通过实际动态试验表明，利用本文提出的方法可有效地对组合系统进行较好的滤波与校正，定位精度较高。
The practical dynamic experimental results show that this method can make better filtering and calibration to the integration system, and the positioning precision is high.
为研究岩石在中等应变速率下的动态加载或动静组合加载的破坏特性及本构关系提供了一种可行的试验方法。
This provides a feasible testing method for studying the behavior and constitutive relation of rock failure with medium stain rate under dynamical loading or static and dynamical combination loading.
本文通过试验与工程实践，介绍采用碎（砂）石桩及低强度混凝土桩组合构成复合地基的试验成果、计算方法及应用检测成果。
This paper introduces the test results and calculative method by using the composite foundation of sand-stone pile and concrete pile with low strength.
最后利用计算机规划求解分析方法，对模型进行优化计算，得出秧苗直立度最大时的最佳参数组合，并通过实际试验进行了验证。
With optimizing calculation method the optimum combination of the parameters for maximum upright degree of seedlings was obtained, and the result was verified with real experiment.
为了验证方法和程序的正确性，论文中对M6机翼和F4翼身组合体的流场进行了数值模拟，并与试验结果进行了对比。
The viscous flow around M6 wing and F4 wing-body configuration are simulated and compared with the results of wind tunnel experiment.
对墙梁中托梁与墙中的“组合作用”进行了论述，并对国家现行规范中的计算方法提出探讨和建议，同时介绍了配筋混凝土空心砌块砌筑墙梁的初步试验结果。
This article deals with the composite action between bressummer and wall on it in wall beam, and puts forward discussion and proposal to the calculation method in current national code.
通过试验确定了较佳的色谱分析条件组合值，所确立的方法具有较好的准确性和重复性。
The better combining number of chromatographic analysis condition was defined from test. The method being established in this paper possessed better accuracy and repetition.
最后，根据试验研究结果进行简化，提出组合板承载力和变形的实用设计方法，可供工程技术人员参考使用。
Finally, by simplifying the result of experiment, a practical design method about bearing capacity and deformation is got and can used by engineers.
通过试验对比发现，在不同混合料和不同试验方案组合下，两种试验方法的抗剪强度结果具有较好的相关性。
It is revealed that the test results of different test methods are in good correlation with the variations of mixtures and test schemes.
试验结果验证了该组合导航方法是有效、可行的，适于在线实时应用，能融合其它导航传感器信息，具有较强可扩展性。
Experiment results prove the method is feasible and effective. It can be used on line and combined with other navigation sensors information with strong expandability.
所应用的方法对于其他组合件型式的模型试验特别是光弹性冻结试验同样是适用的。
The method applied is also suitable for model test of other types of assembly especially for the freezing test in photoelasticity.
介绍了双向组合楼盖的有限元分析方法、试验、施工、节点构造以及现场实测挠度结果。
The finite element analysis method, the test, the construction, the joint connection and the actual deflection dat.
采用分别粉磨再混合的方式，利用正交试验方法，研究了熟料、矿渣及粉煤灰的不同细度组合对复合硅酸盐水泥物理性能的影响。
The properties of the composite cement were studied by orthogonal test, which was prepared by the clinker, slag and fly ash with different fineness and mixed after separately grinding.
内容主要说明：正交设计是多因素试验设计的一种方法，注重科学合理地安排试验，寻找最佳因素水平组合。
The orthogonal design is many factors a method of experimental design, should pay attention to scientific arranging the test, to search for the optimal combination of factors level.
应用模糊数学中的模糊综合评价方法对广东省1999 - 2001年春植玉米区域试验新组合进行定量化评价。
The fuzzy comprehensive evaluation method was applied to the quantitative evaluation of the maize new cross combinations from 1999 to 2001 in Guangdong province.
应用灰色关联度分析方法综合评价了宁夏扬黄灌区玉米品比试验的15个参试组合。
The grey relational degree analysis has been used to evaluate the 15 tested maize combinations in Yanghuang irrigation area of Ningxia province.
通过均匀设计安排橡胶配方试验，进而用数据处理组合方法(GMDH)建立高精度的回归模型。
A high precise regression model of rubber formulation was built with the uniform design and GMDH (group method of data handling) method.
在无风或微风条件下，可通过室外组合喷洒试验或依据单喷头试验资料用计算方法求得。
Under windless condition or in gentle breeze, it can be calculated either through outside compound sprinkler tests or with experimental data from single sprinkler test.
通过对悬臂板，叶片轮盘组合体模型所作的试验说明了这种方法的优越性。
It is shown in the tests that this method has many advantages when it is applied to a cantilever plate and a blade-disc assembly model.
根据计算结果，通过正交试验获取较佳的条件组合，提出了测定水泥活性组分的酸溶解测定方法。
Another acid insoluble residue testing method, based on orthogonal experience, was used to determine the content of active component.
仿形喷雾试验按照不同的喷雾参数组合采用正交试验的方法进行。
The orthogonal experiments were conducted for the profile modeling spray with different spray parameters combination.
利用二次回归的中心组合设计方法进行试验设计和数据优化。
The experiment design and calibration data are dealt with the central composite design, which is a statistical method.
与国内外的连续组合板试验结果的对比表明，提出的计算方法能够较为准确地计算连续组合板的极限承载力。
Comparisons between experimental results and theoretical results show that the proposed method is accurate for calculating the ultimate capacity of continuous composite slab.
计算和试验表明，利用组合结构的有限元方法可以作为结构设计的有效判据。
It is verified by the test that FEM based on assembled structures could be the effective reference to the structure design.
通过带混凝土筒组合墙、开洞组合墙等模型试验，得出组合墙的开裂、极限承载力的计算公式和混凝土筒—组合墙承载力及刚度计算方法。
Through model testing of the building, it has obtained cracks, rigidity, and ultimate bearing capacities, as well as the calculation methods and formulas of the structural system.
采用“3414”试验方法研究了油菜在不同氮、磷、钾肥施用量组合下，油菜产量与施肥的关系，应用回归效应方程寻找最优施肥量组合。
The relationship between yield and fertilizer application was studied by means of "3414" method under different amounts of N, P and K applied .
在防雨棚盆栽试验条件下，以“A115”、“4185”为材料，用干湿交替方法研究了3种水分组合下小麦的水分利用效率与生物学性状的相关关系。
Correlative analysis among water use efficiency and others traits of wheat varieties A115 and 4185 was studied by pot cultivation under rainproof shelter with 3 alternate drying-wetting treatments.
根据二次回归正交组合方法与油气藏射孔完井有限元模型进行了数值模拟试验的设计与计算。
According to the secondary regression in quadrature combined method, the design and computation of finite element numeric simulation were done.
方法：采用4因子3水平正交组合试验与单因素试验进行研究。
Method: The effects of n, p, K and sowing norm were studied by means of 4 factors and 3 levels orthogonal design experiments.
方法：采用4因子3水平正交组合试验与单因素试验进行研究。
Method: The effects of n, p, K and sowing norm were studied by means of 4 factors and 3 levels orthogonal design experiments.
应用推荐