角度公差在0.8度以内，根据规定的旋转。
Angular tolerance should be within 0.8 degree of the rotation specified.
本文从配合公差选用角度来探讨其对可靠性的影响。
This paper discusses the influence of fit tolerance selection on reliability of internal combustion engine.
从产品性能公差设计的角度探讨分形公差理论的建模、分析、设计等有关方法，着重研究分形维数的计算理论和工程方法。
Some methods about fractal based tolerancing are discussed in this paper. The engineering calculation on profile fractal dimension is presented in detail.
从产品性能公差设计的角度探讨分形公差理论的建模、分析、设计等有关方法，着重研究分形维数的计算理论和工程方法。
Some methods about fractal based tolerancing are discussed in this paper. The engineering calculation on profile fractal dimension is presented in detail.
应用推荐