利用湿热试验、盐水浸渍试验及电化学测试方法评价了膜的耐蚀性能。
The anticorrosive property of the conversion film was examined intensively by moisture and heating test, salt solution immersion test and electrochemical method.
用无铬化学方法在铸铝合金表面制得黑色转化膜，利用点滴试验评价了膜的耐蚀性能。
Black conversion film with non-chromate was obtained on a cast aluminum alloy by chemical methods, and the anticorrosion properties of the film were evaluated by means of dropping test.
采用中性盐雾试验测定了镀层的耐蚀性，采用内孔法测定了镀液的覆盖能力，并测定了镀层的硬度。
The corrosion resistance of deposits and covering power of the plating bath were tested respectively by neutral salt spray test and inner-pole method, and the hardness of deposits was also measured.
双层镍作中间镀层的装饰性铬-镍合金试件经16小时铜加速盐雾试验（CASS）后，外观未出现不良现象。 镀层显示了较好的耐蚀性能。
Experienced 16 hours of CASS standard test, the plating layer, based on double post-plating nickel layers, still preserves perfect decorative appearance and shows good property of anti-erosion.
为了提高AZ 31镁合金的耐蚀性，采用微弧阳极氧化技术并通过正交试验法开发出一种环保型的镁合金微弧氧化工艺。
A new environmentally friendly anodizing process for AZ31 magnesium alloy was established based on orthogonal tests so as to increase the corrosion protection of the magnesium alloys.
通过CASS试验检测了镀层的耐蚀性。
The corrosion resistance of deposit was tested with CASS test.
采用正交试验法对锌-铁合金镀层三价铬黑色钝化工艺进行优化，并研究了工艺参数对钝化膜外观和耐蚀性等影响。
The bath compositions of trivalent chrome black passivation for zinc-iron alloy coating were optimized by orthogonal test method.
电化学试验和湿热试验结果表明电解铝硅合金具有良好的耐蚀性。
The results of electrochemical experiments and moisture and hot experiments indicate that the electrolytic Al - Si alloy has excellent corrosion resistance.
通过高温抗氧化、盐雾腐蚀和应力腐蚀试验研究了07X16H6沉淀硬化不锈钢在使用状态（回火态）时的耐蚀性能。
The corrosion resistance of 07X16H6 precipitation hardening stainless steel in tempered state was studied using high temperature oxidation, salt-spray test and stress corrosion test.
用中性盐雾腐蚀试验来评价复合材料的耐蚀性，并用XRD检测了腐蚀产物。
Finally, the corrosion resistance of samples is evaluated by neuter salt-spray tests and corrosion products are confirmed by XRD.
采用间隙盐雾试验考察了修复层的耐蚀性能。
The corrosion resistance of renovated film was measured by batch salt spray test.
试验结果表明：研制得的改性聚四氟乙烯涂层具有优良的不粘性、耐磨性、附着力、耐蚀性、耐高温性等综合性能。
The results show that modified PTFE coating has several outstanding properties such as anti adherence, wear resistance, anti corrupt and excellent performance at high temperature.
试验表明，采用本文推荐的抛光工艺可得到光洁度高、平整性好、又具有较高耐蚀性的光泽表面。
The tests show that the lustrous surface which has high finish, good smoothness and better corrosion resistance can be obtained through the polishing process recommended by this paper.
不同表面质量的连杆盐雾试验对比表明：镀前对汽车减振器连杆进行表面超精加工可显著提高连杆的耐蚀性。
The salt spray test results of piston rods with different surface qualities showed that superfinish process of piston rods before plating can improve corrosion-resistance of piston rods significantly.
试验结果表明，钢表面强化层具有良好的耐磨、耐蚀性能。
The experimental results show that the surface strengthened layers of steel possess better wear and corrosion resistance.
