• 黑色鬃毛,喉部有下悬肉垂,角盘螺旋

    They have a short, dark mane, a dewlap hanging from the throat, and long horns twisted in a tight spiral.

    youdao

  • 他的桌子上放着一热蛋糕和一大杯冰牛奶。

    There, on the corner of his desk, was a plate of warm cakes and a tall glass of cold milk.

    youdao

  • 著名的实验室鹦鹉alex可以物体看,从中衔那个形的蓝色物体。

    Her best-known parrot, Alex, can stare at a tray of objects and pick the one that has four corners and is blue.

    youdao

  • LaChoucrouterie小酒馆剧院里,同时弄着几泡菜面条厨师仅仅冰山一

    Chefs juggling plates of steaming sauerkraut with noodles are just the tip of the iceberg at La Choucrouterie bistro and playhouse.

    youdao

  • 时,连接处记号,以便安装记号装复。

    Pick in the demolition of triangular plate , the junction should be a mark for installation by sign refitted.

    youdao

  • 若使用一条方法,可以几个装满在调色压住照片的四以防止照片浮上药液

    Place small bottles filled with water on each corner of the print to hold it below the surface of the solution and leave it overnight.

    youdao

  • 我们矩形正方形另有三还有椭圆

    We have rectangular plates, square plates, triangular plates and oval plates.

    youdao

  • 传动系传动比,则转向灵敏- - - - - -当车轮转过一定度时,不必转向很大度- - - - - -正是赛车所需要的。

    The lower ratio gives the steering a quicker response — you don't have to turn the steering wheel as much to get the wheels to turn a given distance — which is a desirable trait in sports cars.

    youdao

  • 本文提出了齿优化设计方法最优最后一次刃磨时的最小啮合对应条件;刀具寿命期间,保证进入双齿啮合剃齿。

    This paper proposes an optimization method on the plate shaving cutter, its optimal solution is the premises matching the smallest toothing Angle on the condition of the last cutting grinding.

    youdao

  • 分析摆动从动件凸轮机构压力基本尺寸之间的关系

    The relationship of cam with oscillating followers pressure angle and radius of basic circle were analyzed.

    youdao

  • 本文摆动从动凸轮机构最大压力最小曲率半径问题进行详细的讨论。

    In this paper, the pressure Angle and minimal radius of curvature of CAM mechanism with swinging roller follower are discussed in details.

    youdao

  • 在满足机构许用压力条件下,采用0.618最优确定摆动凸轮机械最小圆半径

    Meeting requirement of the mechanical pressure angle, the minimum base radius of a plate cam for oscillating follower is determined by the 0.618 optimization method.

    youdao

  • 如果眉笔使得眉毛显得过沉重就用一个带有调色来画眉。

    If a pencil is making the brows a little too severe, opt for a waxy palette with a small angle-tip brush.

    youdao

  • 使用定义图形

    I do not use the angles of the chart in defining the pattern.

    youdao

  • 刻度单独装有晶体管的伺服系统驱动指针由自整机驱动。

    Compass card is individually driven by a transistorized servo system and Pointers driven by synchros.

    youdao

  • 水牛弯弯两个弯弯一个牛背多神气哟,就方向哟。

    Old water buffalo, Angle curved, a two curved yo circle, I ride Niu Beiduo to be spirited, likely is grasping the steering wheel.

    youdao

  • 传动比意味着,对于给定车轮转向转过的更大

    A higher ratio means that you have to turn the steering wheel more to get the wheels to turn a given distance.

    youdao

  • 平衡转动一周在转时,局部出现轴向间隙最大间隙最小间隙。

    Disk rotation balance week, will go to a certain point of view, the local emergence of the greatest axial clearance or minimum clearance space.

    youdao

  • 本文通过实测配流副间的厚度,分别考察了转速压力变化对油膜厚度影响

    The effect of rotational speed, pressure and swashplate swinging angle on oil film thickness is analyzed.

    youdao

  • 饼凉至室温时盛放,撒上欧,将小三方形再食用。

    Transfer the tortilla to a plate, sprinkle with parsley and serve cut into triangles or squares.

    youdao

  • 利用单个即可指示断层位移方向断层面状。

    The individual breccia can be used to indicate the direction of displacement of fault walls and the mode of occurrence of the fault surface.

    youdao

  • MATLAB辅助工具,给出了直动推杆凸轮机构推杆实现规律的基本运动时基本尺寸优化设计方法使凸轮机构的体积最大压力达到最小

    A method for optimizing the main dimensions of a cam-oscillating follower mechanism in common follower motions is presented with the MATLAB, which maximizes the CAM volume and maximum pressure angles.

    youdao

  • 给出不同槽位置气垫压力计算公式气垫压力的理论分布曲线

    To give the expressions of air-cushion pressure and make the graph of it, the experimentally studying method is introduced.

    youdao

  • 分析摆动从动凸轮机构压力基本尺寸之间的关系

    The relationship of CAM with oscillating follower's pressure Angle and Basic dimensions were analyzed.

    youdao

  • 本文讨论自动折叠纸盒折叠及体板高度数学问题,该类包装纸盒CAD开发建立了有效的数学模型

    This article is mainly discuss folding Angle, crease line, body-board's height of auto-bend tray-type carton, which supplies mathematic model for the development of carton package CAD.

    youdao

  • 目的比较寄生于家小肠瑞利绦虫瑞利绦虫形态特征发育过程。

    Objective To compare the morphological features and the development of Raillietina echinobothrida and R. tetragona from chicken.

    youdao

  • 造粒采用整体圆弧结构可以93%以上。

    The disc of the plate disc adopt overall circular structure, the granulation rate may reach above 93%.

    youdao

  • 造粒采用整体圆弧结构可以93%以上。

    The disc of the plate disc adopt overall circular structure, the granulation rate may reach above 93%.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定