在统计分析的基础上，给出确定设计许用值的方法。
On the basis of statistical analysis, a method of determining the allowable design values is proposed.
由于复合材料的引入，应该用“设计值”和“许用值”来代替“设计许用值”。
In this paper the authors proposed that the term of "design allowables" should be replaced by "design values" and "allowables" as composites were used in aircraft structures.
在刷镀过程中，镀液温度实时显示在计算机的虚拟面板上，当镀液温度超出许用值时仪器报警。
The solution temperature was displayed on the virtual panel during the brush plating process, and it would be alarmed as the temperature exceeded the permitted value.
讨论了设计值与许用值的关系，并指出复合材料结构压缩设计值主要取决于冲击损伤容限许用值。
The relationship between design values and allowables was discussed. The determination of compressive design values for composite structures was based mainly on impact damage tolerance allowables.
主梁下挠变形的主要原因是受热引起的最大复合应力超过许用值，达到了屈服极限值，强度不满足要求。
The main reason of the main beam down deflection was that the most complex stress exceeded the admissible value and achieved the yield limit value.
从而克服了由于复合材料性能分散性大，用现行方法确定其许用值所需试件个数多、试验经费昂贵的缺点。
Thus, it has overcome the disadvantages of traditional methods caused by the large scatter of the composite materials, such as a great number of specimens and expensive test.
针对这一问题，本文研究了零件加工误差对动模板合模位置的影响，得出了零件加工误差的许用值范围，并计算了由于销轴摩擦力对合模力放大比的影响关系式。
Aiming at these problems, this paper studies how the original error affects the accuracy, works out its allowable values, and finds out the equation between friction of pins and clamping force.
设计要求、强度设计值可转换为许用应力设计值。
Strength Design values may be converted to Allowable Stress Design values.
而管道许用应力是在确定了管道材料的基本许用应力后，乘以质量系数所得的值。
The allowable stress is the value of the determined basic allowable stress of the piping material multiplied by a quality factor.
对不同算法得到不同结果的原因进行探讨，提出算法和许用应力值的取用建议。
The reason of different results from different formulae is discussed, and adoption for the suitable formula and allowance stress is suggested in the paper.
对不同算法得到不同结果的原因进行探讨，提出算法和许用应力值的取用建议。
The reason of different results from different formulae is discussed, and adoption for the suitable formula and allowance stress is suggested in the paper.
应用推荐