虚拟化还能隐藏物理约束，从而更轻松地最小化物理资源更改的影响。
It hides physical constraints, which makes it easier to minimize the impact of changes to physical resources.
该算法直接利用前一周期的时延信息来更新路由表，以作为当前寻找路径的依据，在满足带宽和时延波动约束条件下，使数据传送过程时延最小化。
It can refresh the router table by the previous delay information to find a suitable path with the constraints of the bandwidth and the delay-jitter.
通过满足暂态电压安全约束的无功发电调节与切负荷总代价最小化问题，来表示暂态电压安全风险。
Transient voltage risk can be calculated by optimizing the total cost for generator adjustment and load shielding under restrictions of transient security.
我怎样才能解决最小化约束Z 3 ？
优化模块是以最小化周期时间或以基于服从工件质量约束校正模型后的周期时间为目标来确定磨削和修整参数。
Optimization is used to identify grinding and dressing parameters to minimize or target cycle time based on the calibrated models subject to workpiece quality constraints.
作者根据约束性代价函数原理提出了能够使得截断误差最小化的中心差分优化算子。
This paper presents an optimization of centered finite-difference operator based on the principle of constrained cost function, which can reduce the truncation error to minimum.
由于调和映射具有保持映射能量最小的性质，该方法可以最小化约束纹理映射可能导致的扭曲形变。
The energy minimization characteristic of the harmonic map preserves the low distortion that may yield in the process of texture mapping.
研究三个并行处理器环境中，具有递减链约束的多处理器任务的调度问题，调度目标是最小化总处理时间，假设单项任务需单位处理时间。
This paper focuses on scheduling unit length multiprocessor tasks with de-creasing chain precedence constrains on three identical processors so as to minimize makespan.
所描述的问题为在平行机台上调度具有单一模具约束的成组工作，以实现最小化总拖期量为目标。
The problem of scheduling jobs with chain precedence constraints on identical parallel machines is discussed in this article.
所描述的问题为在平行机台上调度具有单一模具约束的成组工作，以实现最小化总拖期量为目标。
The problem of scheduling jobs with chain precedence constraints on identical parallel machines is discussed in this article.
应用推荐