讨论了低成本开关电源式大功率蓄电池充电机的工作原理,并给出了实用的电路原理图。
This paper discussed the principle of a great power battery charger using low cost switch power converter, the practical circuits are presented.
由于通信的不可中断性,这些蓄电池实际上处于浮充状态,并不允许从电路中断开,所以对其进行测量必须是在线方式。
Due to an interruption of communication, these batteries are in the state of floating charge, and not allow disconnecting from the circuit.
本文介绍了一种新型蓄电池容量检测电路的硬件结构与原理。
The paper introduces the hardware construction and principle of the new detector circuit of the capacity of battery.
高端智能充电器充电指示及电路电量保护设计,确保蓄电池稳定耐用。
High-end intelligent battery charger directives and circuit protection design, ensure the battery stable and durable.
研制的玉米花粉电动采集器由变压器、整流滤波电路、轴流风机、蓄电池与采粉器组合而成。
Corn pollen electric collector consists of transformer, electric circuit of rectifier and filter, electric motor, battery and pollen trap.
通过对混合动力汽车充电电路的分析,引入了蓄电池等效内阻的概念。
The conception of storage battery equivalent resistance is introduced in this paper by analyzing the charge circuit in hybrid electric vehicle (HEV) system.
警示器包括太阳能电池,蓄电池,以及在环境低照度和晚间用以发光元件选控的电路器件。
The warning marker includes solar cells, storage batteries and electrical circuit apparatus for selectively illuminating the light elements during low ambient light and nighttime conditions.
它除了给机车上的蓄电池充电之外,还给机车提供稳定的110V辅助电源,为控制系统以及信号发生电路供电。
Besides the storage battery charging, it works as a stable 110v auxiliary power supply which provides electric energy to the control system and signal produced circuit.
重点介绍利用交流弧焊器对蓄电池自动实施分阶段法充电的调控方法和调控电路原理。
This article introduces emphatically the practical control methods and circuit principles of battery self charging by stages by the arc welder.
简要介绍应用于蓄电池的液位传感器的工作原理,电路设计。
Working principle and circuit design of liquid level sensor applied in storage battery are introduced briefly.
当喇叭线圈与蓄电池的电路接通时,喇叭线圈产生的磁力振动膜片,产生响亮的声音。
When the horn winding is connected to the Battery, the magnetism produced by the winding pulls the diaphragm down, creating a loud click.
该电路适用于蓄电池负载,无需储能电容,满足了车载充电机在体积重量方面的要求。
The circuit is suitable for being connected to the load of storage batteries, and no storage capacitors are needed, it also meets the requirement of volume and weight for on-board charger.
介绍了一种新型蓄电池充放电装置的系统结构和工作原理,并对其控制方法和控制电路进行了研究。
The system configure and operation principle of the novel storage battery charged and discharged device were introduced, and its control method and circuit were gived.
并介绍了铅酸蓄电池的充放电控制电路。
And the introduction of lead-acid battery charge and discharge control circuit.
介绍以蓄电池和串励直流电动机为动力的电动搬运车辆用斩波器的种类、型号、参数、电路原理和应用情况。
The sort, type, parameter, circuitry and application of the choppers used in power-driven vehicles with storage battery or series DC motors.
首先,负责接通和关闭蓄电池和点火线圈之间的电路。
First, it closes and opens the circuit between the Battery and the ignition coil.
同时给出了整流滤波电路、辅助源电路、过压保护电路、蓄电池的充放电控制电路的电原理图及其工作原理。
Schematic circuits of rectifier and filter, assistant power, over voltage protection, and charge control for storage battery are suggested , their working principle are also discussed.
如果电源、充电电路出现故障,蓄电池能量不足,就失去便携功能。
It will lose the portable function if the charge circuit is wrong and the storage battery has no enough energy.
另外电源采用了12V蓄电池,有效的避免了50hz工频干扰,由于减少了电源转换电路,整个的硬件电路也更加的简化。
Another source with a 12v battery, a 50hz effective frequency to avoid interference due to the reduction of power conversion circuits, the entire hardware circuits are more simplified.
针对锂离子蓄电池在充放电过程中容易出现的过充、过放、过流、过温问题,设计了基于软硬件保护的锂离子蓄电池保护电路。
According to the problems in charging and discharging process of lithium-ion battery, a kind of protection circuit based on software and hardware was designed.
设计出用于阵列MPPT的DC/DC电路和具有蓄电池分组充、放电电路。
A charging (discharging) circuit for storage battery and a DC/DC circuit for MPPT of array are designed.
车灯开关开启时,蓄电池和前灯之间的电路接通。前灯的电路由脚踏选择开关来接通。
When the light switch is pulled out, the circuit from the Battery to the headlights is completed. This circuit is through the foot selector switch.
介绍了密封铅酸蓄电池充电控制器UC3906的工作原理和应用电路。
The operation of integrated circuit UC3906 and its application in sealed lead acid battery charger are described.
比较几种采用12V/24V电系共用电路的办法,基本思路是将两组12V蓄电池串联后接24V用电器,其中一组蓄电池接12V用电器。
The paper analyzes serval designs of such dual circuit. The basic concept is using two groups of 12V batteries in series and then connect with 24V load, of which one group is connected with 12V load.
电动车用铅酸蓄电池内部结构和蓄电池外部电路近期有了不少的改进,以提高其高倍率放电性能。
A review with 9 references was given on improvement in the high-rate discharge performance of lead acid batteries for electric vehicles including internal battery design and its external circuit.
一种智能充电电池模块,包括外壳和装于其内的蓄电池组以及充电电路板。
The utility model relates to an intelligent charged cell module, which comprises a casing, a storage battery arranged in the casing and a charging circuit board.
一种智能充电电池模块,包括外壳和装于其内的蓄电池组以及充电电路板。
The utility model relates to an intelligent charged cell module, which comprises a casing, a storage battery arranged in the casing and a charging circuit board.
应用推荐