接着利用概述中给出的公式计算电压系数。
The voltage coefficient for the resistor is then calculated using the equation given in the overview.
提出了一种用连续潮流技术识别和计算电压崩溃临界点的方法。
An identification and computation method of static voltage stability critical point by using the continuation method is presented.
为了满足实时检测要求，研究了计算电压、电流有效值和功率因数的快速演算法。
In order to satisfy the real - time measurement, we studied the fast arithmetic of virtual value of voltage and current, power factor.
整个迭代程序，直到变电所的计算电压与指定电压的差值，小于某一指定值才停止。
The procedure stops after the mismatch of the calculated and the specified voltages at the substation is less than the predefined convergence tolerance.
确定心电图导联的最小子集，从该最小子集，可以利用可接受的误差计算电压-时间测量。
A minimal subset of electrocardiogram leads is identified from which the voltage-time measurements can be calculated with acceptable error.
提出了一种简单的电压空间矢量算法，该算法根据参考电压矢量直接计算电压空间矢量的位置和作用时间，简化了运算过程。
A simplified algorithm is proposed in this paper, which directly calculates the duty cycles of space voltage vector tracking the reference voltage vector.
本文在数字信号处理理论的基础上，通过对电压和电流信号特性的分析，研究了一种新的计算电压和电流有效值的体系结构。
On the basis of the digital signal processing theory and the characters of voltage and current, the system structure of a kind of new voltage (current) RMS calculator is proposed.
它充分利用DSP芯片运算速度快和专用指令的优点以及MATLAB强大的数值分析、计算、信号处理及图形显示功能等来计算电压闪变值。
It full USES of DSP chips for high speed and the advantages of command and MATLAB powerful numerical analysis, signal processing and graphics capabilities to calculate voltage flicker value.
只需记录输出电压并执行一些简单的计算，就能找到以摄氏度或华氏度为单位的温度。
Record the output voltage and perform some simple arithmetic to find the temperature in degrees Celsius or Fahrenheit according to preference.
这种电压过高或过低可能是一个相当普遍的现象，取决于与计算机公用同一电路的设备数量和类型。
Depending on the same circuit with the common computer the number and type of equipment, this may be a very common phenomenon.
他们的想法是不像在传统计算中那样使用电压高低来代表0和1，而是使用噪音的有无。
Their idea is to represent the 0s and 1s of digital signals not using voltage levels as in conventional computers, but using the presence or absence of noise.
如果用Stokes定理计算的话，电场对一条封闭曲线做的功，比如说，电厂中有一个金属线圈，想要知道金属线圈的电压是多少。
If we apply Stokes' theorem to compute the work done by the electric field around a closed curve, that means you have a wire in there and you want to find the voltage along the wire.
它使用的是12伏的电压，这个电压也是在普通的计算机中通过电源提供的电压。
It USES 12 volts, which is a voltage also provided inside an ordinary computer case via the power supply.
起初，在一个房间里的上百台计算机，就好像上百伏电压一次穿过墙上的电线一样，看起来有点咄咄逼人。
Hundreds of computers in a room could seem intimidating at first, just as hundreds of volts coursing through wires in the walls did at one time.
打开计算机或正在使用计算机的时候，都可能有很小的电源电压波动。
It could be that there was a minor power fluctuation when you turn your computer on or while you were using the computer.
用了相对论的计算方法，电池电压预计可以达到2.13伏，能与实测值2.11伏很好地符合。
With them, they predict 2.13 volts, in good agreement with the measured 2.11 volts.
为了计算增益和跨导，指的是部分意义上的固定电压引脚。
To calculate gain and transconductance, refer to the SENSE pin on fixed voltage parts.
然后仪表通过同一套测试引线来测量电阻两端的电压，并计算出相应的电阻数值。
The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly.
有些静电计和皮安计具有内置的电压源，能够自动地计算出未知电阻。
Some electrometers and picoammeters have voltage sources built into the instrument and automatically can calculate the unknown resistance.
注意，用这种方法计算电阻时，完全抵消了热电动势电压(VEMF)。
Note that the thermoelectric voltage (VEMF) is completely canceled out by this method of resistance calculation.
文中导出了计算直流电机换向器片间电压分布曲线的基本公式和试验验证；
Basic formulas for the calculation of bar to bar voltage distributing curve of DC motor commutator are derived and test-verified.
本文阐述了用取样技术测量矢量电压的基本原理，推导了计算公式。
This paper expounds the fundamental principles of vector voltage measurement using a sampling method, and deduces the calculating formula.
负载电流的计算应该根据工作电压和负载的功率计算。
The load current is calculated from the supply voltage and the load power.
普通的计算机以比特(二进制)存储和处理信息，它取值1和0(对应物理中电压高低的状态)。
An ordinary computer stores and processes information using bits, which take the value of either one or zero (physically represented by different voltages of electric current).
同时给出了其牵引绕组电压、电流等系统主要参数的计算。
The system interface parameters calculation, such as input voltage and cur-rent for traction windings is also presented.
单个电池电压的当前值是与一个已知的参考标准进行比对，从一系列测得的电压差中计算出来的。
The voltage of the individual cell is determined by calculating the present value, based on a series of measured cell differences, from an accepted reference.
该测试在两个不同的电压之下进行电阻测量，然后计算出电压系数。
This test makes resistance measurements at two different voltage levels, then calculates the voltage coefficient.
以音乐信号瞬间能达到的峰值电压来计算的输出功率，其商业意义大于实际作用。
With the music signal in a moment can the worth electric voltage of attaining come the over and above and actual function of meaning of calculating exportation power, its business.
这种方法不需要硬件同步电路，能实时地计算电源电压中的基波正序分量。
The proposed method doesn't need hardware synchronization circuit and can perform the calculation of fundamental positive sequence component of the supply voltage in real time.
计算任何两个功率，电压，安培。
应用推荐