有助于实现变电站自动化、通讯以及互操作性的公共数据格式。
Facilitating substation automation and communications as well as interoperability with a common data format.
介绍了CAN总线在变电站自动化系统中的实际应用。
This paper introduces the application of CANbus network in substation automation system SAS .
在综合自动化变电站中,继电保护设备采用的通信协议多种多样,监控系统必须同时处理多种协议。
In the substation automation system, the communication protocols adopted by protection relays are varied and the SCADA has to process many protocols simultaneously. The.
结合光电传感器在变电站自动化系统中的应用现状和前景,提出了二次回路光电数字化的设想。
According to the current situation and prospect of applying OET in substation automation, the opinion of digital electro-optical secondary circuit is given out.
既能与目前广泛应用的变电站综合自动化、调度自动化系统相结合,又可为配电自动化打下基础。
Not only will it be connected with substation and dispatching automation system but also can lay a foundation of distribution feeder automation system.
变电站综合自动化交流采样测量装置可采用虚负荷法和实负荷法检测。
Imaginary load method and real load method can be used to test AC sampling measurement device of integrated substation automation.
最后,就采用综合自动化系统进行无人值班变电站设计和运行的一些技术经济判据进行了讨论。
Finally, the techno-economic criteria of design and operation of non-attended substation using integrated automation system are discussed.
该装置能自动跟踪变电站系统的运行方式,执行相应的备自投方案,保证供电持续可靠。
It follows the operation pattern of substation system automatically and executes corresponding auto-switching scheme to ensure power supply continuous and reliable.
介绍了一种用于变电站自动化系统中的通用测控装置,重点介绍了CPU主模板中PLC模块的实现。
A universal measurement and control equipment for automatic system of the substation is introduced. The realization of the PLC module in the CPU master module is presented emphatically.
随着变电站综合自动化程度的提高,微机保护产品得到大量的应用。
As the advancing in substation automation, microcomputer-based protection products are widely used.
介绍了利用变电站综合自动化系统的间隔层测控装置,实现间隔层五防闭锁的方案。
It also introduces that the implementation of miss operation blocking within or between bays by using measure and control units.
本论文对分层分布式变电站综合自动化系统的技术问题进行了探讨。
This thesis studies the technique problem of the synthesizing automation substation system towards layering distribute type.
本文介绍了“箱式变电站及其自动化装置”的设计方案。
This paper discusses the design of the combined substation and its automation instrument.
随着变电站综合自动化水平的提高,对通讯系统的要求也日益提高。
As the improvement of the substation synthesizing automation, the requirement for communication system increases day by day.
本论文首先对变电站综合自动化技术及嵌入式系统进行了简单概述。
In this paper, firstly, the substation general automation technology and the embedded system are summarized simply.
随着光耦元件在综合自动化变电站二次设备中的广泛应用,其工作特性也需要引起特别关注。
Along with the extensive application of optocoupler element in the secondary equipment of integrated automatic substations, its operating characteristic also needs much attention.
因此有必要在总降压变电站和各厂矿车间变电所推广设计采用微型机监控系统,以提高变电站运行的自动化水平。
Hence, it is necessary to popularize the use of microcomputers monitoring system in power plants and substations to enhance the level of automation of substation movement.
通信网络是变电站自动化系统的关键。
Communication network is a key technique in substation automation system.
该文介绍了其计算过程,对综合自动化变电站蓄电池容量的选择有一定的借鉴意义。
The calculation process is proposed, which proves to be convinent for the capacity choosing of the storage battery in integrated automation substation.
最后,设计了一套基于MMS协议的变电站自动化系统方案。
Finally, a substation automation system is designed, which is based on the MMS protocol.
改造后的变电所供电安全、可靠、经济,煤矿供电网络实行自动化控制,满足变电站无人值守的要求。
Power supply of innovated substation is secure, reliable and economical, which performs automation control and meets the requirement of self-service for substation.
该研究结果对于新一代的变电站自动化系统过程总线通信设计具有参考意义。
The researching result is valuable for process bus communication design of the new substation automation system.
论述了一种全分布式的变电站自动化通信系统。
The thesis describes a substation communication system based on completely distributed structure.
研究快速以太网在变电站自动化系统中的应用,提出了基于100M以太网的变电站通信网的网络结构。
Research the application of 100m Ethernet in substation automation system, and provide a new network configuration of substation automation system base on 100m Ethernet.
介绍适用于超高压变电站自动化系统的单元化逻辑闭锁装置,该装置能方便、灵活地实现变电站间隔级闭锁。
The unit style logic interlock device used in ultrahigh voltage substation automation system is introduced, which can easily implement the bay-level interlock.
文章提出了基于无线自组网的变电站自动化通信方案,分析了变电站自组网的性能和组成。
The AD hoc network based substation communication scheme is presented, and the performance and composition of substation AD hoc network are analyzed.
在国内首次提出了综合自动化变电站智能控制思想。
It is the first time that intelligent control scheme is proposed on integrated substation automation.
主变非电量测控系统是适应电力调度自动化、变电站实现无人值班化和综合自动化的一种新型自动测控系统。
Non-electrical quantity detecting system is a new auto-control system that adapt automation of electric scheduling, self-service and integrating automatism in substation.
本文针对变电站自动化系统目前的运行维护管理现状以及存在问题加以讨论并提出几点建议。
Basing on the current substation automated system's operation maintenance management situation and the existed problems, the paper proposes some Suggestions on it.
变电站综合自动化由继电保护与监控系统组成, I S A 变电站微机成套保护装置,增加了多项新功能。
The integrated automatization of substation is composed of relay protection and monitoring system. ISA complete sets of the computerized protection equipment added various kinds of new functions.
应用推荐