冷却器的排气应由端盖上的排泄螺塞孔进行。
介绍了油孔螺塞拼接式热锻模具的设计及其应用效果。
Finally the design and application achievement of this hot forging die are described.
长期停止使用时，应打开放水螺塞，将泵内的剩水排尽。
Release discharge bolt to discharge the retained water if the pump will not be used for long.
泵的轴封采用机械密封，泵体顶部和底部分别装有注水、放泄的螺塞。
Pump shaft seals use mechanical seal, pump top and bottom, respectively, equipped with water injection plug and the drain plug.
本实用新型具有防盗、使用方便、可靠、成本低等优点，能取代现有的油箱排污螺塞。
The utility model has the advantages of theft prevention, convenient use, reliability and low cost, and can replace the dirt removing plug screw of the exiting oil tank.
第四代螺纹技术——螺塞反角螺纹设计，更易于安装，对棒抱紧力更强，进一步减少钉头体积。
Generation 4 Clousure Technology—A reverse-angle set screw designed to thread easier, hold stronger, and reduce the implant even.
本文所论述的螺塞装配机床，用定扭矩电动扳手进行装配，大大降低了工人的劳动强度，保证了装配质量。
This assembly machine employs electric drive torque controlled wrench in assembly, thus the physical strength of workers is largely decreased and the assembly quality is assured.
当需要清洗时，旋开主管底部螺塞，排净流体，拆卸法兰盖，取出滤篮，清洗后重新装入即可，因此，使用维护极为方便。
When cleaning, unscrew the head bottom plug, drain fluid, remove the flange cover, remove the filter basket, cleaning and re load can, therefore, maintenance is extremely easy to use.
限位部的形状与相应的突出部的形 状相对应。本发明的防磨结构组件具有多块耐磨刚玉陶瓷块、金属衬板、防震垫、内侧 金属螺柱、金属螺帽和刚玉陶瓷塞。
The wear resistant corundum ceramic block includes integral main body, protuberant part, limiting part and connecting holes, and the limiting part has shape corresponding to the protuberant part.
限位部的形状与相应的突出部的形 状相对应。本发明的防磨结构组件具有多块耐磨刚玉陶瓷块、金属衬板、防震垫、内侧 金属螺柱、金属螺帽和刚玉陶瓷塞。
The wear resistant corundum ceramic block includes integral main body, protuberant part, limiting part and connecting holes, and the limiting part has shape corresponding to the protuberant part.
应用推荐