加入膨润土对硫化速度的影响不大。
Filling bentonite composition had little effect on the velocity of vulcanization.
通过盘式硫化仪测定了IIR和BIIR的硫化速度。
The curing rates of IIR and BIIR were tested by sulfuration apparatus.
促进剂M的活化能比DM低得多，说明其硫化速度对温度的依赖性小于DM。
The accelerator M gave larger plastication to NR than DM at lower temperature, but DM would give larger plastication than M as the temperature increased.
与丁基橡胶相比，BIIR焦烧时间和正硫化时间明显缩短，硫化速度大大提高。
Besides the scorch time and optimum cure time of BIIR were shortened considerably while its curing rate increased obviously.
结果表明，白炭黑能加速CR/TPI并用胶的焦烧性能，同时降低了胶料的硫化速度。
The results show that with the increase of the amount of silica, the scorching time and optimum cure time of CR/TPI compounds are shortened.
结果表明，TBSI用作NBR硫化过程促进剂时，焦烧时间长，硫化胶强度高，但硫化速度较慢。
The results showed that as the accelerant of NBR in vulcanization, TBSI had much more scorching resistant time and higher vulcanization degree, but lower vulcanization rate.
胶料的硫化速度较快，强度较高，耐臭氧性能和耐介质性能较好：老化性能优良，耐油性能略有下降。
The aging speed, the strength of the hose, the chemical media resistance, and anti-ozone properties of the blend obtained improved significantly, but the oil resistance decreased slightly.
结果表明，随着白燕华CC用量的增大，胶料表现出比填充非极性SBR更高的拉伸强度和撕裂强度，而硫化速度却明显减慢。
The results showed that when compared with SBR, the NBR filled with calmos CC had higher tensile strength and tear strength, but lower curing speed.
试验配方中并用EPDM和弹性填充剂，胶料门尼粘度、硫化速度和混炼性能得到提高，过滤和挤出工艺性能得到改善。采用试验配方生产的自行车内胎性能良好，达到国家标准要求；
The test results showed that the Mooney viscosity, mixing behavior and curing rate increased, and the filtering and extrudability improved by blending EPDM and an elastic filler in the test compound.
虽然基于硫化物的“地理工程学”必定会减缓臭氧层的恢复速度，但是也不至于使其再度恶化。
Sulphate-based geoengineering would certainly slow down its recovery, but would not send it into reverse.
研究结果表明，选择仿人智能控制作为硫化成型过程的控制策略时，可实现速度快、精度高的控制，且具有极强的鲁棒性。
The results showed that it was rapid in response velocity, high in precision, strong in robust-ness while selecting human simulation control as control strategy for vulcanization shaping process.
分析在硫化橡胶拉伸应力应变性能试验中试样的形状、宽度、厚度、试验温度以及拉伸速度对试验结果的影响。
This paper analyzed the influence of the sample's shape, breadth, thickness, temperature and extension speed on the result of the test when vulcanized rubber's extension performance was tested.
根据室内矿样试验表明，铁离子浓度愈大，硫化矿氧化速度越快，发生火灾的可能性就越大。
The indoor test result of ore samples has shown that the higher the content of iron ions, the faster the speed of sulfide mineral oxidate and the greater the possibility of fire hazard exists.
探讨了硫化钠的作用机理，硫化钠可提高铜矿物浮游速度，在预期回收率前提下提高铜精矿品位。
Proper sodium sulphide can increase the floating speed of Cu mineral in slag and Cu grade of concentrate on the premise that the desired recovery is gained.
介绍了一种新型的高效节能平板硫化机，它既可以提高可动平台上升、下降速度，又可以减少功率消耗、节省能源。
The new and high efficiency platen press with saving energy could not only increase the move speed of the bolster, but also reduce the consumption of power and energy.
在使用上具有操作方便、净化度高、床层阻力小、适应性强、脱硫化氢及部分有机硫的速度快、容量高等特点。
Have in the use of easy to operate, clean and high bed resistance, adaptability, and some organic sulfur from hydrogen sulfide faster, higher-capacity characteristics.
在硫酸盐法制浆时，药液的硫化度无论对于蒸煮速度还是对成浆的得率和质量等各方面有很大影响。
When making pulp with sulfate process, the sulphidity of liquor has great impact on both cooking time and pulp yield &quality.
介绍了pcx43r300型液压硫化机在高速度级轿车子午线轮胎生产应用过程中的特点及硫化工艺参数的确定对轮胎质量的影响。
The features of PC X43R300 type hydraulic curing press for high speed passenger car radial tire and the influence of curing process parameters on tire quality are described.
研究表明，与传统炭黑增强样品相比，碳纳米管在橡胶中的混入速度快，温升幅度小，混炼胶的硫化返原现象减轻。
The results showed that the nanotubes mixed rapidly into the rubber with little temperature increase during the mixing. The curing reversion of rubber composites was also reduced.
研究表明，与传统炭黑增强样品相比，碳纳米管在橡胶中的混入速度快，温升幅度小，混炼胶的硫化返原现象减轻。
The results showed that the nanotubes mixed rapidly into the rubber with little temperature increase during the mixing. The curing reversion of rubber composites was also reduced.
应用推荐