探索旋涂法制备工艺参数对薄膜结构的影响。
The influence of processing parameters in spin-coating was explored.
研究了衬底材质及表面粗糙度对薄膜结构的影响。
The effects of substrate material and surface roughness on it are studied.
薄膜结构的形态分析是薄膜结构设计中的一个重要环节。
Form analysis of membrane structures is an important component in design of membrane structures.
研究了衬底温度对薄膜结构、表面形貌以及介电性能的影响。
Investigated were the effects of substrate temperature on the structures and surface morphology, dielectric properties of films.
通过比较薄膜的结构，探讨了薄膜底电极对薄膜结构的影响。
The effect of the bottom electrodes on the structures of thin films is investigated by comparing the structures of thin films.
考察了热处理温度、掺银浓度等因素对薄膜结构及性能的影响。
The influence of different heat treatment temperature and amount of Ag on the structure and properties of thin film was investigated.
首先，利用扁壳的无矩理论得到了平坦薄膜结构的基本力学方程。
First, the fundamental equations of flat membrane structures are obtained by applying the non-moment theory of thin shallow shells.
文中揭示的薄膜结构静力性能规律，为膜结构设计提供了有益的帮助。
The mechanical property of membrane revealed in this paper as well as the practical engineering introduced would for sure do great help to future membrane structure design.
采用椭偏光谱法分析了薄膜的结构，并提出多层膜模型模拟薄膜结构。
The structure of the laser crystallized poly-Si thin film is analyzed by using spectroscopic ellipsometry.
根据薄膜结构的受力特点，建立了薄膜结构与空气耦合系统的运动方程。
According to the mechanical characteristic of membrane structures, coupling kinetic equation of the air-structures interaction is established.
通过薄膜在水中的温阻变化实验，研究了纯水对薄膜结构和电阻的影响。
The impact of water on the crystal structure and resistance of the film was investigated through the temperature-resistivity experiments of the film in distilled water.
介绍了模板剂法制备多孔氧化钛薄膜的机理、工艺及影响薄膜结构的因素。
In this paper, the mechanism, the technology preparing the titania porous films and the factors influencing the surface structure of films are introduced.
以非线性有限元法为基础，提出充气薄膜结构有限元分析的基本方程及解法。
On the basis of non linear finite element method, fundamental equation and solution of pneumatic membrane structure finite element analysis are put forward.
然而溅射工艺参数的选取以及沉积的薄膜结构和性能是人们主要关注的课题。
However, it is still a question how to determine sputtering process parameters, microstructure and properties of thin films.
系统地研究了溅射功率对沉积速率、薄膜结构、组织形貌及接触性能的影响。
The influences of the sputtering power on deposition rate, film structure, and contact performance of the film prepared on CdZnTe substrate have been investigated.
本文初步分析了薄膜结构与风环境的静力耦合作用对薄膜结构自振特性的影响。
There is an intense interaction between wind and fabric structures, which is a critical factor for the dynamic behavior of fabric structures.
改变氧化时间，可以改变氧化铝薄膜的厚度，进而调控不同区域薄膜结构色的变化。
The thicknesses of the alumina thin films can be adjusted by changing the oxidation time, and then the change of structural colors at different zones can be adjusted.
研究了前驱体浓度、PEG2000加入量及不同水浴温度对薄膜结构和性能的影响。
The effects of precursor concentration, PEG2000 content and water bath temperature on the characteristics of films were studied.
BCN薄膜的划痕深度与薄膜的结构密切相关，而摩擦系数受薄膜结构的影响不明显；
The scratch depth of BCN films were mainly depended on the component of bonding structures in the films, but the effect of bonding structures on the friction coefficient was not obvious.
介绍了利用非线性有限元法进行薄膜结构找形分析的相关理论和相应的有限元计算公式。
In this paper, the relative theory and its corresponding finite element calculation formula about the shape finding of membrane structure is introduced.
傅立叶变换红外光谱(FTIR)表明，所获得的薄膜结构一致，均为六角氮化硼薄膜。
Fourier transform infrared spectroscopy (FTIR) indicates that all of films have the same structure of hexagonal construction.
合金化作为一种常用的控制薄膜结构，改善薄膜性能的方法引起了越来越多的人的注意。
Much attention has been paid to the method of alloying, which could both control the microstructure and improve the properties of thin films.
本文对微电子固体薄膜结构，以及影响薄膜电阻导电性和稳定性的因素进行了研究和分析。
This paper study and analysis microelectronic solid film construction and factor that effect the film resistor conductivity and constantity.
薄膜应力和折射率的改变主要是由于Y2O3含量的改变使得薄膜结构发生了变化引起的。
Moreover, the variations of residual stress and the shifts of refractive index correspond to the evolution of structures induced by the addition of Y2O3.
采用各种分析手段研究了沉积温度和真空退火处理对薄膜结构、表面形貌及光电性能的影响。
The effects of substrate temperature and post deposition vacuum annealing on structural, electrical and optical properties of ZMO: ga thin films were investigated.
将制备出的薄膜分别在大气和氮气气氛下退火处理，研究了退火气氛对薄膜结构和性能的影响。
The influence of anneal atmosphere on structure and properties of films is investigated by annealing films respectively in air and nitrogen.
因此，研究纳米多层氧离子导体电解质薄膜结构、电学性能和稳定性已成为一个重要研究内容。
Therefore, the study of oxygen ion conductor electrolyte nanometer multilayer film structure, electrical properties and stability has become an important research.
值得注意的是，薄膜表面大小减少时，摩擦力程度增加，这是由于薄膜结构上的空穴所造成的。
It's remarkable that the degree of friction increases when the surface size decreases, as a result of holes being made in the structure of the film.
文中以五边形曲面薄膜结构为例，研究不同的矢跨比、膜材的弹性模量对结构变形和受力的影响。
This article mainly discussed the mechanical performance of membrane structure with different structural and mechanical parameters.
文中以五边形曲面薄膜结构为例，研究不同的矢跨比、膜材的弹性模量对结构变形和受力的影响。
This article mainly discussed the mechanical performance of membrane structure with different structural and mechanical parameters.
应用推荐