文分析了用半偏法测电流计内阻时误差产生的可能原因，并提出改进措施。
We analyze the error reasons of inferring inside block of amperemeter in the middle divisor as well as bring forward betterment measure.
用高斯-牛顿误差最小法将六维观测量转化为四元数，作为观测量的一部分，显著减少了直接使用EKF的计算量。
Gauss-Newton error minimization is used to transform six-dimentional reference vector to quaternion as a part of observations for EKF, which significantly reduces the computational requirement.
本文介绍了用阴影云纹法测量爆炸载荷下铝板变形的方法及结果，并进行了误差讨论和静态标定。
A shadow moire method and its results for measurement of distortion of aluminium plate at exploding charge is presented. Possible errors are also estimated.
与原子吸收法比较，相对误差小于5%。
Compare this method with AAS, its relatively error were less than 5%.
并对系统最大误差位置进行误差参数灵敏度分析。用蒙特卡洛法进行精度综合。
The sensitivities of error parameters were analyzed at the maximum error position, and accuracy synthesis was conducted by using Monte Carlo method.
最小区域法是符合最小条件的一种直线度误差评定方法，但较难实现。
The minimum zone method meets the minimum condition for evaluating the straightness, however it is difficult to accomplish computerization.
此方法比凝固点低压法易发生更大的实验误差。
The method is subject to greater experimental errors than the freezing-point-depression method .
预测结果与误差分析表明，自适应滤波法用于江河洪水预测是可行的。
The predictive results and error analysis show that the method is feasible for stream flood prediction.
提出了一种计算机控制的机床主轴回转误差的数字测量法。
A digital measurement method for machine spindle rotary error with supper computer was presented.
本文介绍了直线度误差最小评定的0.618法和凸多边形法，并给出了这两种方法的高级语言程序。
The 0.618 method and the convex polygon method for minimum condition evaluation of straightness error are introduced, and their high-level language programs are given in this paper.
本文将最小误差激励(mee)法推广应用于多机电力系统分散输出反馈控制器的设计。
This paper proposes the application of extended minimum error excitation (MEE) method to designing decentralized output feedback controllers for multi-machine power systems.
一维最小误差阈值法假设了目标和背景的灰度分布服从混合正态分布。
One-dimensional minimum error thresholding method assumed that the histogram distributions of object and background are governed by a mixture Gaussian distribution.
由计算结果的分析比较可知，扩充混合型法比一般的输出误差型法更为通用。
It has been proved that satisfactory results can be easily obtained by using this process than the general output error method.
在识别算法中采用字长阈值法、滑动模板法和误差双阈值法来减小环境噪声的影响。
Threshold of word length, sliding template, and double threshold of error are applied to minimize influence of environmental noise.
提出了多位法误差分离技术读数方程，可统一现行的多步法和多点法。
The measurement equation for multi position error separation technique is put forward, and the equation is universal for all the current multi step and multi point methods.
应用推荐