导出晶相与非晶相界面法拉第角计算公式。
Farady Angle formulas of crystalline phase and noncrystalline phase interfaces are derived.
负极集电体处于三相界面上，直接影响电池的性能。
The current collector lies in the three-phase interface, having direct effect on batteries characteristic.
靶溶质分子扩散到水-有机相界面与载体形成复合物；
The target solute molecules diffuse to the aqueous organic interface, forms a complex with the carrier;
还发现，内相中氢氧化钠的浓度对两相界面张力也有影响。
The relation between the interface tension and the encapsulated phase NaOH concentration is discovered too.
动态硫化增加了共混物中NR与HDPE相界面间的结合力。
The combination Power of phase surface between NR and HDPE in blends can be enhanced by dynamic Vulcanization.
采用三相界面聚合法，对聚合单体进行筛选，对聚合条件进行优化。
The use of three-phase interfacial polymerization, polymerization of monomer on the screen to optimize the polymerization conditions.
萃取速率与相界面积、两相中的溶质浓度差和滴内流体力学状态有关。
Extraction velocity had a relation with interface areas, concentration gradient of solute and the status of fluid kinet...
马氏体相变中相界面能量较低，导致其内耗峰值低于扩散型相变的峰值。
The lower interphase energy in the martensitic transformation results in a lower value of internal friction peak as compared with that in diffusional transformation.
结果表明脱硫反应是在气固相界面之间进行，气体COS是中间载硫体。
The results showed that the desulfurization reaction took place at gas-solid interfaces, and that gaseous COS was found to be an intermediate product acting as sulfur-carrier.
聚合物高分子溶液具有网链结构，运动中显示出的黏弹效应直接关系相界面能量转换。
The polymer solution has the net chain structure, it shows the effect of viscoelasticity in the movement which directly relates to the interface energy conversion.
气液相际间传质过程中，由溶质浓度梯度产生的表面张力梯度可以导致相界面湍动现象。
In the gas liquid mass transfer processes, solute concentration gradients may produce surface tension gradients, resulting in interfacial turbulence at the interface.
采用三相界面聚合法能够制备出表面相对光滑的高脱盐、高水通量的新型复合型反渗透膜。
The use of three-phase interfacial polymerization can be prepared by a relatively smooth surface of high-desalination, high water flux of the new composite reverse osmosis membrane.
这是因为该复合材料中形成了共析组织，且相界面增多，塑性变形抗力增大，硬质点数量增多。
The main reasons are the forming of eutectoid structure, the increase of the phase interfaces, the enhance of the plastic deformation resistance, as well as the increase of the hard particles.
综述了多相聚合物体系相界面的形成、界面层状态的表征、界面层性质及其对体系性能的影响。
The formation and characterization of the interphase in multi-phase polymers were summarized in this paper.
结果显示，随着界面运动速率的提高，马氏体和母相之间的相界面能量增加，相界面的宽度下降。
The results show that the interface energy increases and the interface width decreases between martensite and parent with the increase of velocity of the interface motion.
尤其是三甲基氯硅烷改性后的TS 1沸石，在相界面催化反应中，具有比改性前高得多的活性。
Especially by the TS-1 modified with trimethylchlorosilane, much higher catalytic activity was achieved than by parent TS-1 zeolite in the phase-boundary catalysis.
介绍了一种测量金属固-固相界面能的方法——零蠕变法，并着重阐述双向零蠕变法的原理和设备。
Therefore, a new method named Zero Creep Measurements has been introduced to measure the interfacial energies. The principle and devices for Biaxial Zero Creep Measurements are emphatically described.
采用水平集方法捕捉气，液两相界面，结合投影方法，对所建立的两相流动模型进行了三维数值求解。
The Level Set method is adopted to capture the gas-liquid interface and the projection method is used to solve the three dimensional two-phase flow equations.
然后分析了碳钢在过冷等温时，相界面共格的固态相变过程中，相界面附近碳的扩散系数变化的情况；
The variation of the carbon diffusion coefficient at the vicinity of the phase boundary during the process of eutectic solid state phase transformation of the phase boundary was analyzed.
分析了狭缝口型中的一维复合共挤出流动，叠代计算得到两相界面位置以及速度、剪切速率和切应力的分布。
The interface between two molten polymers, as well as the distribution of flow rate, shear rate and shear stress were obtained by using an iterative calculating scheme .
由于高温下合金中相界面的软化及粘性滑动，四种合金在高温下均存在一个温度内耗峰，只是出现的温度不同。
There exists a damping peak in all of the alloys with different temperature because of the viscous sliding or slipping of the grain boundaries and interfaces at high temperature.
测定了离子在不相混溶的、新鲜的、可重复的液—液相界面间传导的行为，并试图据此探讨离子传导机理模型。
The ion transfer across the fresh, renewable and immiscible liquid-liquid interface was measured. The ion transfer mechanism model was suggested in this paper also.
PL偶联剂改善了HA与HDPE两相界面间的结合性能，提高了HA在高密度聚乙烯基体中的分散度和填充量。
Pl coupling agent could enhance the interface combination between ha and HDPE, and improve the dispersibility and fill content of ha in the HDPE basis.
异氰酸酯与不同含水率纤维素反应机理很复杂，存在多种机理同时存在；当与绝干纤维素反应时主要是相界面机理。
The phase interface mechanism controls the reaction of isocyanate with dry cellulose, when water exists, the mechanism is very complicated, and some mechanisms coexist.
结果表明，变温马氏体相变及I/C相变过程中内耗均为粘弹性型内耗，是相界面在克服粘滞性阻力而运动时引起的。
The IF behaviour in the processes of MP and I/C phase transformations are nearly the same and is associated with the motion of phase interface under the action of phase transformation driving force.
研究发现在一定油相折算速度条件下，随水相折算速度的增大，局部相界面浓度有先递减，而后逐渐增大的变化趋势。
This can be explained that for lower water flow rates, the decrease of the interfacial area concentration was caused by the sharp decrease of the oil phase fraction with increasing water flow rates.
获得了以该介质为蓄冷媒介的蓄冷平板在第一类边界条件下凝固时的相界面移动规律、板内温度分布及预测蓄冷时间等参数。
The motion of phase interface, the temperature distribution and the thermal storage time of the cool storage slab under the first boundary condition were obtained.
钎料的钎焊性能很大程度取决于钎料对基板上的润湿性能，而润湿性能与液态钎料在基板上的液、固、气三相界面的界面张力有关。
The solderability of electronic solders depends to a great extent on the wettability, which relates to solid, liquid and gas interfacial tensions of the melted solders on substrates.
钎料的钎焊性能很大程度上取决于钎料对基板的润湿性能，而润湿性能与液态钎料在基板上的液、固、气三相界面的界面张力有关。
The solderability depends on a great extent on the wettability, which relates to solid, liquid and gas interfacial tensions of the melted solders on substrates.
钎料的钎焊性能很大程度上取决于钎料对基板的润湿性能，而润湿性能与液态钎料在基板上的液、固、气三相界面的界面张力有关。
The solderability depends on a great extent on the wettability, which relates to solid, liquid and gas interfacial tensions of the melted solders on substrates.
应用推荐