另外，有关稳态密度轮廓变陡的解析计算，也正确地反映了有关实验及计算机模拟的结果。
In addition, the analytic calculations for steady state, steepened density profile are also well consistent with the results obtained by using microwave plasma experiments and numerical simulation.
证明新模型的基本图，即车流渐近稳态的平均速度与道路上的车辆密度之间的函数关系与FI模型的完全相同。
It is proved that the fundamental diagram of the average traffic flow speed as the function of the car density for the new model is exactly the same as for fi model.
对高能量密度激光匙孔焊接过程的二维准稳态传热进行了计算方法的研究。
A numerical method is presented for the two dimensional quasi steady state heat transfer on high power density laser welding processes according to the keyhole model.
分析了流体的非稳态流动及颗粒的密度分布对模拟结果的影响。
The influence of non-uniform flow and particle density distribution on the simulation results was discussed.
送气系统提供的稳态和脉冲送气方式成功地运用于各种物理实验和密度控制。
Steady and pulsed gas injection modes are provided by this system and work well for density control.
在此基础上对大口径铜蒸气激光器的径向动力学参量进行了计算，包括激励电场和亚稳态铜粒子密度等动力学参量的径向分布。
On the basis of this model the radius kinetic parameters are calculated, including the stimulating electric field and the metastable state copper density.
实验结果表明，各动态成型条件下的型坯密度明显大于稳态成型条件下的密度。
Results show that the density of green parts under dynamic molding conditions is obviously higher than under steady molding conditions.
根据实验所得沸腾曲线，对纳米颗粒悬浮液进行稳态数值模拟，计算了不同过热度下活化核心的密度。
A steady numerical simulation of the effect of nano-particles on nucleation sites in nucleate pool boiling heat transfer was conducted based on the experimental boiling curves.
诱导爆轰距离与装填密度之间呈“U”型曲线关系，稳态爆速与装填密度之间近似呈线性增长关系。
The curve showing the relationship between predetonation distance and charge density is U-shaped and the detonation velocity rises linearly as change density increases.
当等离子体密度较高、注入电压较低时，稳态鞘层厚度对于靶体半径的变化极不敏感。
For a high plasma density and low applied voltage, the steady-state sheath thickness is more or less insensitive to variations in the spherical radius, but it is very sensitive under other conditions.
通过数据拟合得到了流注稳态传播电场和相对空气密度以及湿度之间的经验公式。
An empirical equation was obtained for explaining the relationship between streamer stability propagation field and relative air density, humidity.
对高温平板滞止区内R- 113的喷流冲击沸腾的临界热流密度(CHF)进行了系统的稳态实验研究。
A steady heat transfer experiment was carried out for predicting the critical heat flux (CHF) of convective boiling for a round R-113 liquid jet impingement on the stagnation zone of a hot surface.
建立了室外空气温度发生周期性变化情况下的复合墙体一维非稳态传热物理模型及数学模型，推导出复合墙体温度分布及热流密度分布表达式。
We aim at the establishment of one-dimensional physical and math model in the multiplayer walls. Heat flux and temperature distribution expression has been reduced and analyzed.
本文对高温平板滞止区内三种过冷液体的圆形喷流冲击沸腾的临界热流密度进行了系统的稳态实验研究。
An experimental investigation was carried out to predict the Critical Heat Flux (CHF) of convective boiling of 2 subcooled liquids for a round jet impingement on the stagnation zone of a hot surface.
本文对高温平板滞止区内三种过冷液体的圆形喷流冲击沸腾的临界热流密度进行了系统的稳态实验研究。
The quantificational effects of the nanoparticles concentration and the flow conditions on the jet boiling heat transfer and the critical heat flux (CHF) were systemically investigated.
本文对高温平板滞止区内三种过冷液体的圆形喷流冲击沸腾的临界热流密度进行了系统的稳态实验研究。
A steady heat transfer experiment was carried out for predicting the critical heat flux (CHF) of convective boiling for a round R-113 liquid jet impingement on the stagnation zone of a hot surface.
本文对高温平板滞止区内三种过冷液体的圆形喷流冲击沸腾的临界热流密度进行了系统的稳态实验研究。
A steady heat transfer experiment was carried out for predicting the critical heat flux (CHF) of convective boiling for a round R-113 liquid jet impingement on the stagnation zone of a hot surface.
应用推荐