绿色和平组织以及其他组织批评该法案没有采取积极的行动，制定的碳排放量上限不足以预防将在本世纪末发生的一些气候变化的极端影响。
The bill has been criticised by Greenpeace and others for failing to move aggressively enough to cap emissions to prevent some of the extreme effects of climate change occurring late in the century.
研究发现，受BP漏油事故影响且经FDA检测的虾类产品中有大约50%产品的有害碳物质含量超出了该组织视为对怀孕妇女安全构成危险的控制临界值。
The study found about 50 percent of the shrimp the FDA tested after the BP spill had harmful carbon levels exceeding the level of risk deemed by the group to be safe for pregnant women.
本文研究了在普通砂型条件下，低频振动使铁碳合金凝固组织的影响。
Effect of low freqency vibration on solidified behavior of ferro-carbon alloy was inspected in sand-mold Casting.
结果表明，碳显著的影响低碳高合金钢的组织和性能，而以锰代镍低碳高合金钢可以获得预期的组织与性能。
The results indicate that carbon influences structure and properties of LCHA significantly, and substitution for nickel with manganese may result in expected structure and properties.
本文就对以锰代镍制取低成本低碳高合金钢，以及锰元素对其组织与性能的影响作了一些探讨。
This article use Mn to replace Ni to make low-cost LCHA, and the effect of Mn on structure and properties of LCHA was discussed following.
通过扫描电镜、能谱分析仪和电子探针研究了稀土复合变质剂对离心铸造的高碳高速钢轧辊组织和力学性能的影响。
The effects of RE compound modificator on the mechanical properties and microstructure of high carbon high speed steel used for roller ring were investigated by SEM, EDS and EPMA.
通过对粗晶合金性能的检测和金相组织的观察，研究了碳含量对粗晶硬质合金性能的影响。
The effect of carbide content on the properties of coarse grained cemented carbide is studied by means of measuring properties and observing polished cross section.
本文研究了不同含量的硅元素和热处理工艺对中碳低合金钢的组织与性能的影响。
The effect of different content of silicon to the medium carbon low-alloy steel microstructure and mechanical properties was studied under different heat treatment technology.
研究了不同含量的硅元素和热处理工艺对中碳低合金钢的组织与性能的影响。
The influence of different silicon contents on the medium carbon low-alloy steel microstructure and mechanical properties was studied under different heat treatment processes.
利用光镜、显微硬度计研究了铬含量对低碳合金钢组织、硬度、冲击韧度及耐均匀腐蚀性的影响。
The influences of chromium content on the hardness, impact toughness and corrosion resistance of low carbon alloy steel were studied using om and hardness tester.
通过力学性能和耐磨性能测试、金相组织观察和ESEM形貌分析，研究了氮含量对低碳高铬铸铁性能的影响。
The effects of nitrogen on the properties of low carbon high chromium cast iron were studied by mechanical property and wear resistance test, and metallograph analysis using OM and ESEM.
分析了钢中碳、锰、铌、钒和钛等元素对管线钢组织和性能的影响，以及硫、磷、氧等杂质元素对钢的性能影响。
The effect of carbon, manganese, vanadium and titanium on the microstructure and properties, as well as the effect of sulfur, phosphorus and oxygen on properties were investigated.
通过试验研究了不同碳、铬含量对不锈轴承钢的显微组织、碳化物、硬度和接触疲劳寿命的影响。
This research studies the effect of different carbon and chrome content on the microstructure, carbides, hardness and contact fatigue life of the stainless bearing steel.
本文研究了钒对低碳铸钢组织和性能的影响。
The effect of vanadium on the structure and properties of low- carbon cast steel was studied in this paper.
研究了碳量对含砷锡铅钛球墨铸铁组织与力学性能的影响。
The effects of carbon content on microstructure and mechanical properties of spheroidal graphite cast iron containing arsenic, tin, lead and titanium was investigated.
研究了中碳含硅贝氏体钢不同组织结构对高应力冲击磨损行为的影响。
The high stress impact wear behaviors of bainite steel containing silicon with different microstructure were studied.
研究了淬火、回火工艺对低碳马氏体型高强度高韧性非调质钢的组织和性能的影响。
The effect of hardening and tempering process on the organization and performance of high-strength and high-toughness non-hardened-and tempered steel of low carbon martensite is researched.
叙述了正火工艺对中碳非调质钢组织和力学性能的影响。
In this paper, the effect of normalization process on microstructure and mechanical properties of medium carbon non-quenched and tempered steels is introduced.
研究了硅和等温淬火工艺对高碳低合金马氏体-贝氏体钢金相组织与机械性能的影响。
The effect of silicon and isothermal quenching process on the microstructure and mechanical property of the high-carbon low alloy martensite-Bainite steel was studied.
研究了时效温度和保温时间对时效硬化型超低碳含铜钢的显微组织和硬度的影响。
The effects of the aging temperature and holding time on the microstructure and hardness of the ultra-low-carbon steel bearing copper were investigated.
对于硬质合金而言，碳含量对合金的组织性能有重要影响。
Carbon content has an important influence on structure and properties of cemented carbide.
结果表明：碳含量、浇注温度及表面活性元素对试样的变形及组织均有较大影响。
The results showed that the carbon content, pouring temperature and surface active elements have more effect on deformation and structure of the samples.
该文研究碳含量对纳米硬质合金组织和性能的影响。
This paper studies the effect of the C content on microstructure and properties of nanosize cemented carbide.
在热模拟试验机上研究了控轧控冷工艺对微合金化低碳贝氏体型非调质钢组织性能的影响，并探讨了贝氏体转变机制问题。
The effect of TMCP parameters on microstructure and property was studied, and a controversial question about bainite transformation mechanism also was discussed.
研究了含碳量和轧制工艺对低碳微合金V - N钢显微组织和性能的影响。
The effects of carbon content and rolling process parameters on microstructures and properties of the V-N microalloyed steels were studied.
利用光学显微镜和扫描电镜以及能谱分析，研究了稀土元素钇对低碳微合金钢组织、性能的影响规律。
The effects of rare earth Y on the microstructure and properties of low carbon micro-alloyed steel were studied by optical microscope, scanning electron microscopy and spectroscopy.
本文研究了碳含量对508 - 3钢大锻件组织与性能的影响。
This paper experimentally investigated the effect of Carbon content on the microstructure and property of SA508Gr3 steel heavy forging.
通过TMCP工艺实验，研究了终轧温度和卷取温度对低碳锰钢力学性能和微观组织的影响规律。
The effects of processing parameters of TMCP, such as finish rolling temperature and coiling temperature on microstructure and mechanical properties of low CMn steel were studied by TMCP tests.
研究了淬火和回火温度对中碳低合金耐磨铸钢组织和力学性能的影响。
The influences of quenching and tempering temperature on microstructure and mechanical properties of medium-carbon-low-alloy wear-resistant cast steel were investigated.
通过固定其它元素的含量，调整碳含量的方式，研究了碳含量对马氏体钢显微组织和力学性能的影响。
The influence of carbon on microstructure and mechanical property of low-carbon martensite steel was studied by fixing the content of other elements and regulating the content of carbon.
应用推荐