另外还在数字编码电路中加入了纠错设计。
In addition, I also add the correction consideration in the digital encoding circuit.
颜色编码电路指示。
根据不同级精度的编码要求，设计出时钟控制编码电路。
According to the encode demands of different stage resolution, clock-control encode circuit is designed.
为了提高引信的抗干扰性，还设计了激光引信的编码电路。
In order to increase the anti-interference capability of laser fuse, the paper has designed the laser fuse code circuit.
RS编码器IP核设计的难点是提高编码电路的编码运算速度。
The difficulty of RS encoder IP core design is how to improve operation rate of encoding circuit.
发射器一般由指令键、指令编码电路、调制电路、驱动电路、发射电路等几部分组成。
General by the command transmitter key, instruction encoding circuit, modulation circuit, driver circuit, firing circuit, such as a few parts.
内有编码电路(可不编址)，编码时可直接接入报警总线，不编码时需配控制模块才能使用。
Coding circuit inside (may not code), can be connected in alarm bus directly when coded and matched with module when not coded.
接着，针对生成矩阵的准循环特性，提出了一种新的基于反馈移位寄存器的编码电路，并用FPGA进行了实现。
Next, according to the characteristics of quasi-cyclic matrix, a new encoding circuit using feedback shift registers is proposed and implemented by FPGA.
根据组合逻辑电路的设计方法，突出用卡诺图化简逻辑表达式在并联比较型A/D转换器编码电路设计中的应用。
To stress the application of Karaugh map on designing of coding circuits in parallel-comparator ADC in terms of the design of combinational logic circuits.
介绍一种针对正、余弦旋转变压器数字转换器（RDC）模块，用复杂可编程逻辑器件（CPLD）技术实现伺服轴角编码电路设计的方案。
This paper introduces the technology scheme to design radar servo shaft encoder circuit by using CPLD on the rotary transformer and RDC module.
我们的遥控器是通过高稳定性的电路和高抗干扰的优化编码来实现对各种电器的控制。
Our remote controllers realize to control all kinds of electrics through the high steady circuits and the high antijamming good codes.
在某相位编码毫米波雷达系统中，要求很高的目标速度测量精度，因而目标多普勒频率测量电路的设计比较重要。
The design of target doppler frequency measurement circuit is very important in phase coded MMW radar system because of the high measurement precision requirement of target speed.
包装的晶体管允许使用编码的信息程序进行操作的称为决策逻辑电路。
This package of transistors allows for logical decision circuits to operate using the encoded messages known as a program.
这些决策逻辑电路在操作使用该编码的消息时将会产生一个可预测的输出结果。
These logical decision circuits, when operating with the encoded messages, will have a predictable outcome.
在某相位编码毫米波雷达系统中，由于对目标速度测量精度的要求很高，因此目标多普勒频率测量电路的设计也具有比较重要的地位。
The design of target Doppler frequency measurement circuit is very important in phase-coded MMW radar system because of the high measurement precision requirement of target speed.
采用高分辨率的增量式光电编码器和相应的硬件接口电路，实现了变磁阻电机转子在定子两个齿之间位移的检测。
Using an optical incremental encoder and hardware interface, the position of the motor rotor between the two teeth of the motor stator is measured.
本文叙述了一种适用于低速数字信道的地址编码时分交换系统的新的电路方案。
A new circuit scheme for the address coded TDM switching system of low speed digital channels is discussed in this paper.
与以往十值电路的设计方法相比较，此设计方案具有编码效率高、供电电压低等特点。
Compared with the conventional design of ten-valued circuits, the design has the characteristics of high coding efficiency, low voltage supply, etc.
USB的电气特性反映了端口驱动电路、传输电平、编码结构、位同步处理及供电方式。
The USB electrical specifications describe the port driver circuit, electrical level of data transmission, code structure, bit synchronization and power distribution.
介绍用LED发光二极管组成数码显示的一种编码方法，并介绍了译码驱动电路及与单片机的接口。
This paper introduces a coding method of using LEDs to constitute digital display of Numbers. The related driving circuits and their interfaces with Micro-controllers are also introduced.
论述了一种小型嵌入式LED点阵显示系统的驱动电路和汉字编码方法；
The driving circuit and a method of Chinese character coding in an embedded LED array display system are discussed in this paper.
检测仪器除了恒流源外，主要还有温度补偿、脉冲形成、脉宽鉴别以及编码、译码等电路。
In addition to the current source, the detecting instrument mainly contains the circuits for temperature compensation, pulse formation, pulse duration discrimination and encode, decode.
对RS编码器采用移位寄存器形式，来实现除法电路求得监督位。
Check bit of divide operation circuits of rs codes is realized by using shift registers.
本文介绍了一种基于编码开关和单片机系统的定时电路设计方法，并对硬件电路设计和软件设计作了详细介绍。
This article introduces a timing circuit design, which is based on coding switches and singlechip system. Hardware and software design of the circuit are also discussed in detail.
详细分析了PPM编码的帧结构，说明了脉冲编号的解码方案以及电路的实现原理，最终给出电路的仿真测试结果。
The paper analyzes frame architecture of PPM code in detail, illustrates pulse-number method and implementation principle of the circuit, and supplies test result of the circuit.
介绍旋变及同步机轴角编码器的典型电路设计与调试。
The paper introduces the design and adjustment of resolver and synchronizer axial angle encoder.
介绍了光电编码器脉冲四倍频电路及与计算机的脉冲接口。
The photoelectric encoder quadruple circuit and its pulse interface with computer are presented.
介绍了光电编码器脉冲四倍频电路及与计算机的脉冲接口。
The photoelectric encoder quadruple circuit and its pulse interface with computer are presented.
应用推荐