本文将机车继电器控制电路等效为数字组合逻辑电路,建立了它的固定故障等效模型。
The electric locomotive bang-bang circuit is converted into an equivalent digitalcombinational logic circuit for setting up its stuck-at fault model.
抖动,说明极有可能是消磁电阻损坏,如果没有响声则可能继电器及其控制电路有问题。
Jitter, that is very likely damage degaussed resistance, in the absence of sound may be the relay and control circuit problem.
使用继电器、接触器、按钮、空气开关、行程开关等低压电器构成的控制电路称为继电接触控制电路。
Use relays, contactor, button, air switch and travel switch etc low-voltage constitute control circuit called relay contact control circuit.
控制电路通过水位检测信号,利用继电器和接触器控制排水机构。
The control circuit controls the water drainage mechanism using a relay and a contactor by the water level detection signal.
对采用继电器控制系统进行控制的某实验室船舶燃油辅助锅炉,采用计数法进行可靠性评估,得出控制电路的平均无故障时间。
The reliability lab ship fuel oil donkey boiler controlled by relay control system is evaluated using counting method, and mean time to failure (MTTF) of the control circuit is educed.
设计和实现了一种采用工控机与温度模块、PWM输出卡、固态继电器及相关控制电路搭建的计算机电阻炉温度控制系统。
Temperature computer control system of a resistance furnace is designed with industry person computer (IPC), temperature input module, PWM output card, solid state relay(SSR) and interrelated circuit.
电流互感器通常与电流表、控制电路、保护继电器配套使用。
Current transformers are commonly used in metering and protective relays in the electrical power industry.
本文以常见的继电器顺序控制电路为例,重点分析了在设计有触点的电器控制线路及实际应用中,常常忽视的临界竞争问题。
Based on usual circuit, this paper analyzed the critical competition in the design of electric appliance control of circuit with contact.
本文介绍了温度继电器自动测试系统的设计,此系统由温控箱、开关量检测电路、温度控制电路、接口电路及工控机等硬件组成。
This system was composed of a temperature controlled tank , switch measurement circuit , temperature control circuit , interface circuit , an industrial manipulative computer, and so on.
在分析和设计继电器-接触器控制电路时,往往忽视临界竞争现象,结果造成电气控制达不到预期目的,甚至造成事故。
In the practice of analyzing and designing of relay-contactor circuits, the critical-competition phenomenon is usually ignored, causing failures in reaching the intended purpose or even damages.
在典型的R LC振荡放电电路中,引入5 5 5时基电路和水银继电器作为控制电路,设计了阻尼正弦瞬变信号发生器。
In typical R-L-C resonance circuit, the 555-time-circuit and mercury relay are used as control unit. A damped sinusoid source is designed. It has been proved that the source satisfies our request.
在典型的R LC振荡放电电路中,引入5 5 5时基电路和水银继电器作为控制电路,设计了阻尼正弦瞬变信号发生器。
In typical R-L-C resonance circuit, the 555-time-circuit and mercury relay are used as control unit. A damped sinusoid source is designed. It has been proved that the source satisfies our request.
应用推荐