介绍一种低功耗实时脉冲计数电路。
Recommend a real-time pulse counts circuit with low consumption.
限位开关同时连接在计数电路上。
The limit switch is also connected with the scaling circuit.
设计了光电编码器用可编程计数电路。
A programmable count circuit for photoelectric encoder is designed.
介绍《瞬断仪》的基本工作原理，具体分析10 0计数电路。
This paper introduces the basic working principle, and analyzes the 100 count circuit.
最后用计算机模拟程序检验绝热触发器和可变计数电路的结果。
Finally, Computer simulation has shown that above flip-flop and adiabatic variable counter are stable with lower power consumption.
介绍了一种高精度旋转编码器单片机计数电路、该电路包括方向识别电路、双向计数电路及单片机系统。
A high precise counter circuit for rotary encoder based on single chip microprocessor is presented in this paper.
详细叙述了测量电路的硬件设计，主要包括方向识别电路与计数电路的CPLD实现，以及部分程序的设计。
Mainly introduced hardware design of the measuring circuit. It included used CPLD to implement the direction circuit and count circuit.
硬件部分以P89C61X2BA为控制核心，包括采用USBN9604接口芯片的USB接口电路，光栅尺输出信号处理电路，以XC95108为主的信号细分、辨向和计数电路等。
The hardware of the system is made up of P89C61X2BA as main processor, USBN9604 as USB interface, grating signal-processing circuit, XC95108 as signal subdivision, sensing, counter circuit and so on.
我那时已经把电视上的计时电路做到最小了，只要再用横向和纵向的计数器去驱动存储着字符的内存就可以了。
I already had the TV timing circuits minimized and just had to use the horizontal and vertical counters to drive some memory with the characters stored.
当主控门打开时，经过转换的输入信号脉冲通过它进入计数寄存器，并在此统计，然后通过显示电路输出。
While the main gate is open, the conditioned input signal pulses are passed through to the counting register, where they are tallied and then scaled for output by the display circuitry.
在设计数字电路时，设计者往往一开始就真值表描述电路所应该做的。
In designing digital circuits, the designer often begins with a truth table describing what the circuit should do.
并将脉冲宽度信号送至SD-M - 3002专用电路完成计数、译码、脉冲分配等控制。
And pulse width signal is sent to SD-M-3002 special circuit, to complete such controls as counting, decoding, pulse distribution, etc.
设计的信号模拟电路精确模拟了光纤陀螺输出信号的波形，给计数卡提供了准确的输入测试信号。
The designed signal simulation circuit can precisely simulate the output signal waveform of fiber-optic gyro, offer accurate input signal to counter card.
应用振弦式传感器并基于脉冲计数法进行压力测量可达测量精度受脉冲计数精度、电路噪声及温度补偿等多重因素影响。
When using pulse counting method, the precision of pressure-measuring with vibrating-wire sensor is influenced by the precision of pulse counter, circuit noise, temperature compensation, etc.
提出了计数接口电路的硬件和软件设计方法，并进行了电路调试。
The hardware and software design methods of the counter interface circuit were put forward. And the circuit debugging has been carried on.
本文介绍了用PTC8253 - 5实现啤酒自动包装计数定时的设计，给出的硬件电路和软件程序。
This paper introduces the design of counting and timing device for automated beer packing with PTC8253-5. The hardware circuit and software are given.
最后，就这两种计数器在电路结构和经济性能方面进行了分析比较，论证了二—N进制计数器的优点。
Finally an analytic comparison is made between those two kinds of counters in both their circuit structure and economic property, and hence the advantages of the binary-N carry counter are proved.
本文介绍了用PTC8253-5实现机加零件自动包装计数定时的设计，给出了硬件电路和软件程序。
This paper introduces the design of counting and timing device for automated machine-made spares packing with PTC8253-5. The hardware circuit and software are given.
分析了一个异步十进制加法计数器实验电路的错误，介绍了异步十进制加法计数器典型电路。
This paper analysis the errors of experimental circuit on a asynchronous decimal carry counter, introduces a typical circuit on a asynchronous decimal carry counter.
频率计由时间闸门电路和计数器组成。
本文介绍一种按规则序列设计的移位型计数器。此类计数器设计方便，电路简单，译码电路简单，并具有快速自启动特性。
In this paper, it introduces one kind of shift counters designed with regular sequences. These counters have many advantages: easy to design, simple circuit, simple decode and self starting.
介绍一种以大规模集成电路为核心组成的通用计数器的设计。
The design of an universal electronic counter which mainly consists of LSICis introduced.
文中介绍了移位型计数器中反馈逻辑电路设计的基本思路，举例说明了移位型计数器实现的基本方法。
The article introduces the basic design idea of feedback logic circuit for shift counter and illustrates the basic method of shift counter realization.
本文研究了计数式光纤陀螺输出信号模拟的方法、电路设计及计数卡的具体实现电路和软件编程方法。
This paper presents the simulation method and the circuit design of output signal for counting type fiber-optic gyro, and the realization circuit and software programming method of counter card.
另外，还介绍了该计数器在一种平板显示器驱动电路中是如何通过脉宽调制实现灰度显示的。
In addition, how to use this counter to realize Gray Display by PWM in Driving Circuit of Flat Panel Display has been discussed.
数据采集系统触发电路、随机采样短时间产生电路、存储器地址计数器电路等相关控制电路的设计、仿真和调试；
The circuits revelent to data acquisition system such as trigger circuit, the circuit of short time generator in random sampling etc, are designed, simulated and adjusted.
在探测器电路中采用猝灭电路，延长了G-M计数管的使用寿命。
The quenching circuit in the detector lengthens the using lifespan of G M counter.
可变模计数器作为一种基本数字电路模块，在各种数字系统中应用广泛。
As a basic digital circuit module module-alterable counter has an abroad application in various digital systems.
可变模计数器作为一种基本数字电路模块，在各种数字系统中应用广泛。
As a basic digital circuit module module-alterable counter has an abroad application in various digital systems.
应用推荐