通过冷裂敏感性试验、焊接热影响区最高硬度试验及可调拘束试验，对新型铁路车辆用TCS耐蚀钢的焊接性进行了深入系统分析。
The weldability of TCS corrosion resistant stainless steel for railway wagon was investigated by cold cracking sensitivity test, HAZ maximum hardness test and varestraint test.
综述了影响罐装食品用电镀锡板耐蚀性能的因素及其试验方法。
Factors influencing the corrosion resistance of electrolytic tin plate used for food cans were introduced as well as its test methods.
试验结果说明，镀锌层耐蚀性随镀液流速增大而提高，随电流密度增大而下降。
The results showed that the corrosion resistance of zinc electroplating increased with the increase in flow velocity of electrolyte, and decreased with the increase of current density.
通过进行25%氨水溶液腐蚀试验、10%硝酸溶液腐蚀试验和耐磨试验，测定了这种复合镀层的耐蚀性和耐磨性。
Corrosion resistance and wear resistance of the liquid microcapsule composite copper coating was evaluated by 25% ammonia, 10% HNO_3 corrosion testing, and wear testing.
本文试验研究了钇基稀土用于改善铸造镍基耐蚀合金性能的效果。
The effect on improving the properties of Ni-base alloy was studied in this paper based on variation in adding amount of rare-earth metals.
采用浸泡试验，盐雾试验，原子吸收分光光度法等试验方法，研究BTA用量对封护剂耐蚀性能的影响。
Results show that BTA has great effect on properties of protective coatings, such as properties of acid proof, alkali-proof, waterproof and resistance to salt fog.
用SEM法测定了金属原料粉及镀层的SEM形貌；用盐雾试验测定了镀层的耐蚀性。
The morphology of the metal material powders and mechanically plated coatings were examined by SEM.
并测量陶瓷膜层的厚度，观察膜层微观形貌，通过盐雾试验来评定陶瓷膜层的耐蚀性。
The thickness of ceramic film was measured, the morphology of film was observed, the corrosion resistance of ceramic film was determined through salt-fog test.
涂层的耐蚀性采用中性盐雾试验和5%盐水浸润试验，并测试涂层的阳极极化曲线综合进行比较。
The corrosion resistance of the coating was measured by neutral mist of salt experiment and soaking in 5%nacl solution. Moreover, the curves of positive polarization were give...
通过盐雾试验、扫描电镜、电化学测试等手段，研究了该钝化膜的耐蚀性及耐蚀机理。
Corrosion resistance and mechanism were studied by salt spaying test, SEM and electrochemistry tests etc.
运用正交试验分析了镀液中各主要组分对镀速及耐蚀性等影响，优选化学镀最佳工艺。
The effects of the main compositions in bath on deposition rate and corrosion resistance of the deposits are analyzed, and the optimum process is determined by orthogonal test.
通过实际环境腐蚀试验和电化学测试，研究了粉末渗锌涂层和达克罗涂层在不同水环境中的耐蚀性能。
Corrosion resistance of zinc impregnation and dacromet coating was studied by environmental corrosion test and electrochemical measurement techniques.
利用斑点试验、点蚀试验、电化学测试及扫描电镜等方法 ，研究了熔敷温度、保温时间和稀土添加量等工艺参数对热熔敷法制备的玻璃涂层耐蚀性的影响 ，探讨了添加稀土提高玻璃涂层耐蚀性的机理。
The impact test, the thermal shock test and the scanning electron microscopy were used to investigate the effect of rare earth oxide on the adhesiveness between the glass coating and the base metal.
利用斑点试验、点蚀试验、电化学测试及扫描电镜等方法 ，研究了熔敷温度、保温时间和稀土添加量等工艺参数对热熔敷法制备的玻璃涂层耐蚀性的影响 ，探讨了添加稀土提高玻璃涂层耐蚀性的机理。
The impact test, the thermal shock test and the scanning electron microscopy were used to investigate the effect of rare earth oxide on the adhesiveness between the glass coating and the base metal.
应用推荐